Owner-reported complaints naming the powertrain system, filed with NHTSA
Data refreshed
Powertrain reports that are not specifically the engine or transmission — driveshafts, axles, transfer cases and differentials. Every record below is an owner-reported complaint about the 1998 Dodge Ram 2500 submitted to NHTSA — not a confirmed defect, not a recall and not a manufacturer bulletin. 8 reports on file name it.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Shown in the owner’s own words, exactly as filed
I WAS PULLING A CAR FROM INDIO CA TO PHX. AZ WHEN IT STARTED TICKING AND SMOKEING AND LOST POWER I PULLEDOVER CHECKED THE OIL AND IT WAS 2 QUARTS LOW IT HAD NEVER USED OIL BEFORE THIS IT NEVER GOT HOT THOUGH I SLOWED WAY DOWN AND BARELY MADE IT HOME.
I OWN A 1998 DODGE RAM 2500, I HAVE NOTICED THIS PROBLEM ON MULTIPLE DODGES AND READ ABOUT IT ON THE INTERNET, THE FRONT LOWER AXLE MOUNT ROTS OUT DUE TO POOR DESIGN LEAVING NOTHING TO HOLD THE SPRING IN PLACE MY COIL MOUNT IS ROTTED OUT AND THERE IS BARELY ANY LEFT OF IT, AND DODGE NOR DO ANY AUTO PART STORES SELL COIL MOUNTS TO REPLACE IT THE MOUNT IS WELDED DIRECTLY ON THE AXLE SO THE AXLE HOUSING WOULD NEED TO BE REPLACED, THIS IS VERY UNSAFE IF THE AXLE WERE TO GIVE OUT DEW TO THIS. *TR
EVENT: PULLED UP IN FRONT OF BARN TO GET A LOAD OF HAY. MOVED GEAR SELECTOR LEVER TO REVERSE TO BACK UP TO BUILDING, BUT WHEN ACCELERATOR WAS PRESSED, VEHICLE MOVED FORWARD. FAILURE: INTERNAL PARTS IN STEERING COLUMN HAD BECOME DISCONNECTED FROM EACH OTHER, THE RESULT BEING THAT MOVEMENT OF THE GEAR SELECTOR LEVER DID NOT AFFECT THE LEVER AT THE END OF THE STEERING COLUMN THAT IS CONNECTED TO THE TRANSMISSION CONTROL ROD. THE ONLY WAY THAT THE VEHICLE COULD BE PLACED IN PARK, STARTED, OR PUT INTO A GEAR POSITION WAS TO RAISE THE HOOD AND MOVE THE TRANSMISSION CONTROL ROD BY HAND. SOLUTION: SINCE THE STEERING COLUMN IS A WELDED ASSEMBLY AND IS NOT SERVICEABLE, IT WAS REPLACED. THE OLD ASSEMBLY IS AVAILABLE FOR INSPECTION. THE ASSEMBLY PART NUMBER IS P55351175 RELATED COMPLAINT: SIMILAR TO COMPLAINT ODI ID 892310 WHICH WAS ENTERED AS A PROBLEM WITH COMPONENT : POWERTRAIN: AUTOMATIC TRANSMISSION: P/N START SWITCH. MY PROBLEM WOULD HAVE MANIFESTED ITSELF IN THE SAME WAY IF I HAD PLACED THE SHIFT LEVER INTO PARK POSITION AND HAD GOTTEN OUT OF THE VEHICLE WITHOUT SETTING THE BRAKE. *TR
THE GEAR SHIFTED OUT OF DRIVE WHEN THE VEHICLE WENT OVER A BUMP.*JB
WHEN BACKING UP A CLUNKING NOISE EMITTED FROM DIFFERENTAL. DEALER REPLACED FLUID AND ADDED SOME "ADDITIVE". DID NOT CORRECT PROBLEM. THEY KEPT TRUCK TO DISASSEMBLE DIFFERENTAL, FOUND NOTHING AMISS, REPLACED FLUID AND ADDITIVE. AT THIS TIME, ALL SEEMS OK. THE COST WAS $83.90. WHEN THEY DECIDED TO KEEP THE TRUCK OVER NIGHT THEY THOUGHT IT WOULD BE COVERED UNDER WARRANTY. HOWEVER, IT WAS OUT OF POCKET EXPENSE.*AK
THE PASSENGER SIDE SEAT BELT LOCKED UP, THE DEALER FOUND THAT THE SEAT BELT SOLENOID SHORTED OUT. *SLC
AXLE DESIGNED TO LEAK GREASE EXCESSIVELY. YH
WINDSHIELD WIPERS ASSEMBLY FAILED CAUSING THE WIPER ARM ASSEMBLY TO POP OFF. MJS
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Categories with enough reports to have a page of their own
Data on this page last refreshed .