It would not downshift or go into reverse. I have to replace the LH Multifunction switch.
- NHTSA ID
- 11582281
- Incident
- Mar 15, 2024
Reports submitted to NHTSA by owners and drivers, shown in full
Data refreshed
Our database holds 5 NHTSA owner-reported complaints for the 2019 Can-Am Spyder F3. Each one is a report filed by an owner or driver and published by NHTSA without most of them being verified. A complaint is not a confirmed defect, not a recall and not a manufacturer bulletin. Narratives are shown exactly as filed.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Showing 1–5 of 5
It would not downshift or go into reverse. I have to replace the LH Multifunction switch.
Front sprocket recall. Original defective sprocket failed at 20,000 miles. The recall replacement sprocket designed to fix the problem Failed at 12,000 miles. BRP Canam Refused to replace failed recall replacement sprocket under that recall And will not provide extended warranty for future pocket failures.
The contact owns a 2019 Can-Am Spyder F3. The contact stated received notification of NHTSA Campaign Number: 22V352000 (Power Train) however, the part to do the recall repair was not yet available. The contact stated that he had called two dealers who stated that parts were not yet available. The vehicle was taken to Daytona Fun Machines Honda Service (450 Ridgewood Ave, Daytona Beach, FL 32117) who stated that the vehicle was safe to drive until the parts became available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact has not experienced a failure. Parts distribution disconnect.
Recall issues for the following vehicle [XXX] 2019 Can Am Spyder F3 have contacted vehicle manufacturer and dealership for an estimate on the repair of this vehicle. Manufacturer and dealership do not have components for this recall and offer no solutions to correct this situation. INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).
Front belt sprocket internal gears were ground away. It didn't allow the engine sprocket to turn the pulley that drives the belt powering the rear tire. Resulted in a loss of propulsion while traveling at 55 MPH making riding to a safe location difficult, had to coast off the roadway. The attached photo is after the sprocket was removed from the bike. The pieces broken along the outside are from a gear puller during removal. The sprocket would only free spin making removal extremely difficult.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Data on this page last refreshed .