The parking brake connector is bad on a brake that is never used.
- NHTSA ID
- 11768342
- Incident
- Oct 1, 2026
Reports submitted to NHTSA by owners and drivers, shown in full
Data refreshed
Our database holds 44 NHTSA owner-reported complaints for the 2016 BMW 428I. Each one is a report filed by an owner or driver and published by NHTSA without most of them being verified. A complaint is not a confirmed defect, not a recall and not a manufacturer bulletin. Narratives are shown exactly as filed.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Showing 1–25 of 44 · page 1 of 2
The parking brake connector is bad on a brake that is never used.
Possible wiring harness for the air conditioning system that may be damaged and cause a short circuit. Had to air compressors installed and both reasons codes were "shorts". A damaged A/C wiring harness can short-circuit, potentially creating electrical issues and increasing safety risks while driving or when parked. A recall was just issued in February but my vehicle wasn't included and I'm thinking it is because most BMW owners today would not be owning a 2016 coupe which I bought in 2020 just because it was a good deal. I'm thinking no BMW owner bothered even submitting a complaint for this issue ever...just me because I'm poor and live in Miami, FL. Any help with this would be greatly appreciated! Thank you!
1. Radio cut on and off and then Engine failed. I started smelling weird fumes when I was driving but eventually the car restarted back up. 2. Car stopped on the highway and could have resulted in other vehicles running into me. 3. No, I parked the car at my house and don't drive it. 4.No, I parked the car at my house and I don't drive it 5. Yes, the yellow lights on the dash board came on and it said something about the ignition.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure.
The contact owns a 2016 BMW 428I. The contact stated that upon further inspection, the vehicle had an abnormal engine coolant leak. No warning light was illuminated. The contact stated that the engine temperature gauge was rising abnormally. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 115,000.
The contact owns a 2016 BMW 428I. The contact stated while driving 20 MPH, the vehicle hesitated, and the contact noticed smoke coming from the engine compartment. The check engine warning light was illuminated. An independent mechanic was contacted. The vehicle was taken to an independent mechanic and was diagnosed and determined that the engine was overheating, and the air condition system had failed. The vehicle was not repaired. The manufacturer was notified of the failure but offered no assistance. The contact related the failure to NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM). The contact stated that the manufacturer had exceeded a reasonable amount of time to repair the recall. The contact was referred to the NHTSA Hotline for assistance. The failure mileage was unknown.
The engine coolant pump on my 2016 BMW 4 Series has an open recall (#24V-608), issued in August 2024. It’s been almost a year, and the remedy is still marked as "Not Available." Recently, my check engine light came on. I used my personal OBD-II scanner and retrieved fault code U019F, which indicates “Lost Communication with Engine Coolant Pump Control Module.” This is directly related to the recalled component. I contacted BMW of Bay Ridge in Brooklyn, NY, and they told me I need to pay $335 for a diagnostic, even though I already provided the fault code and it matches the recall issue. They said this is a “standard diagnostic fee,” and they do not offer reimbursement even if it turns out to be related to the recall. BMW North America customer support told me that if a dealership confirms the fault is recall-related, they may try to expedite the remedy. But to get that confirmation, I’m expected to pay out of pocket first — which I find unacceptable since the part is already under an open recall and has now failed. So far, no dealer or service center has inspected the vehicle officially because I don’t want to pay $335 to confirm something I already know. Yes, my safety is at risk — the engine cooling system is compromised, and I’m afraid to drive the car. I feel severely impacted and stuck in a situation where BMW won’t take responsibility unless I pay first. This is unreasonable. I believe BMW should cover diagnostics or offer another way to confirm the issue without forcing owners to pay out of pocket for their known safety defect. I’m requesting NHTSA’s help in resolving this issue.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was unavailable. The contact stated that several dealers were contacted, and the contact was informed that parts were no longer available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available .
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
My 2016 BMW 428i is part of an active recall for a defective engine coolant pump. This defect caused damage to my coolant housing, water pump, thermostat, and engine, and BMW has stated there is no fix available. My vehicle is unsafe and undrivable, yet BMW has not provided any solutions. I am requesting that NHTSA investigate and require BMW to provide a resolution, such as repairs, compensation, or a buyback.
The manufacturer has not remedied recall number 24V-608 Water Pump Electrical Connector in a reasonable time. I have contacted my BMW local service provider and they say the manufacturer has nor supplied the necessary parts with no commitment n when parts will be available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical system); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
I hear weird sounds in the car and it smells like it's burning. The car stalls while driving and while in traffic.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The vehicle has had an open recall for more than 5 months as of today. No remedy is available. The dealer is refusing to assist with any solution to this problem or inspect the vehicle for this particular issue.
The contact owns a 2016 BMW 428i. The contact received notification of NHTSA Campaign Number: 24V608000(Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that the vehicle intermittently failed to start immediately and required several attempts to be started. The contact stated that there was white smoke coming from the rear of the vehicle while idling or while driving at various speeds. The check engine warning light and tire pressure monitoring warning light was illuminated. The dealer was contacted. The manufacturer was not made aware of the issue. The failure mileage was unknown. VIN tool confirms parts not available.
Recall has not been remedied.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Categories with enough reports to have a page of their own
Data on this page last refreshed .