RoadVitals

2002 Crane LET2

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
3
Latest Feb 1, 2008
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 2002 Crane LET2. 3 safety recalls have been issued covering this model year.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

3 campaigns cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
08V049000

SERVICE BRAKES, AIR

Feb 1, 2008
672 units potentially affected
The defect: CRANE CARRIER IS RECALLING 672 MY 1999-2001 COE,MY 1999-2002 LDT, MY 2001-2007 LDT2, MY 1998-2003 LET, AND MY 2001-2007 LET2 REFUSE CAB AND CHASSIS FOR FAILING TO COMPLY WITH THE BRAKE RELEASE TIMING REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS." THE BRAKE RELEASE TIMING WAS SLOWER THAN REQUIRED.
The risk: THIS STANDARD SPECIFIES PERFORMANCE AND EQUIPMENT REQUIREMENTS FOR VEHICLES EQUIPPED WITH AIR BRAKE SYSTEMS, INCLUDING AIR-OVER-HYDRAULIC BRAKE SYSTEMS, TO ENSURE SAFE BRAKING PERFORMANCE UNDER NORMAL AND EMERGENCY CONDITIONS.
The remedy: CRANE WILL REPLACE SEVERAL FITTINGS AND HOSES WHICH WILL INCREASE THE AIR FLOW AND SUBSEQUENTLY IMPROVE THE BRAKE RELEASE TIMING. THE RECALL BEGAN ON MARCH 14, 2008. OWNERS MAY CONTACT CRANE CARRIER AT 918-832-7305.
CRANE CARRIER COMPANYView on NHTSA.gov
03V167000

SERVICE BRAKES, AIR:SLACK ADJUSTERS:AUTOMATIC

May 1, 2003
130 units potentially affected
The defect: ON CERTAIN TRAILERS EQUIPPED WITH A SPECIFIC COMBINATION OF REYCO SUSPENSION, EATON DRIVE AXLE, AND BENDIX SLACK ADJUSTERS, THE FAILURE OF A DRIVE AXLE SLACK ADJUSTER TO AUTOMATICALLY ADJUST AS REQUIRED TO COMPENSATE FOR BRAKE WEAR, WILL CAUSE AN OUT OF ADJUSTMENT CONDITION. IF THIS CONDITION OCCURS AND IS NOT IDENTIFIED AND CORRECTED THROUGH NORMAL INSPECTIONS AND MAINTENANCE, THE SLACK ADJUSTER WILL OVER-ROTATE AND MAY CONTACT THE SUSPENSION LOWER SPRING SADDLE.
The risk: IF THIS OCCURS, BRAKING PERFORMANCE WILL BE INHIBITED, INCREASING THE RISK OF A CRASH WITHOUT WARNING.
The remedy: CRANE CARRIER WILL SUPPLY, AT NO CHARGE, GUNITE SLACK ADJUSTERS AND INSTALLATION INSTRUCTIONS TO REPLACE THE EXISTING BENDIX SLACK ADJUSTERS ON THE DRIVE AXLE. THE INSTALLING FACILITY WILL BE REIMBURSED BY CRANE FOR ONE (1) HOUR LABOR PER VEHICLE AT THEIR POSTED LABOR RATE. OWNER NOTIFICATION BEGAN ON JUNE 10, 2003. OWNERS SHOULD CONTACT CRANE AT 1-918-832-7305.
CRANE CARRIER COMPANYView on NHTSA.gov
02V231000

EQUIPMENT:OTHER:LABELS

Sep 5, 2002
86 units potentially affected
The defect: ON CERTAIN TAG AND PUSHER AXLE ASSEMBLIES PURCHASED FROM RIDEWELL, THE AXLE ASSEMBLIES HAVE AN ACTUAL WEIGHT RATING LESS THAN THAT SPECIFIED ON THE LABEL AND THEREFORE FAIL TO COMPLY WITH THE REQUIREMENTS OF PART 567.5, "CERTIFICATION."
The risk: LOADING THE TAG/PUSHER AXLE TO THE GAWR LABEL RATING OR LOADING THE VEHICLE TO THE GVWR LABEL RATING WILL CAUSE THE PUSHER/TAG AXLE TO BE OVERLOADED.
The remedy: CRANE WILL PROVIDE OWNERS WITH REPLACEMENT VEHICLE CERTIFICATION LABELS AND INSTALLATION INSTRUCTIONS. OWNER NOTIFICATION BEGAN OCTOBER 4, 2002. OWNERS WHO DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CRANE AT 1-918-832-7333.
CRANE CARRIER COMPANYView on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Compare model years

Complaint and recall counts across every year of this model

Crane LET2 by model year
YearComplaintsRecallsInvestigationsIssue Index
2022010—
2020030—
2019010—
2016010—
2015020—
2014020—
2013030—
2012020—
2011030—
2010030—
2009030—
2008030—
2007030—
2006010—
2005030—
2004020—
2003040—
2002Viewing030—
2001030—
2000020—
1999010—
1998010—
1997010—
1996010—

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.