2026 Chrysler Pacifica Problems

I was traveling on the DC beltway (interstate), it was raining and the temp was in the low 50s. The vehicle in front of me hit their brakes pretty hard. I started braking firmly myself. I heard an alarm sound and I believe the anti-lock braking activated, and the van began automatically braking itself. I was brought to a complete stop on the interstate by the van. The vehicle ahead of me accelerated again and I stepped on the gas to get going again and it wouldn't move. At all. I kept pressing on the gas to get going and the van wouldn't move. Meanwhile traffic behind me is gaining on me and I was rear-ended. After being hit I tried to move it out of the travel lane and it still wouldn't move. After all that I looked at the dash and it said to move forward, release the electronic parking brake (or something to that effect). I pushed the button to turn it off, and was able to get onto the shoulder. I believe the root cause of the crash was that the van automatically turned on the parking brake on it's own, and I did not want it on. If it hadn't, I could've accelerated away and not gotten rear-ended.

The contact owns a 2026 Chrysler Pacifica. The contact stated that while driving at an undisclosed speed, several unknown warning lights were illuminated. The contact stated that while the vehicle was parked, the parking brake independently enabled and caused the battery to drain. Roadside Assistance was contacted. The Roadside Assistance driver recharged the battery. The vehicle was taken to the dealer, where it was diagnosed with battery failure. The contact was informed that both batteries needed to be replaced. The vehicle was repaired; however, the failure reoccurred. The contact was informed that further diagnostic testing was needed. The vehicle was scheduled for an upcoming diagnostic test. The manufacturer was made aware of the failure, and a case was filed. The failure mileage was approximately 700.

I was traveling on the DC beltway (interstate), it was raining and the temp was in the low 50s. The vehicle in front of me hit their brakes pretty hard. I started braking firmly myself. I heard an alarm sound and I believe the anti-lock braking activated, and the van began automatically braking itself. I was brought to a complete stop on the interstate by the van. The vehicle ahead of me accelerated again and I stepped on the gas to get going again and it wouldn't move. At all. I kept pressing on the gas to get going and the van wouldn't move. Meanwhile traffic behind me is gaining on me and I was rear-ended. After being hit I tried to move it out of the travel lane and it still wouldn't move. After all that I looked at the dash and it said to move forward, release the electronic parking brake (or something to that effect). I pushed the button to turn it off, and was able to get onto the shoulder. I believe the root cause of the crash was that the van automatically turned on the parking brake on it's own, and I did not want it on. If it hadn't, I could've accelerated away and not gotten rear-ended.

The contact owns a 2026 Chrysler Pacifica. The contact stated that while driving 5-10 MPH, the brakes locked up. The contact stated that the parking brake unexpectedly engaged and failed to release. The driver’s side rear wheel locked up. The check engine warning light was illuminated. The vehicle was towed to the local dealer, where it was diagnosed and determined that the brake actuator needed to be replaced. The vehicle was repaired, but the failure recurred. While driving in the driveway, the brakes locked up. The vehicle was taken to the dealer again, where the ABS module was replaced. Additionally, there was an engine malfunction, and the battery was recharged. The manufacturer was contacted and opened a case. The contact requested a vehicle buyback. The failure mileage was approximately 5,000.

Driving down a busy section of highway on I-25 in Colorado, without warning car lost all power and shutoff. Was able to veer off highway to shoulder without getting hit. Car will not restart. This was incredibly unsettling as my family and kids were all in the car on the way home and was a very dangerous situation. For a brand new vehicle to shut off on the highway without warning is unacceptable.

The contact owns a 2026 Chrysler Pacifica. The contact stated that while driving 5-10 MPH, the brakes locked up. The contact stated that the parking brake unexpectedly engaged and failed to release. The driver’s side rear wheel locked up. The check engine warning light was illuminated. The vehicle was towed to the local dealer, where it was diagnosed and determined that the brake actuator needed to be replaced. The vehicle was repaired, but the failure recurred. While driving in the driveway, the brakes locked up. The vehicle was taken to the dealer again, where the ABS module was replaced. Additionally, there was an engine malfunction, and the battery was recharged. The manufacturer was contacted and opened a case. The contact requested a vehicle buyback. The failure mileage was approximately 5,000.

Driving down a busy section of highway on I-25 in Colorado, without warning car lost all power and shutoff. Was able to veer off highway to shoulder without getting hit. Car will not restart. This was incredibly unsettling as my family and kids were all in the car on the way home and was a very dangerous situation. For a brand new vehicle to shut off on the highway without warning is unacceptable.

The contact owns a 2026 Chrysler Pacifica. The contact received notification of NHTSA Campaign Number: 26V189000 (Air Bags). The vehicle was taken to the dealer, and the contact was informed that the parts were ordered. The contact stated that parts were ordered two months ago, and the parts had not yet been delivered. The manufacturer was made aware of the issue, and a case was filed. The contact had not experienced a failure.

The contact's mother owns a 2026 Chrysler Pacifica. The contact stated that while his mother was driving 30-35 MPH on a well-maintained road, the front passenger's side of the vehicle suddenly lowered, and the driver lost control of the steering wheel, causing the rear passenger's side of the vehicle to strike a curb, and the vehicle was pushed towards the left, near oncoming traffic. The contact stated that the vehicle nearly rolled over prior to coming to a stop. The driver was able to exit the vehicle. A Police Officer arrived at the scene and redirected traffic away from the vehicle, but no Police report was filed. There was no injury sustained. The contact stated that upon meeting his mother at the scene, the contact inspected the vehicle. The contact noticed that the front passenger's side lower control arm ball joint had fractured sharply, separated, and had gone sideways. The vehicle was towed to an Auto Collision repair shop. The dealer was notified of the failure and reported the failure to a Chrysler regional manager. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure and referred the contact to the dealer for assistance. The failure mileage was approximately 1,173.

I was traveling on the DC beltway (interstate), it was raining and the temp was in the low 50s. The vehicle in front of me hit their brakes pretty hard. I started braking firmly myself. I heard an alarm sound and I believe the anti-lock braking activated, and the van began automatically braking itself. I was brought to a complete stop on the interstate by the van. The vehicle ahead of me accelerated again and I stepped on the gas to get going again and it wouldn't move. At all. I kept pressing on the gas to get going and the van wouldn't move. Meanwhile traffic behind me is gaining on me and I was rear-ended. After being hit I tried to move it out of the travel lane and it still wouldn't move. After all that I looked at the dash and it said to move forward, release the electronic parking brake (or something to that effect). I pushed the button to turn it off, and was able to get onto the shoulder. I believe the root cause of the crash was that the van automatically turned on the parking brake on it's own, and I did not want it on. If it hadn't, I could've accelerated away and not gotten rear-ended.

We were stopped for fuel. Prior to fueling we turned off the engine and opened the fuel door, inserting the gas nozzle and then began to pump fuel. While the nozzle was running, a passenger opened the sliding door by pressing the auto open button - and the door slid into the hand of the individual holding the fuel nozzle, crushing his hand between the door and the nozzle - causing the nozzle to dislodge from the filling neck , releasing gasoline all over the driver and j hiring his hand. There is no interlock preventing the door from auto opening while the fuel tank is open - which is a critical design flaw, that can result in injury to the individual fueling and hazardous material spills/ hazardous conditions where the pump attendant is directly drenched in fuel. A simple sensor on the door with a software interlock would resolve this issue and prevent future instances. In this case the injury was minor/bruise and discomfort, but it could have been more severe had the driver not reacted quickly, or had the driver had underlying medical conditions such as brittle bones or was on blood thinners.