Reports submitted to NHTSA by owners and drivers, shown in full
Data refreshed
Our database holds 103 NHTSA owner-reported complaints for the 2020 BMW X5. Each one is a report filed by an owner or driver and published by NHTSA without most of them being verified. A complaint is not a confirmed defect, not a recall and not a manufacturer bulletin. Narratives are shown exactly as filed.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Showing 1–25 of 103 · page 1 of 5
This vehicle has AC problem it’s blowing hot air. It has evaporator leaking. I called multiple shops and they said this problem is very popular for the X5 2019 to 2023 in my car is 2020. Please recall the Evaporator Core problem. It is too dangerous to drive in the car without AC and is too expensive to Have the Evaporator Core replacement.
My 2019 BMW X5 (G05) equipped with the B58 Technical Update (B58TU) engine has experienced a failure / is showing early signs of failure of the engine oil pump assembly.Beginning with the B58TU engine, BMW utilized a variable-displacement oil pump that contains a thermoplastic/plastic internal adjusting ring. This plastic component degrades under normal operating temperatures, resulting in a sudden mechanical failure of the pump. This failure leads to a sudden drop in engine oil pressure, vehicle disablement without sufficient warning, or an inability for the iDrive infotainment system to complete an electronic oil level measurement.A sudden loss of engine lubrication while driving presents a severe safety hazard, capable of immobilizing the vehicle in active traffic. BMW has updated this exact pump part number to utilize all-metal internal carriers on later production runs, but refuses to cover the cost for early out-of-warranty models. I am requesting that the NHTSA open a safety defect investigation into the early B58TU oil pump assembly to force a mandatory safety recall.
It’s a common issue between 2019-2020 where the oil pump which came from factory has plastic impellers which crack/disintegrate causing catastrophic failure to the engine disabling the vehicle the only warning signs before this happens is you cant read oil level and or the car prompts with a warning low oil messages if untreated the car will have catastrophic engine failure with little to no warning the car was mass produced and this is a common issue therefore should be recalled
Low oil pressure light came on during interstate drive. Later analysis at dealership revealed this is related to faulty oil pump with plastic parts in B58 engine.
I replaced my starter prior to a recall that was issued. After the recall, I submitted a claim for reimbursement and the check was issued. Bmw of North American has not updated the recall information associated with my vin. I am this unable to list my vehicle on any rental platform as it is showing a status of an open recall for the starter. The repair was done in September, 2025 and I was reimbursed 3 weeks ago.
Hello, my front differential recently failed on my BMW. based on some research, this appears to be a manufacturing defect that BMW isn't covering affecting many owners of this car.
The AC system blowed hot air. There's must be a problem with this model because my friend also have the 2021 BMW X5 and its AC also have problem. We're suffering from this due to Manufacturing defect.
The contact owns a 2020 BMW X5. The contact received notification of NHTSA Campaign Number: 25V644000 (Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.
For my 2019 BMW X5 SDRIVE40i, The A/C evaporator core failed and began leaking refrigerant, resulting in complete loss of cold air from the A/C system. The vehicle had approximately 50,000 miles. The repair required full dashboard removal and cost approximately $4,500 including a rental vehicle. This appears to be a widespread issue on 2019–2025 BMW X5/X6/X7 models, suspected to be caused by R-1234yf refrigerant incompatibility with the aluminum evaporator core. The leaking R-1234yf refrigerant is also an environmental concern. R-1234yf is a hydrofluorocarbon (HFC) greenhouse gas with a global warming potential significantly higher than CO2. An uncontrolled leak of this refrigerant directly into the atmosphere — due to a defective factory-installed evaporator core — contributes to environmental harm and violates the spirit of EPA regulations governing refrigerant emissions. Consumers should not bear the financial burden of a known manufacturing defect that also results in the uncontrolled release of a regulated substance. BMW has not issued a recall or extended warranty for this component despite widespread owner reports of the same failure. I am requesting NHTSA investigate this issue and compel BMW to issue a formal recall and provide reimbursement to affected owners.
I own a 2019 BMW X5 xDrive40i with the B58 3.0L turbocharged inline-six engine. While driving in Minnesota, the vehicle suddenly displayed an urgent warning stating “oil pressure too low” and instructed me to stop the engine. This occurred while the vehicle was being operated on the road, requiring me to stop driving immediately. The vehicle was later inspected by an authorized BMW dealer. The dealer diagnosed the failure as a defective oil pump and stated that the oil pump must be replaced. The estimated repair cost was approximately $7,500 or more. This is a serious safety concern because a sudden loss of engine oil pressure can lead to engine seizure, loss of motive power, and loss of vehicle control risk depending on traffic conditions. The oil pump is a critical lubrication component and should not fail as a normal wear item. I have found numerous similar owner reports involving BMW B58 oil pump failures, including reports suggesting that cold-weather operation may contribute to or expose the failure. My vehicle is operated in Minnesota, a cold-weather state. The vehicle was inspected by Park Place BMW in Rochester, MN. I am requesting that NHTSA investigate whether this is a safety-related defect affecting 2019 BMW X5 xDrive40i vehicles and other BMW models equipped with the B58 engine.
Front Differential input bearing failure. Sudden jerking that almost causes loss of control. This poses a safety risk. This seems to be a know problem for the 2020 BMW X5 M50i No warning lights and I did not experience hearing any sounds as other have reported.
Plastic oil pump cracking problem is apparently known to BMW, but they haven’t recalled these defective oil pumps leading to engine failure.
The contact owns a 2020 BMW X5. The contact stated that the vehicle was taken to a dealer for routine maintenance and it was discovered that there was a coolant leak and that there was a failure with the front differential failure, and that the A/C unit was leaking. The leaking valve was replaced but the differential was not repaired. The contact stated that the failure was a known failure with the vehicle. The manufacturer was made aware of the failure. The failure mileage was 70,000.
Failure of front differential
Safety Hazard: Oil Pump Failure Leading to Sudden Engine Stall (BMW B58TU engines) Description of Defect: The oil pump module in the 2020 BMW X5 (G05) contains internal plastic components that are prone to thermal degradation and premature failure. These plastic parts can crack or disintegrate, causing a sudden loss of oil pressure. Safety Risk: A failure of the oil pump leads to insufficient lubrication of critical engine components, which can result in a sudden and complete engine seizure while the vehicle is in motion. This causes an immediate loss of propulsion and power steering assist, significantly increasing the risk of a high-speed collision or being stranded in dangerous traffic conditions. Additional Note: This is a known mechanical defect where a critical engine component (oil pump) relies on non-durable plastic materials, creating an unreasonable safety risk for drivers and passengers due to potential catastrophic engine failure without prior warning.
Safety Hazard: Oil Pump Failure Leading to Sudden Engine Stall (BMW G05 X5) Description of Defect: The oil pump module in the 2020 BMW X5 (G05) contains internal plastic components that are prone to thermal degradation and premature failure. These plastic parts can crack or disintegrate, causing a sudden loss of oil pressure. Safety Risk: A failure of the oil pump leads to insufficient lubrication of critical engine components, which can result in a sudden and complete engine seizure while the vehicle is in motion. This causes an immediate loss of propulsion and power steering assist, significantly increasing the risk of a high-speed collision or being stranded in dangerous traffic conditions. Additional Note: This is a known mechanical defect where a critical engine component (oil pump) relies on non-durable plastic materials, creating an unreasonable safety risk for drivers and passengers due to potential catastrophic engine failure without prior warning.
The contact owns a 2020 BMW X5. The contact received notification of NHTSA Campaign Number: 25V644000 (ELECTRICAL SYSTEM); however, the part to do the recall repair was not yet available. The contact stated that the vehicle failed to start. After several attempts, the vehicle started. The check control master warning light was illuminated. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was approximately 120,000.
While driving through west Los Angeles, the vehicle suddenly began emitting white smoke from the engine compartment. There were no prior warning lights, messages, or symptoms indicating a problem. The smoke quickly intensified and turned dark. Thick smoke filled the air, and the cockpit, with the smell of toxic fumes. I safely maneuvered to the shoulder and exited the vehicle with my passenger. Flames erupted from the front of the vehicle. We called 911, which dispatched the fire department. The LAFD responded, cutting open the hood in order to extinguish the fire. The vehicle was towed to a yard following the incident. The vehicle and its contents were declared a total loss. BWM North America dispatched a technician to inspect the vehicle. After inspection, the manufacturer indicated that the starter was the source of the fire. At the time of the incident, the vehicle was subject to a safety recall related to the starter with no remedy available. The failure occurred without warning. Both occupants were exposed to heavy smoke.
I'm reporting a safety issue with BMW vehicles equipped with the B58TU engine (primarily 2019–2021 models). These vehicles use an oil pump containing an internal plastic component that regulates oil pressure. This plastic part is fracturing in the field, leading to sudden loss or instability of oil pressure. Failures commonly occur during cold starts in low temperatures. When the component fails, oil pressure becomes erratic or is lost entirely, often with little to no warning before engine damage or vehicle disablement. Warning signs, when present, include inability to measure oil level electronically, abnormal oil pressure behavior, or sudden drivetrain malfunction warnings. These can quickly progress to engine shutdown or severe engine damage due to oil starvation. My vehicle is currently experiencing all of the described oil pump-related symptoms, including inconsistent electronic oil level readings and drivetrain malfunction warnings consistent with oil pressure instability. This condition creates a serious safety risk. The vehicle can become disabled without warning while driving or shortly after startup. Oil starvation can lead to catastrophic engine failure, especially at highway speeds, where sudden engine shutdown or seizure increases the risk of a crash. Failures are particularly dangerous in winter conditions, when vehicles may become immobilized in traffic or freezing temperatures. Replacement of the pump requires major disassembly and typically costs $6,000–$8,000, assuming no engine damage. Owners cannot determine whether their vehicle has the original plastic component or a revised metal version. BMW’s VIN-based parts lookup now shows only updated components even when original plastic parts remain installed, and the original plastic part number has been removed from dealer systems. Because this defect can cause sudden vehicle disablement and potential catastrophic engine failure without adequate warning.
I am reporting a safety concern involving BMW vehicles equipped with the B58 Technical Update (B58TU) engine, commonly found in model years 2019–2021. These vehicles utilize a variable-displacement engine oil pump containing an internal thermoplastic adjusting component responsible for regulating oil pressure. Field failures are increasingly being reported in which this internal component fractures, resulting in sudden loss or instability of engine oil pressure. The failure frequently occurs during cold-start operation in low ambient temperatures. When the component fails, oil pressure regulation becomes erratic or is lost entirely. In many cases, drivers receive little or no actionable warning prior to engine damage or vehicle disablement. Reported precursor symptoms include inability to electronically measure engine oil level, abnormal oil pressure behavior, or sudden drivetrain malfunction warnings. Failures may rapidly progress to engine shutdown or severe mechanical damage caused by oil starvation. Loss of lubrication can cause the vehicle to become disabled without warning while driving or shortly after startup. This creates a safety hazard, particularly when vehicles become immobilized in active traffic or during winter conditions the cold is when they fail the most, where occupants may be exposed to freezing temperatures while awaiting assistance. Replacement of the oil pump requires extensive disassembly of the vehicle and repairs commonly exceed $6,000–$8,000 for just the pump, assuming the motor is unharmed. Owners are currently unable to determine whether their vehicles contain the original thermoplastic oil pump design or a later revised version utilizing metal internal components, as VIN-based parts information now identifies updated components in the car even when no replacement has occurred and the old components are actually in the car. Also, BMW has actively removed the plastic part number out of all dealer networks as well. Failures have be
I am submitting this correspondence as a formal notification of a potential safety-related defect affecting BMW vehicles equipped with the B58 Technical Update (B58TU) engine platform, most commonly model years 2019–2021. The purpose of this communication is to request immediate review under BMW’s vehicle safety defect evaluation process due to an increasing number of oil pump failures capable of causing sudden loss of engine lubrication, unexpected vehicle disablement, and occupant exposure to hazardous conditions. The original B58 engine (B58B30M0, 2015–2017) utilized a conventional mechanically robust gerotor oil pump with predominantly metallic internal construction and demonstrated strong reliability in field operation. This component, constructed from reinforced thermoplastics including PA66-GF materials, operates within a chemically aggressive and thermally cyclic environment involving continuous exposure to engine oil additives, fuel dilution, condensation, and repeated heat cycling. While acceptable under accelerated validation testing, real-world operating conditions increasingly demonstrate premature degradation consistent with polymer embrittlement and fracture. Documented owner and technician reports indicate that under cold-start conditions — particularly in sub-freezing climates — elevated oil viscosity and startup load impose increased mechanical stress on the thermoplastic carrier. Fracture of this internal component allows debris intrusion into the pump mechanism, resulting in unstable oil pressure regulation. Commonly reported precursor symptoms include: • Inability to perform electronic oil level measurement via iDrive • Erratic or oscillating oil pressure behavior • Intermittent lubrication warnings or absence of warning prior to failure • Rapid progression to bearing damage and engine seizure Given the potential for sudden vehicle disablement without adequate warning, I respectfully request BMW of North America initiate a formal inquiry
Please read file attached
The contact owns a 2020 BMW X5. The contact stated that while the vehicle was parked, there was fluid and lubricant on the ground underneath the vehicle. No warning lights were illuminated. The vehicle was taken to the dealer where it was diagnosed with a detached front differential shaft bearing. In addition, the contact was informed that the front differential shaft bearing caused excessive play in the propeller shaft. The contact was informed that the front differential shaft bearing needed to be replaced. The vehicle was not repaired. The contact stated that the failure was a known failure with the vehicle. The contact stated that the vehicle was serviced by the dealer seven weeks prior to the failure. The manufacturer was made aware of the failure but provided no assistance. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was unknown.
The contact owns a 2020 BMW X5. The contact received notification of NHTSA Campaign Number: 25V644000 (Electrical System); however, the part to do the recall repair was not yet available. The dealer was contacted and confirmed that parts were not yet available for the recall repair. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.
Vehicle has excessive condensation in driver headlight. Garage kept only. Problem discovered because of parking vehicle outside on driveway while the garage hosted moving boxes. This was the only time this vehicle has spent the night outside.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Categories with enough reports to have a page of their own
Data on this page last refreshed .