2021 Audi Q8 Problems

Belt Starter Generator failure rendered car undrivable -- power steering failed while in motion. Issue is subject to Class Action Settlement in USDistrict Court, Case # 3:23-cv-02291-RK-RLS. But this should have been a recall because of danger of Injury or Death. A recall would provide notice that the notice of settlement failed to provide. This failure happened to me on March 29, 2026. Dealer is not able to do the repair work in a timely manner.

Purchased my car used from Volkswagen of west islip. After a few months I was doing regular maintenance when I noticed that the brake sensor was missing and the harness was tampered with. The brake wear sensor was removed from the front driver side and a small price of wire/ conductive material was inserted into the harness to trick the cars system into on seeing the sensor in a safe and working manner. This would prevent the cars system from alerting me when the brakes need to be replaced which could have resulted in resulted in a serious accident due to brake failure. I feel like this was either deliberately done by the dealer before selling the car to save a few dollars or was overlooked during what should have been a basic safety inspection before listing the vehicle for sale. After reaching out to the dealer- they refused to fix the issue.

On multiple occasions, the car states there is a steering malfunction and to stop the car immediately. Power steering fails. The last time I left the car to the dealership to have a recall serviced - it did this. I let the Audi (Fred Lavery Birmingham Michigan) know. They did not respond / did nothing. It has happens at least 10x at varying speeds (some high, med and low speed) since the day I left the dealership

On April 2, 2025, while driving on Interstate 25, my 2021 Audi Q8 Premium Plus experienced a catastrophic engine and electrical failure. This included the generator system failing, which resulted in a complete loss of power, disabling all active safety systems (including electronic stability control, braking assist, and lane monitoring), as well as basic driving capabilities such as acceleration and steering responsiveness. The incident occurred without prior warning or diagnostic alerts, and the vehicle became immobile on the highway. The situation posed a serious safety hazard to both myself and surrounding drivers. The vehicle had an unresolved generator recall, which Audi later confirmed and completed after the incident. This event raises significant concerns regarding system reliability and pre-failure alert mechanisms in the Q8 platform.

I was driving my car would not accelerate on the highway and it almost caused me to get into an accident with my niece in the car. When I took the car to Audi this is what I was told my the service adviser. “Good afternoon. The technician has been looking into the vehicle and has found the cause of the issue. He has found the coolant water pump has failed internally causing coolant to leak internally into the vacuum system. This is causing the vacuum to be blocked for the turbo and thus causing the sluggish feeling when accelerating. In order to fix, the water pump and all compromised vacuum system components need to be replaced. It is a rather extensive job unfortunately.” My car only has a little over 45 thousand miles. Audi should be responsible to fix this problem because they sold this car knowing the water was faulty in these models. I recall should have been put out. I was quoted $6,000 to fix this problem.

The engine (internal mechanical failure) malfunctioned. The vehicle developed a persistent ticking/knocking noise from the engine bay, and the authorized Audi dealer diagnosed the issue as requiring a full engine replacement. The vehicle is currently available for inspection upon request. A catastrophic engine failure presents a risk of sudden loss of power, stalling, or engine seizure, which could occur while driving at speed or in traffic. This creates a potential risk of loss of vehicle control, inability to accelerate, or being stranded in unsafe conditions, endangering both the driver and other motorists. The problem was confirmed by an authorized Audi dealership, which diagnosed the vehicle and stated that a complete engine replacement is required. The estimated repair cost provided by the dealer is approximately $26,000 (so far in parts only). The vehicle has been inspected and diagnosed by an authorized Audi dealership. At this time, it has not been inspected by police or insurance representatives. Audi corporate has been contacted for review. The primary symptom was a persistent ticking noise from the engine bay, which began around late December 2025 / early January 2026. There were no immediate warning lights or dashboard messages at the onset of the noise. The noise progressively worsened, prompting dealer inspection and diagnosis.

At approximately 52,000 miles, on August 11,2026 (or earlier), my vehicle developed a coolant leak that was traced to a failed coolant shut off valve. The coolant shut-off valve failure allowed coolant to migrate into the vacuum harness, vacuum reservoir which contaminated the water pump. This resulted in the vacuum system becoming filled with coolant, compromising components that rely on vacuum pressure to function correctly. The combination of these failures — water pump contamination, coolant shut-off valve failure, and a coolant-contaminated vacuum system — points to a defect in the design or manufacturing of these components rather than an isolated or wear-related issue.

The contact owns a 2021 Audi Q8. The contact stated that while driving at various speeds, the instrument panel failed to operate. The contact stated that while driving 70 MPH, the failure recurred. The contact received notification of NHTSA Campaign Number: 25V201000 (Electrical System), and the vehicle was taken to the dealer, where the recall repair was performed; however, the failure recurred the same day while driving from the dealer. Additionally, the contact stated that the vehicle stalled while driving at various speeds. The vehicle was taken to the dealer, where it was diagnosed that the fuel pump had failed, but the vehicle was not repaired due to the cost. The contact stated that while driving 50-55 MPH, the messages "Loss of Power", "Reduced RPMs to 3,000", and other unknown messages were displayed, and the vehicle stalled. The vehicle was towed to the residence. The contact related the failure to NHTSA Campaign Number: 22V516000 (Fuel System, Gasoline); however, the VIN was not included. The vehicle was not repaired. The manufacturer was notified of the failures. The failure mileage was approximately 60,000.

At approximately 52,000 miles, on August 11,2026 (or earlier), my vehicle developed a coolant leak that was traced to a failed coolant shut off valve. The coolant shut-off valve failure allowed coolant to migrate into the vacuum harness, vacuum reservoir which contaminated the water pump. This resulted in the vacuum system becoming filled with coolant, compromising components that rely on vacuum pressure to function correctly. The combination of these failures — water pump contamination, coolant shut-off valve failure, and a coolant-contaminated vacuum system — points to a defect in the design or manufacturing of these components rather than an isolated or wear-related issue.

I was driving my car would not accelerate on the highway and it almost caused me to get into an accident with my niece in the car. When I took the car to Audi this is what I was told my the service adviser. “Good afternoon. The technician has been looking into the vehicle and has found the cause of the issue. He has found the coolant water pump has failed internally causing coolant to leak internally into the vacuum system. This is causing the vacuum to be blocked for the turbo and thus causing the sluggish feeling when accelerating. In order to fix, the water pump and all compromised vacuum system components need to be replaced. It is a rather extensive job unfortunately.” My car only has a little over 45 thousand miles. Audi should be responsible to fix this problem because they sold this car knowing the water was faulty in these models. I recall should have been put out. I was quoted $6,000 to fix this problem.

On multiple occasions, the car states there is a steering malfunction and to stop the car immediately. Power steering fails. The last time I left the car to the dealership to have a recall serviced - it did this. I let the Audi (Fred Lavery Birmingham Michigan) know. They did not respond / did nothing. It has happens at least 10x at varying speeds (some high, med and low speed) since the day I left the dealership

Belt Starter Generator failure rendered car undrivable -- power steering failed while in motion. Issue is subject to Class Action Settlement in USDistrict Court, Case # 3:23-cv-02291-RK-RLS. But this should have been a recall because of danger of Injury or Death. A recall would provide notice that the notice of settlement failed to provide. This failure happened to me on March 29, 2026. Dealer is not able to do the repair work in a timely manner.

The contact owns a 2021 Audi Q8. The contact stated while driving 70 MPH, the vehicle shutoff as the electrical problem, see local dealer warning message appeared on the instrument panel. The contact pulled off to the side of the highway and had the vehicle towed to a local dealer. The vehicle remained in the possession of the dealer and had yet to be diagnosed. The manufacturer had yet to be notified of the failure. The vehicle had yet to be repaired. The failure mileage was approximately 3,500.

High beam assistant: Malfunction

TL* THE CONTACT OWNS A 2021 AUDI Q8. THE CONTACT STATED WHILE STOPPED AT A RED LIGHT, HE LEANED FORWARD AND THE FRONT DRIVER'S SEAT BELT SHOULDER HARNESS TIGHTENED WHICH CAUSED HIM SHORTNESS OF BREATH AND CHEST PAIN. MEDICAL TREATMENT WAS LATER RECEIVED FOR HIS INJURIES. AUDI RANCHO MIRAGE (71265 CA-111, RANCHO MIRAGE, CA 92270) WAS MADE AWARE OF THE FAILURE AND INFORMED THE CONTACT THAT THE SEAT BELT SHOULDER HARNESS TIGHTENED AS A PART OF THE SAFETY FEATURE OF THE VEHICLE. THE DEALER STATED THAT THEY WOULD VERIFY WHETHER OR NOT THE SAFETY FEATURE COULD BE DISABLED. THE VEHICLE WAS NOT DIAGNOSED NOR REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS 1,500.

Purchased my car used from Volkswagen of west islip. After a few months I was doing regular maintenance when I noticed that the brake sensor was missing and the harness was tampered with. The brake wear sensor was removed from the front driver side and a small price of wire/ conductive material was inserted into the harness to trick the cars system into on seeing the sensor in a safe and working manner. This would prevent the cars system from alerting me when the brakes need to be replaced which could have resulted in resulted in a serious accident due to brake failure. I feel like this was either deliberately done by the dealer before selling the car to save a few dollars or was overlooked during what should have been a basic safety inspection before listing the vehicle for sale. After reaching out to the dealer- they refused to fix the issue.