RoadVitals

1991 Eagle Premier Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
7
Newest Jan 12, 1998
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
5 investigations on file

Recall campaigns

7 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:ROTOR

Jan 12, 1998
293,369 units potentially affected
The defect: VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR.
The risk: THE REDUCED STRENGTH CAN ALLOW THE CAST IRON WEAR SURFACE TO SEPARATE FROM THE HUB, REDUCING THE BRAKE EFFECTIVENESS OF THE VEHICLE.
The remedy: DEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.
CHRYSLER CORPORATIONView on NHTSA.gov

SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP

Jun 13, 1996
321,000 units potentially affected
The defect: THE ABS HYDRAULIC CONTROL UNIT CAN EXPERIENCE EXCESSIVE BRAKE ACTUATOR PISTON SEAL WEAR CAUSING PUMP-MOTOR DETERIORATION.
The risk: IF THIS CONDITION OCCURS, THE ABS FUNCTION COULD BE LOST AND REDUCED POWER ASSIST WOULD BE EXPERIENCED DURING VEHICLE BRAKING INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.
The remedy: DEALERS WILL TEST THE VEHICLE'S ANTI-LOCK BRAKE SYSTEM AND REPAIR THE VEHICLES IF NECESSARY. ALSO THE WARRANTY ON ALL ABS COMPONENTS WILL BE EXTENDED TO 10 YEARS OR 100,000 MILES (EXCEPT FOR THE BRAKE ACTUATOR PISTON ASSEMBLY AND THE PUMP-MOTOR ASSEMBLY WHICH WILL HAVE A LIFETIME COVERAGE). OWNERS WILL ALSO BE REIMBURSED FOR PREVIOUS ABS COMPONENT REPAIR COSTS.
CHRYSLER CORPORATIONManufacturer number 685View on NHTSA.gov

SEAT BELTS:FRONT:ANCHORAGE

Nov 7, 1995
90,000 units potentially affected
The defect: THE AUTOMATIC SHOULDER BELT SYSTEMS CAN MALFUNCTION AND BECOME INOPERATIVE.
The risk: THE LACK OF PASSIVE RESTRAINTS COULD INCREASE THE RISK OF PERSONAL INJURY IN THE EVENT OF A VEHICLE COLLISION.
The remedy: DEALERS WILL REPLACE THE SYSTEM TRACK AND DRIVE ASSEMBLY ON AUTOMATIC SHOULDER BELT SYSTEMS WHICH ARE CURRENTLY INOPERATIVE AND THOSE SYSTEMS WHEN THEY BECOME INOPERATIVE IN THE FUTURE.
CHRYSLER CORPORATIONView on NHTSA.gov

VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:HEATER CORE

Jan 11, 1994
125,000 units potentially affected
The defect: THE END CAP CONNECTING THE HEAT EXCHANGER'S CORE TO THE ENGINE COOLING SYSTEM COULD RUPTURE AND ALLOW HOT COOLANT TO ESCAPE INTO THE PASSENGER COMPARTMENT.
The risk: THE COOLANT ESCAPING INTO THE PASSENGER COMPARTMENT COULD CONTACT THE DRIVER'S FEET AND INJURE THE DRIVER. ALSO, STEAM FROM THE HEATER LIQUID WILL CLOUD ON THE WINDOW SURFACES AND IMPAIR THE DRIVER'S VISION. IN EITHER CASE, FAILURE OF THE HEATER CORE END CAP COULD RESULT IN A VEHICLE ACCIDENT.
The remedy: A COOLANT TEMPERATURE CONTROLLED HEATER CORE FLUID BYPASS VALVE WILL BE INSTALLED.
CHRYSLER CORPORATIONView on NHTSA.gov

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS

Nov 1, 1991
80,000 units potentially affected
The defect: THE ANTI-LOCK BRAKE SYSTEM HIGH PRESSURE HOSE MAY LEAK OR DETACH AT ITS CRIMPED END FITTING RESULTING IN THE DISCHARGE OF HYDRAULIC FLUID.
The risk: FLUID DISCHARGE EVENTUALLY CAUSES THE LOSS OF BOTH THEANTI-LOCK BRAKE SYSTEM AND HYDRAULIC ASSIST FOR THE BRAKE SYSTEM, RESULTING ININCREASED LIKELIHOOD OF BRAKE LOCKUP AND INCREASED STOPPING DISTANCES, WHICHCOULD RESULT IN A VEHICLE ACCIDENT.
The remedy: REPLACE THE ABS HIGH PRESSURE HOSE WITH A HOSE OF DIFFERENT DESIGN AND CONSTRUCTION.
CHRYSLER CORPORATIONView on NHTSA.gov

ELECTRICAL SYSTEM:12V/24V/48V BATTERY

Mar 11, 1991
5,500 units potentially affected
The defect: ROUTING OF BATTERY MAIN FEED WIRING MAY ALLOW IT TO CONTACT THE AIR CLEANER BRACKET AND CONTNUED CONTACT MAY LEAD TO AN ELECTRICAL SHORT CIRCUIT.
The risk: THE ELECTRICAL SHORT CAUSED BY CONTINUOUS CONTACT COULDRESULT IN THE IGNITION OF THE WIRING INSULATION, AND AN UNDERHOOD FIRE.
The remedy: THE MAIN FEED ON ALL INVOLVED VEHICLES WILL BE REROUTED AND SECURED WITH TIE STRAPS AWAY FROM THE AIR CLEANER BRACKET.
CHRYSLER CORPORATIONView on NHTSA.gov

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS

Feb 13, 1991
76,000 units potentially affected
The defect: REAR BRAKE TUBE ROUTING IS CONTACTED BY FUEL TANK HEAT SHIELD WHEN SUSPENSION IS IN FULL JOUNCE POSITION. THIS DAMAGES THE BRAKE FLUID TUBE, CAUSING A LEAK.
The risk: LOSS OF FLUID FROM HALF OF THE DIAGONALLY SPLIT BRAKEHYDRAULIC SYSTEM AFFECTS BRAKING CAPABILITY, WHICH COULD RESULT IN AN ACCIDENT.
The remedy: MODIFY HEAT SHIELD TO ELIMINATE POTENTIAL FOR SHIELD CONTACTING BRAKE TUBE.
CHRYSLER CORPORATIONView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

EA97001ClosedEngineering Analysis

BRAKE DISC/HUB SEPARATION

Opened Jan 13, 1997
Closed Jan 9, 1998

CONSUMER COMPLAINTS INDICATE THAT CORROSION OF THE BRAKE ROTORS HAVE CAUSED SEPARATION OF THE BRAKE DISC FROM ITS HUB, RESULTING IN BRAKE FAILURE.

SERVICE BRAKES, HYDRAULICLed to recall 98V005000
PE96053ClosedPreliminary Evaluation

BRAKE DISC/HUB SEPARATION

Opened Sep 5, 1996
Closed Jan 13, 1997

consumer complaints indicate that corrosion of hte brake rotors have caused separation of the brake disc from its hub, resulting in brake failure.

SERVICE BRAKES, HYDRAULIC
EA95016ClosedEngineering Analysis

ABS BRAKING MALFUNCTION

Opened May 26, 1995
Closed Jun 24, 1996

There is no summary currently available

SERVICE BRAKES, HYDRAULICLed to recall 96V099000
PE94027ClosedPreliminary Evaluation

AUTO SHOULDER BELT FAILS

Opened Mar 18, 1994
Closed Jul 29, 1994

There is no summary currently available

SEAT BELTS
PE92086ClosedPreliminary Evaluation

ENGINE COMPARTMENT FIRES

Opened Nov 25, 1992
Closed Mar 31, 1993

There is no summary currently available

ENGINE AND ENGINE COOLING

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .