2019 Can-Am Ryker Problems
Owner-reported complaints filed with NHTSA, grouped by component
Data refreshed
What this page shows
Everything below is an owner-reported complaint submitted to NHTSA about the 2019 Can-Am Ryker, grouped by the component NHTSA recorded on the report. These are not confirmed defects, and they are not recalls. NHTSA does not verify most reports before publishing them, and a category with more reports in it is not evidence that a part is defective.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Reports by component
Ranked by how many owner reports name each component category
- Steering1726.2%
- Other / unspecified1523.1%
- Brakes1015.4%
- Driver assistance710.8%
- Electrical710.8%
- Suspension46.2%
- Engine23.1%
- Exterior lighting11.5%
- Powertrain (other)11.5%
- Fuel system11.5%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Each component in detail
What the reports in each category say, in the owners' own words
Steering
Reports naming the steering system — racks, columns, power-steering assist and steering linkage.
From owner reports, verbatim
If you hit a bump the steering will go out of alignment left or right and the direction is different Tight the column if the steering many times tight the was its engineered is too weak
At approximately 5600 miles, my Can-Am Ryker went into limp mode during a ride, limiting my top speed to 50 mph on the highway. This unexpected and sudden occurrence put my safety and the safety of other road users at risk. Request for NHTSA Intervention: I am reaching out to NHTSA to request your immediate intervention in addressing this widespread safety concern with the Can-Am 3-wheel motorcycles manufactured by Can-Am BRP. It is crucial that this matter is investigated thoroughly, and necessary actions are taken to ensure the safety of riders and passengers who are at risk due to the malfunctioning Stability Control System and associated components. I kindly request that NHTSA: Conduct a comprehensive investigation into the safety issue described, including the YAW sensor, SAS system, and Stability Control System of Can-Am. Collaborate with Can-Am BRP to expedite the development and implementation of a reliable and effective solution to rectify the issue, ensuring the safety of riders. Consider issuing a safety recall or other appropriate actions to address the issue in all affected vehicles. The safety of riders and road users is of paramount importance, and I believe that NHTSA's intervention is crucial in ensuring that this issue is resolved promptly. Issue Description: The Stability Control System on my Can-Am 3-wheeler engages during low-speed left turns when it is not required, which leads to significant safety issues. This system does not engage in a similar manner during right turns of comparable speed and sharpness. When the Stability Control System engages on a left turn, power is unexpectedly cut to the rear wheel, and the right brake engages, resulting in a disconcerting "wobble," unsteadiness, and a sensation of jumping. This situation causes extreme unease and creates a sense of losing control over the vehicle.
Other / unspecified
Reports whose component NHTSA recorded as unknown, or that do not map to one of the categories above.
From owner reports, verbatim
Can Am Ryker Wobbly Front and Back Tire/VSS Fault death wobbly VSS63 Code
I reached out to dealer ship and manufacture of my unit, explain to them that my unit has a serious wobble and shuddering skip while making turns in curves. I feel like it about to throw from the unit when it does this. I was told it was a yaw sensors. They would then tell me my bike is fine but it an ongoing issue that they refuse to look into
Brakes
Reports naming service brakes, the antilock braking system, brake hoses, master cylinders or the parking brake.
From owner reports, verbatim
The Stability Control System engages on low speed left turns when it is not required. It does not engage on right turns at similar speed and sharpness of corner. Power is cut to the rear wheel and the right brake engages, causing a "wobble", unsteady, and jumping sensation. This creates unease and the sense of losing control. I've been told this is a common problem that the YAW sensor and sas system is faulting. please get this fixed as it is dangerous.
The vehicle Stability Control System engages on low speed left turns when it is not required. It does not engage on right turns at similar speed and sharpness of corner. Power is cut to the rear wheel and the right brake engages, causing a "wobble", unsteady, and disconcerting sensation. This creates unease and the sense of losing control. Can Am has a service bulletin that may be related to this problem: https://static.nhtsa.gov/odi/tsbs/2020/MC-10181946-0001.pdf They will apply this fix if under warranty, but my warranty has expired. Many people have experienced this or similar problems.
Driver assistance
Reports naming forward-collision avoidance, lane keeping, back-over prevention, cruise control and related electronic driver-assistance systems.
From owner reports, verbatim
The Stability Control System engages on low speed left turns when it is not required. It does not engage on right turns at similar speed and sharpness of corner. Power is cut to the rear wheel and the right brake engages, causing a "wobble", unsteady, and jumping sensation. This creates unease and the sense of losing control. I've been told this is a common problem that the YAW sensor and sas system is faulting. please get this fixed as it is dangerous.
When making a left hand turn, at any speed over 35mph, the rear of the bike wobbles, and the front tires, at least one if not both begin to automatically brake. I’ve looked into it, it appears to be related to a SAS/VSS issue with the suspension and stability having too much play. I’ve researched and found that so many people reported it to NHTSA that you have an article, 137209. They will not fix this issue under recall because they claim it’s not an issue being reported enough. I can’t afford to have this issue that came from factory fixed because they don’t want to fix their issue. This is a major concern, at highway speed on an overpass I experience this issue daily and I’m afraid it’s going to cause an accident, because when it occurs the bike automatically slows 10-15 mph without me hitting the brakes, and I am worried I’m going to get hit by someone because of a defect in their product.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Electrical
Reports naming the electrical system — wiring, battery, charging, control modules, infotainment and electrical accessories.
From owner reports, verbatim
The contact owns a 2019 Can Am Ryker. The contact stated that while making sharp left turns at moderate speeds, the vehicle independently slow downed without warning. The contact stated that the handlebars and the rear tire would vibrate during the failure. Upon investigation, the contact linked the cause of the failure to a defective turn sensor. The contact had taken the vehicle to two dealers for inspection. The manufacturer was notified of the failure. The vehicle was not diagnosed or repaired. The failure mileage was approximately 2,200.
The Stability Control System engages on low speed left turns when it is not required. It does not engage on right turns at similar speed and sharpness of corner. Power is cut to the rear wheel and the right brake engages, causing a "wobble", unsteady, and jumping sensation. This creates unease and the sense of losing control. I've been told this is a common problem that the YAW sensor and sas system is faulting. please get this fixed as it is dangerous.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Suspension
Reports naming suspension components — springs, struts, shocks, control arms and related hardware.
From owner reports, verbatim
When making a left hand turn, at any speed over 35mph, the rear of the bike wobbles, and the front tires, at least one if not both begin to automatically brake. I’ve looked into it, it appears to be related to a SAS/VSS issue with the suspension and stability having too much play. I’ve researched and found that so many people reported it to NHTSA that you have an article, 137209. They will not fix this issue under recall because they claim it’s not an issue being reported enough. I can’t afford to have this issue that came from factory fixed because they don’t want to fix their issue. This is a major concern, at highway speed on an overpass I experience this issue daily and I’m afraid it’s going to cause an accident, because when it occurs the bike automatically slows 10-15 mph without me hitting the brakes, and I am worried I’m going to get hit by someone because of a defect in their product.
Ryker went into limp mode
Too few reports in this category for a page of its own — they appear in the full complaint list.
Engine
Reports naming the engine itself — including stalling, misfires, oil consumption, cooling and internal engine components.
From owner reports, verbatim
the coolant reservoir has started to split at the seam so it leaks coolant.
Making left turns causes vehicle to go into limp mode which makes vehicle lose control! It’s a known issue with rykers that BRP refuses to validate!!! Almost lost control and crashed due to it
Too few reports in this category for a page of its own — they appear in the full complaint list.
Exterior lighting
Reports naming headlights, tail lights, turn signals and other exterior lighting.
From owner reports, verbatim
TL* THE CONTACT OWNS A 2019 CAN-AM RYKER. THE CONTACT STATED THAT THE PASSENGER'S SIDE REAR BRAKE LIGHT WAS INOPERABLE. ADDITIONALLY, THE VEHICLE REAR TAILLIGHTS AND BOTH FRONT HEADLIGHTS HAD WATER INSIDE OF THE HOUSING. THE CONTACT CONTACTED POWER MOTORSPORTS LOCATED AT 333 SW SUBLIMITY BLVD, SUBLIMITY, OR 97385, (503) 769-8888) WHERE A PENDING APPOINTMENT WAS SCHEDULED. THE VEHICLE WAS NOT DIAGNOSED NOR REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 15,000.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Powertrain (other)
Powertrain reports that are not specifically the engine or transmission — driveshafts, axles, transfer cases and differentials.
From owner reports, verbatim
The vehicle Stability Control System engages on low speed left turns when it is not required. It does not engage on right turns at similar speed and sharpness of corner. Power is cut to the rear wheel and the right brake engages, causing a "wobble", unsteady, and disconcerting sensation. This creates unease and the sense of losing control. Can Am has a service bulletin that may be related to this problem: https://static.nhtsa.gov/odi/tsbs/2020/MC-10181946-0001.pdf They will apply this fix if under warranty, but my warranty has expired. Many people have experienced this or similar problems.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Fuel system
Reports naming fuel storage or delivery — tanks, pumps, lines, injectors and fuel leaks.
From owner reports, verbatim
SPITS GASOLINE AND CONTINUE TO READ FUEL FAULT! MY RIGHT WHEEL HAS BEEN MAKING A RATTLE NOISE SINCE THE RECALL INSTALL. BRAKES HAVE MADE NOISE SINCE PURCHASE
Too few reports in this category for a page of its own — they appear in the full complaint list.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — owner-reported complaints and the components recorded on them
Data on this page last refreshed .