The contact owns a 2019 BMW 440I. The contact stated that while driving at an undisclosed speed, there was a hissing sound coming from the vehicle, and there was white smoke coming from the engine compartment and the exhaust system. The vehicle went into LIMP Mode, with several unknown warning lights illuminated. The vehicle was towed to a local dealer, where it was diagnosed with a coolant leak and PCV failure. The vehicle was repaired. The manufacturer was notified of the failure. The failure mileage was approximately 60,000.
- NHTSA ID
- 11725078
- Incident
- Aug 21, 2025
- Mileage
- 60,000 mi
Electrical
Filed Feb 26, 2025
Emergency Call system failed. SOS warning on instrument cluster. In case of emergency the system is inoperative. This could provoke a Life/Death situation. Several other features are affected: Navigation system, Fuel mileage/distance monitor, Fuel level warning indicator, Clock display. Internet search support’s probable water leak into the Telematics Control Unit from the “Shark Fin” on the roof since it’s mounted right under it. There is a”Emergency Call Malfunction” displaying on the instrument cluster along with “SOS”. Note: there is an 8 volt back up battery in the system that has been confirmed operable therefore not the cause of failure. The problem started intermittently in the winter months of 2023 then failed entirely in winter of 2024.
- NHTSA ID
- 11645095
- Incident
- Oct 1, 2023
EngineFuel system
Filed Nov 1, 2024
BMW issued an extended warranty of 15 years/150k for a pressure control valve (PCV) failure for certain years/models that included my vehicle. While driving, the PCV failed causing a loud high pitch noise and white smoke billowing from my exhaust. Such an immediate failure while driving of this PCV valve should have been subject to a recall given the sudden and unexpected failure. I travel a lot for work and if this would have happened while travelling and out of town, it would have been a more serious incident in addition to the inconvenience. After have the PCV replaced, my vehicle's RPM's would drop at startup when put in reverse and/or back in drive, causing the vehicle to stall and jerk forward. This problem was never an issue prior to the PCV failure. Since the replacement my car has stalled numerous times placing myself in danger of having to hurriedly restart my car and "gun" the accelerator to prevent another stall. Because of this issue which I correlate directly to the PCV replacement, I am now being told the software needed to be updated. However, instead of being considered part of the PCV issue, they are charging 200 dollars to remedy. I'm sure others have reported issues similar to mine. Bottom line is that this whole issue should be subject to a recall and covered by BMW before someone's car stalls resulting in serious damages and injuries to vehicles and persons.
- NHTSA ID
- 11623089
- Incident
- Oct 12, 2024
BrakesEngine
Filed Feb 25, 2019
CAR WAS SLOWLY BEING DRIVEN INTO A PARKING SPACE WHEN IT ACCELERATED TO FULL ENGINE RPM DID A BURNOUT UP OVER A CURB AND INTO A LAMP POLE CONCRETE BASE. BRAKES WERE BEING FULLY APPLIED TO NO RESULT CAR STOPPED MOVING AT LAMP POST BASE ENGIN AT FULL RPM RIGHT REAR TIRE BURNING. PUSHED OFF BUTTON TO STOP MOTOR
- NHTSA ID
- 11182424
- Incident
- Jan 25, 2019
- Mileage
- 108 mi
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.