RoadVitals

1987 Buick Lesabre Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
5
Newest May 19, 2006
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
9 investigations on file

Recall campaigns

5 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

06E043000

FUEL SYSTEM, GASOLINE

May 19, 2006
88,303 units potentially affected
The defect: CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
The risk: THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.
The remedy: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).
HONEYWELL INTERNATIONAL, INC.View on NHTSA.gov
89V102000

VEHICLE SPEED CONTROL

Jun 16, 1989
1,755,897 units potentially affected
The defect: A SMALL NYLON BUSHING IN THE CRUISE CONTROL SERVO BAIL MAY SLIP OUT OF PLACE, CAUSING INTERMITTENT AND UNEXPECTED INCREASES IN ENGINE SPEED OR DIESELING (ENGINE RUN ON WITH IGNITION OFF).
The risk: SERVO ROD ASSEMBLY COULD CATCH ON ENGINE COMPONENTS ANDRESULT IN A STUCK THROTTLE WITH POTENTIAL FOR A VEHICLE CRASH.
The remedy: INSTALL A NEW BUSHING IN CRUISE CONTROL SERVO BAIL.
GENERAL MOTORS CORP.View on NHTSA.gov
88V067000

SERVICE BRAKES, AIR:ANTILOCK

Apr 19, 1988
1,889 units potentially affected
The defect: LOW TORQUE OF THE BRAKE HYDRAULIC UNIT MOUNTING BOLTS COULD CAUSE INCREASED BRAKE PEDAL TRAVEL AND/OR POOR PEDAL FEEL IF ATTACHMENT LOOSENS.
The risk: THIS CONDITION COULD LEAD TO SEPARATION OF BRAKEHYDRAULIC UNIT FROM ITS MOUNTING BRACKET AND RESULT IN LOSS OF BRAKE FUNCTIONAND AN ACCIDENT.
The remedy: REPLACE HYDRAULIC UNIT MOUNTING BOLTS.
GENERAL MOTORS CORP.View on NHTSA.gov
87V135000

ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS

Sep 1, 1987
479,715 units potentially affected
The defect: AN IN LINE FUSIBLE LINK MAY MELT DOWN AND CAUSE A FIRE.
The risk: THE IN LINE FUSIBLE LINK LOCATED IN THE AREA OF THEPLASTIC WINDSHIELD WASHER BOTTLE BRACKET MAY, UNDER A HIGH RESISTANCE LOAD,MELT DOWN AND IGNITE THE WASHER BOTTLE BRACKET RESULTING IN AN ENGINECOMPARTMENT FIRE.
The remedy: THE WINDSHIELD WASHER BOTTLE BRACKET WILL BE REPLACED.
GENERAL MOTORS CORP.View on NHTSA.gov
87V093000

SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP

Jun 23, 1987
6,004 units potentially affected
The defect: THE ANTI LOCK BRAKE SYSTEM (ABS) PRESSURE/WARNING SWITCH MAY EXHIBIT BRAKE FLUID SEEPAGE WHICH EVENTUALLY CAN LEAD TO LOSS OF THE BRAKE SYSTEM HYDRAULIC PUMP MOTOR. ADDITIONALLY, THE HYDRAULIC PUMP MOTOR AND ABS ELECTRICAL RELAYS MAY HAVE BEEN EXPOSED TO WATER CONTAMINATION DURING VEHICLE ASSEMBLY. THIS CONDITION CAN CAUSE LOSS OF THE HYDRAULIC PUMP MOTOR AND/OR LOSS OF THE ABS FUNCTION.
The risk: LOSS OF THE HYDRAULIC PUMP MOTOR WOULD RESULT IN A TOTALLOSS OF REAR BRAKES AS WELL AS POWER ASSIST TO THE FRONT BRAKES. THE RED BRAKEWARNING LIGHT WOULD ILLUMINATE AND STAY ON. IF THIS WARNING IS NOT HEEDED, ALOSS OF REAR BRAKES AT A TIME WHEN MINIMUM STOPPING DISTANCE IS REQUIRED COULDRESULT IN A VEHICLE CRASH. AN INOPERATIVE ABS ELECTRICAL RELAY COULD CAUSELOSS OF THE ABS FUNCTION, BUT NORMAL POWER ASSISTED BRAKING WOULD BE RETAINED.THE AMBER ANTI LOCK WARNING LIGHT WOULD ILLUMINATE AND STAY ON.
The remedy: THE ABS AND HYDRAULIC PUMP MOTOR ELECTRICAL RELAYS AND 30 AMP FUSES WILL BE REPLACED. IN ADDITION, THE HYDRAULIC PUMP MOTOR ASSEMBLY AND PRESSURE/WARNING SWITCH WILL BE INSPECTED AND, IF REQUIRED, REPLACED.
GENERAL MOTORS CORP.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

EA90017ClosedEngineering Analysis

BRAKE FAILURE

Opened Mar 26, 1990
Closed Apr 22, 1991

There is no summary currently available

SERVICE BRAKES, HYDRAULIC
PE89171ClosedPreliminary Evaluation

BRAKE FAILURE

Opened Sep 26, 1989
Closed Mar 26, 1990

===

SERVICE BRAKES, HYDRAULIC
EA89028ClosedEngineering Analysis

REAR BRAKE PIN

Opened Jul 28, 1989
Closed Jul 27, 1990

SUMMARY:THESE VEHICLES HAVE REAR DRUM BRAKES.THE PARKING LEVER PIVOTPIN IS HELD BY AN E RING.WHEN THE RING FAILS, PARTS OF THE RING ANDPIN FALL LOOSE INTO THE DRUM AND MAY JAM THE BRAKE, LOCKING THE WHEEL.A STRONGER E RING IS USED IN 1988 AND NEWER CARS.THIS INVESTIGATIONHAS BEEN EXPANDED TO INCLUDE GMS C BODY CARS LISTED ABOVE (E RING COMMONTO ALL CARS SHOWN).===

SERVICE BRAKES, HYDRAULIC
PE89101ClosedPreliminary Evaluation

REAR BRAKE PIN

Opened Mar 15, 1989
Closed Jul 28, 1989

===

SERVICE BRAKES, HYDRAULIC
PE89098ClosedPreliminary Evaluation

ANTI LOCK BRAKES

Opened Mar 10, 1989
Closed May 17, 1989

===

SERVICE BRAKES, HYDRAULIC
C89001ClosedInvestigation

THROTTLE NON-RETURN

Opened Mar 6, 1989
Closed Jan 16, 1990

There is no summary currently available

VEHICLE SPEED CONTROL:LINKAGES

Showing 6 of 9 inquiries on file for this model year, open ones first. Every one of them is listed on NHTSA.gov.

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .