2014 BMW K 1600 Gtl Problems
Owner-reported complaints filed with NHTSA, grouped by component
Data refreshed
What this page shows
Everything below is an owner-reported complaint submitted to NHTSA about the 2014 BMW K 1600 Gtl, grouped by the component NHTSA recorded on the report. These are not confirmed defects, and they are not recalls. NHTSA does not verify most reports before publishing them, and a category with more reports in it is not evidence that a part is defective.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Reports by component
Ranked by how many owner reports name each component category
- Steering440.0%
- Engine220.0%
- Body & structure110.0%
- Fuel system110.0%
- Powertrain (other)110.0%
- Suspension110.0%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Each component in detail
What the reports in each category say, in the owners' own words
Steering
Reports naming the steering system — racks, columns, power-steering assist and steering linkage.
From owner reports, verbatim
WHILE RIDING THE BMW MOTORCYCLE THERE IS A PRONOUNCED PULL TO THE LEFT. THIS HAPPENS AT ALL SPEEDS. THE HIGHER THE SPEED THE GREATER THE PULL IS. THIS IS AN ONGOING PROBLEM SINCE APRIL 2014. DIFFERENT TIRES AND CHANGING THE RECOMMENDED TIRE PRESSURE MAKES NO IMPROVEMENT IN THE LEFT PULL.
1. THE MOTORCYCLES PULLS TO THE LEFT. CONSTANT CORRECTION IS STRESSFUL ON HIGHWAYS AND TAXES ONE'S MUSCLES. 2. ENGINE HAS A TICKING NOISE (VALVE CHATTERING) AT 3000-3500 RPM BAND (FIRST NOTICED AT 8000 MILES) AND DEALER/MANUFACTURER IS UNABLE TO DO ANYTHING ABOUT IT. THERE ARE LOTS OF K1600 ON THE ROAD WITH THIS ISSUE AND BMW HAS NO RESOLUTION FOR THIS. 3. SHIFTING TO NEUTRAL - FIRST OBSERVED AT APPROX 16000 MILES (IMMEDIATELY AFTER THIRD SERVICE) - THE MOTORCYCLE DOES NOT SLOT INTO 2ND AND NEUTRAL GEARS WITH PRECISION. FIRST GEAR HAS A LOUD CLUNK SOUND ON ENGAGING AND SOMETIMES CLUTCH DO NOT DISENGAGE FULLY ENOUGH THOUGH I WOULD DEPRESS THE LEVER FULLY. AT TIMES GEAR CHANGE REQUESTS ARE ABORTED AS THE GEAR CHANGE ENTERS LIMBO STATE. THE GEARBOX AND CLUTCH DO NOT WORK IN TANDEM FOR SMOOTH UPSHIFTS. AT STOP-N-GO TRAFFIC FINDING NEUTRAL BY ROCKING GEAR LEVER IS A PAIN. I HAVE TO CONSTANTLY LOT AT GEAR INDICATOR TO CONFIRM IS UPSHIFT WAS EXECUTED FROM 1ST TO 2ND (OR IS IT IN A LIMBO - NOT EVEN NEUTRAL). DURING THIS SITUATION THERE IS LOUD MECHANICAL GRINDING NOISE WHEN I WOULD WANT TO SLOT TO SECOND GEAR AND COUPLE OF ATTEMPTS TO UPSHIFT GO IN VAIN. BEEN RIDING FOR YEARS AND I KNOW ALL TIMING TECHNIQUES BUT A MISSED UPSHIFT PUTS ME AT RISK.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Engine
Reports naming the engine itself — including stalling, misfires, oil consumption, cooling and internal engine components.
From owner reports, verbatim
1. THE MOTORCYCLES PULLS TO THE LEFT. CONSTANT CORRECTION IS STRESSFUL ON HIGHWAYS AND TAXES ONE'S MUSCLES. 2. ENGINE HAS A TICKING NOISE (VALVE CHATTERING) AT 3000-3500 RPM BAND (FIRST NOTICED AT 8000 MILES) AND DEALER/MANUFACTURER IS UNABLE TO DO ANYTHING ABOUT IT. THERE ARE LOTS OF K1600 ON THE ROAD WITH THIS ISSUE AND BMW HAS NO RESOLUTION FOR THIS. 3. SHIFTING TO NEUTRAL - FIRST OBSERVED AT APPROX 16000 MILES (IMMEDIATELY AFTER THIRD SERVICE) - THE MOTORCYCLE DOES NOT SLOT INTO 2ND AND NEUTRAL GEARS WITH PRECISION. FIRST GEAR HAS A LOUD CLUNK SOUND ON ENGAGING AND SOMETIMES CLUTCH DO NOT DISENGAGE FULLY ENOUGH THOUGH I WOULD DEPRESS THE LEVER FULLY. AT TIMES GEAR CHANGE REQUESTS ARE ABORTED AS THE GEAR CHANGE ENTERS LIMBO STATE. THE GEARBOX AND CLUTCH DO NOT WORK IN TANDEM FOR SMOOTH UPSHIFTS. AT STOP-N-GO TRAFFIC FINDING NEUTRAL BY ROCKING GEAR LEVER IS A PAIN. I HAVE TO CONSTANTLY LOT AT GEAR INDICATOR TO CONFIRM IS UPSHIFT WAS EXECUTED FROM 1ST TO 2ND (OR IS IT IN A LIMBO - NOT EVEN NEUTRAL). DURING THIS SITUATION THERE IS LOUD MECHANICAL GRINDING NOISE WHEN I WOULD WANT TO SLOT TO SECOND GEAR AND COUPLE OF ATTEMPTS TO UPSHIFT GO IN VAIN. BEEN RIDING FOR YEARS AND I KNOW ALL TIMING TECHNIQUES BUT A MISSED UPSHIFT PUTS ME AT RISK.
WHILE DRIVING ON THE HIGHWAY IN TRAFFIC AT APPROXIMATELY 70MPH, THE ENGINE SUDDENLY SHUT OFF WITH NO WARNING. WE WERE FORCED TO GO OFF THE ROAD ON LEFT SHOULDER TO AVOID BEING STRUCK FROM BEHIND. ENGINE WOULD NOT RESTART, AND WE COASTED ACROSS TO THE RIGHT SHOULDER WHEN IT WAS SAFE TO DO SO. THIS COULD HAVE BEEN MUCH WORSE. ALL ELECTRICAL FUNCTIONS WERE STILL WORKING, JUST NOT THE ENGINE. *TR
Too few reports in this category for a page of its own — they appear in the full complaint list.
Body & structure
Reports naming the vehicle structure, frame, body panels, doors, hood and trim.
From owner reports, verbatim
WHEN MY WIFE AND I CAME TO A STOP AFTER COMING OFF THE INTERSTATE, SHE ADJUSTED HER SELF ON THE SEAT OF THE 2014 BMW K1600 MOTORCYCLE, AS SHE USED THE ARM REST FOR SUPPORT IN SHIFFING HER WEIGH (SHE WEIGHTS 105 LBS) THE ARM REST SNAPPED OFF). HAD WE BEEN GOING INTO A TURN OR PASSING ANOTHER VEHICLE, AND IF SHE HAD BEEN USING THE ARMREST FOR SUPPORT AND IT BROKE, THIS COULD HAVE SHIFTED HER WEIGHT UNEXPECTIALLY WHICH MIGHT HAVE CAUSE THE DRIVE TO LOSE CONTROL OF THE MOTORCYCLE. I REPORTED THIS TO THE DEALER AND BMW, RECEIVED A CALL FROM BMW ASKING ME TO CALL THEM BACK, I DID, SHORTLY AFTER GETTING THERE CALL. NO ANSWER, EMAILED THEM 4 TIMES, NO ANSWER. I CONSIDER THIS A FACTORY DEFECT WITH THE PART JUST SNAPPING OFF. I HAVE PICTURES OF MY BIKE TO SHOW IT WAS NOT DROPPED OR DAMAGED. SIMILY A BAD PART. I HAD TO USE EPOXEY TO FASTHEN IT BACK ON SO THAT MY WIFE WOULD NOT CUT HER SELF ON THE SHARP EDGES. THE LADY THAT CALLED FROM BMW SAID HERE NAME WAS ASHLEY, (800-831-1117 EXT 8816. HOWEVER, AFTER CALLING BACK 4 TIMES, ON TWO DAYS, AND 4 EMAILS, IT APPEARS THEY ARE TOO BUSY TO REPLY TO MY CONCERN.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Fuel system
Reports naming fuel storage or delivery — tanks, pumps, lines, injectors and fuel leaks.
From owner reports, verbatim
BMW has an open recall regarding a defective fuel pump. Affected bikes: BMW K 1600 GT, K 1600 GTL, K 1600 GTL Exclusive (2011-2014) When I contact BMW they tell me my VIN is not affected, but I have 100% confirmed that my fuel pump is leaking gas at a very unsafe rate. My bike year and model matches, and the effected part also matching, including the failure. This can cause my motorbike to turn into flames very easily as soon as it is turned on. I have seen it throw a flame but it stopped soon after. BMW is not willing to help me, even though there is an open recall.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Powertrain (other)
Powertrain reports that are not specifically the engine or transmission — driveshafts, axles, transfer cases and differentials.
From owner reports, verbatim
1. THE MOTORCYCLES PULLS TO THE LEFT. CONSTANT CORRECTION IS STRESSFUL ON HIGHWAYS AND TAXES ONE'S MUSCLES. 2. ENGINE HAS A TICKING NOISE (VALVE CHATTERING) AT 3000-3500 RPM BAND (FIRST NOTICED AT 8000 MILES) AND DEALER/MANUFACTURER IS UNABLE TO DO ANYTHING ABOUT IT. THERE ARE LOTS OF K1600 ON THE ROAD WITH THIS ISSUE AND BMW HAS NO RESOLUTION FOR THIS. 3. SHIFTING TO NEUTRAL - FIRST OBSERVED AT APPROX 16000 MILES (IMMEDIATELY AFTER THIRD SERVICE) - THE MOTORCYCLE DOES NOT SLOT INTO 2ND AND NEUTRAL GEARS WITH PRECISION. FIRST GEAR HAS A LOUD CLUNK SOUND ON ENGAGING AND SOMETIMES CLUTCH DO NOT DISENGAGE FULLY ENOUGH THOUGH I WOULD DEPRESS THE LEVER FULLY. AT TIMES GEAR CHANGE REQUESTS ARE ABORTED AS THE GEAR CHANGE ENTERS LIMBO STATE. THE GEARBOX AND CLUTCH DO NOT WORK IN TANDEM FOR SMOOTH UPSHIFTS. AT STOP-N-GO TRAFFIC FINDING NEUTRAL BY ROCKING GEAR LEVER IS A PAIN. I HAVE TO CONSTANTLY LOT AT GEAR INDICATOR TO CONFIRM IS UPSHIFT WAS EXECUTED FROM 1ST TO 2ND (OR IS IT IN A LIMBO - NOT EVEN NEUTRAL). DURING THIS SITUATION THERE IS LOUD MECHANICAL GRINDING NOISE WHEN I WOULD WANT TO SLOT TO SECOND GEAR AND COUPLE OF ATTEMPTS TO UPSHIFT GO IN VAIN. BEEN RIDING FOR YEARS AND I KNOW ALL TIMING TECHNIQUES BUT A MISSED UPSHIFT PUTS ME AT RISK.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Suspension
Reports naming suspension components — springs, struts, shocks, control arms and related hardware.
From owner reports, verbatim
WHILE RIDING THE BMW MOTORCYCLE THERE IS A PRONOUNCED PULL TO THE LEFT. THIS HAPPENS AT ALL SPEEDS. THE HIGHER THE SPEED THE GREATER THE PULL IS. THIS IS AN ONGOING PROBLEM SINCE APRIL 2014. DIFFERENT TIRES AND CHANGING THE RECOMMENDED TIRE PRESSURE MAKES NO IMPROVEMENT IN THE LEFT PULL.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — owner-reported complaints and the components recorded on them
Data on this page last refreshed .