RoadVitals

1998 BMW K1200RS Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
4
Newest Sep 12, 2000
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
2 investigations on file

Recall campaigns

4 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

00V266000

ENGINE AND ENGINE COOLING:ENGINE

Sep 12, 2000
188 units potentially affected
The defect: VEHICLE DESCRIPTION: MOTORCYCLES. THE CYLINDER HEAD CONTAINS TWO SEALING PLUGS COVERING HOLES IN THE AREA NEAR THE SPARK PLUGS. ONE OR BOTH PLUGS MAY NOT HAVE BEEN FULLY SEATED DURING VEHICLE ASSEMBLY. EITHER OR BOTH OF THE SEALING PLUGS COULD LOOSEN OR COMPLETELY DETACH FROM THEIR MOUNTING POINT DURING VEHICLE OPERATION.
The risk: THIS CONDITION COULD ALLOW COOLANT TO ESCAPE, TRAVEL ALONG THE ENGINE COVER, AND CONTACT THE REAR TIRE, REDUCING ITS TRACTION AND AFFECTING THE STABILITY OF THE MOTORCYCLE. IN ADDITION, THE LOSS OF COOLANT COULD LEAD TO INCREASED ENGINE OPERATING TEMPERATURE AND POSSIBLE OVERHEATING.
The remedy: DEALERS WILL REPLACE THE SEALING PLUGS WITH A STAINLESS STEEL PLUG DESIGN.
BAYERISCHE MOTOREN WERKEView on NHTSA.gov
00V264000

ENGINE AND ENGINE COOLING:ENGINE

Sep 12, 2000
2,368 units potentially affected
The defect: VEHICLE DESCRIPTION: MOTORCYCLES. A SPRING-LOADED THERMOSTATIC ELEMENT IN THE OIL THERMOSTAT HOUSING IS HELD IN PLACE BY A COVER THAT IS RETAINED BY A SNAP RING. THE SNAP RING MAY NOT HAVE BEEN PROPERLY INSTALLED DURING PRODUCTION. DURING VEHICLE OPERATION, THE SNAP RING COULD UNSEAT, ALLOWING THE COVER TO LOOSEN OR DETACH, RESULTING IN LOSS OF THE ENTIRE OIL VOLUME.
The risk: ENGINE DAMAGE COULD OCCUR IF THE ENGINE IS NOT IMMEDIATELY SWITCHED OFF. IN ADDITION, OIL COULD TRAVEL ALONG THE ENGINE COVER AND ULTIMATELY CONTACT THE REAR TIRE, REDUCING ITS TRACTION AND AFFECTING THE STABILITY OF THE MOTORCYCLE, POSSIBLY RESULTING IN A CRASH AND PERSONAL INJURY.
The remedy: DEALERS WILL INSPECT THE SNAP RING INSTALLATION AND IF THE SNAP RING IS NOT FULLY SEATED, THE COMPLETE OIL PUMP INTERMEDIATE FLANGE WILL BE REPLACED.
BAYERISCHE MOTOREN WERKEView on NHTSA.gov
98V258000

FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY

Oct 14, 1998
1,000 units potentially affected
The defect: VEHICLE DESCRIPTION: MOTORCYCLES. DURING EXTENDED OPERATION IN HIGH AMBIENT TEMPERATURE CONDITIONS, THE AREA OF THE PUMP MOUNTING SURFACE OF THE FUEL TANK CAN DEFORM, FORMING A GAP BETWEEN THE TANK MOUNTING SURFACE AND THE GASKET, ALLOWING FUEL TO ESCAPE FROM THE TANK AT THAT AREA.
The risk: IF AN IGNITION SOURCE WAS PRESENT, A FIRE COULD OCCUR RESULTING IN PERSONAL INJURY.
The remedy: DEALERS WILL REPLACE THE FUEL PUMP-TO-TANK GASKET.
BAYERISCHE MOTOREN WERKEView on NHTSA.gov
97V134000

SERVICE BRAKES, HYDRAULIC

Aug 8, 1997
973 units potentially affected
The defect: VEHICLE DESCRIPTION: MOTORCYCLES. THE ADJUSTING SCREW FOR THE PRESSURE POINT OF EITHER THE BRAKE OR CLUTCH LEVERS MAY NOT BE SUFFICIENTLY TIGHT, DUE TO GREASE CONTAMINATION OF THE THREADS.
The risk: THE SCREW(S) CAN BACK OUT OVER TIME WHILE THE VEHICLE IS BEING OPERATED CAUSING A CHANGE IN THE PRESSURE POINT OF THE MASTER CYLINDER FOR THE CLUTCH AND/OR FRONT BRAKE INCREASING THE RISK OF A VEHICLE CRASH.
The remedy: DEALERS WILL CHECK THE ADJUSTMENT SCREWS OF THE FRONT BRAKE AND CLUTCH LEVERS FOR MOVEMENT. IF THE SCREWS ARE TIGHT, NO FURTHER ACTION WILL BE TAKEN. IF A SCREW IS FOUND TO BE LOOSE, IT WILL BE REMOVED, CLEANED AND REINSTALLED WITH NEW LOCTITE.
BAYERISCHE MOTOREN WERKEView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

PE98047ClosedPreliminary Evaluation

FUEL TANK LEAK

Opened Aug 27, 1998
Closed Oct 15, 1998

ALLEGED THAT THE FUEL LEAKS AT THE INTERFACE BETWEEN THE FUEL TANK AND FUEL PUMP ASSEMBLY

VEHICLE SPEED CONTROL:LINKAGESLed to recall 98V258000
SQ97023ClosedInvestigation

REDUCED CLUTCH AND BRAKE EFFECTIVENESS

Opened Nov 14, 1997
Closed Dec 22, 1997

IN AUGUST 1997, BMW CONDUCTED A SAFETY RECALL TO CORRECT A CONDITION OF THREAD CONTAMINATION ON THE BRAKE AND CLUTCH LEVERS ADJUSTING SCREWS.THIS GREASE CONTAMINATION NEGATES THE EFFECTIVENESS OF LOCTITE AND THIS CAN SEGNIFICANTLY REDUCE BRAKE EFFECTIVENESS.DUE TO THIS INVESTIGATION, BMW HAS INCREASED THE POPULATION TO INCLUDE ALL THE 1988 MOTORCYCLES.NO FURTHER ACTION IS NECESARY.THIS INVESTIGATION IS CLOSED.RECALL NUMBER ASSIGNED IS 97V-134.02.

SERVICE BRAKES, HYDRAULIC

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .