2016 Buick Cascada

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

The contact owns a 2016 Buick Cascada. The contact stated that while driving at an undisclosed speed, the vehicle made an abnormal squealing sound. The vehicle was subsequently taken to the dealer, where it was diagnosed with a PCV valve failure. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 19,000.

NHTSA ID

11745874

Incident

Jun 21, 2026

Mileage

19,000 mi

Buick Cascada back window on the convertible tops coming apart, causing flooding inside the car, also there's a danger the window will come out driving down the road. Buick refuses to do anything.

NHTSA ID

11731096

Incident

Jan 15, 2021

The back window on the convertible top has separated from the fabric. Buick dealership said it was not a covered item under the extended warranty. We tried to glue it back down but it keeps separating all around. Dangerous situation because it could separate completely during travel and cause an accident/injury to others. Should be a recall item since it is being reported by several other Cascada owners.

NHTSA ID

11718833

Incident

Apr 1, 2022

The rear window of the convertible top starts to pull away from the top itself. Could separate and displace entirely causing damage or injury behind.

NHTSA ID

11718797

Incident

Feb 18, 2026

See attached document for complaint.

NHTSA ID

11688051

Incident

Aug 11, 2025

The contact owns a 2016 Buick Cascada. The contact stated that when his wife entered the vehicle, the rear passenger’s side window automatically rolled down when the vehicle was started. The contact was unable to confirm if any warning lights were illuminated. The contact stated that the failure was related to NHTSA Campaign Number: 16V844000 (Visibility). The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was contacted and confirmed that the VIN was not under recall. The failure mileage was approximately 80,000.

NHTSA ID

11675525

Incident

Jan 1, 2023

Mileage

80,000 mi

The motor is out of the seat belt presenter on the driver's side. It does not present and makes a horrible sound. This part was ordered in July, 2024. I've contacted the dealer and Buick directly to find out when I can expect the part to be replaced. They've told me that the back is on an extended back order. I asked if the part could be replaced with a used part. They told me that because it's a safety-sensitive part, it has to be replaced with a new part. But this part has been on back order for months with no delivery in sight, and they expect me to drive my car like this with this "safety" issue compromised.

NHTSA ID

11630157

Incident

Jul 31, 2024

The rear window on the Cascada is known to separate from the convertible top material, likely due to an insufficient amount of primer used during the assembly process, which creates stress points allowing the material to separate from the glass. Once this bond has started to fail, it is eventually going to lead to the glass completely falling off the car. It is likely that the glass separating could render the rear defrost inoperable, too, decreasing visibility. NHTSA bulletin 17-NA-216 describes this problem; why was no recall ever issued?

NHTSA ID

11582433

Incident

Apr 8, 2024

PI to help diagnose A/C concern

This preliminary information communicates information about how to determine if a wheel and tires size change is available.

This Preliminary information communicates the steps on how to save a GDS2 Session Log and upload to a Technical Assistance Case in CX Connect.

This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.

This preliminary information advises a dealer on how to email GDS2 session logs into Technical Assistance.

This Preliminary Information communication provides information to the technician about vehicles that have had multiple repair attempts that are being performed on customer’s vehicles that exhibit vibration conditions without utilizing the support of General Motors Technical Assistance Center. If valid vibration frequency or Road Force Variation data has been collected and a repair attempt does not correct the customer complaint, contact General Motors Technical Assistance Center for further support. For any vehicles that remains unrepaired after being at the dealer for three days or more and a related bulletin or PI is not found, contact General Motors Technical Assistance Center for further support.