2017 Ferrari 488 Gtb

From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at www.nhtsa.gov/sites/nhtsa.gov/files/documents/expert_report-hrblomquist.pdf.Consequently, all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see nhtsa.gov/recalls?nhtsaId=EA21002 -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.

Headliner is sagging and this is causing sun visor to come down thus affecting visibility of the driver. this problem is very common on this model and causing a safety issue.

NHTSA ID

11490055

Incident

Oct 19, 2022

On Sunday Sept 4th, while attending an Edge Addicts track day event at Circuit of the Americas in Austin, My 2017 488 Was parts of the run group, 2 laps were completed prior to the brake pedal failing completely to the floor and causing my driver to loose all braking capability and slamming into a wall. We have in car video from Go Pro footage, footage from another vehicle from behind my 488 and also footage from the control room of the track. This vehicle was purchased 3 months ago, the brake fluid is at the correct level and the new "Recalled" Brake fluid cap is installed. There is some sort of serious manufacturing defect with this system, this is a car designed for this type of use. This needs a serious investigation before others are hurt or killed.

NHTSA ID

11482908

Incident

Sep 4, 2022

Mileage

12,000 mi

IN APRIL OF THIS YEAR WE RECEIVED NOTICE OF AN AIRBAG RECALL. THE NOTICED MENTIONS PARTS ARE AVAILABLE. WE TRIED TO MAKE AN APPOINTMENT WITH OUR DEALER BUT THEY MENTIONED THE PARTS WERE NOT AVAILABLE. WE HAVE FOLLOWED UP WITH THE DEALER SEVERAL TIMES TO NO AVAIL. WE CONTACT FERRARI USA CUSTOMER SERVICE AN THEY ONLY MENTIONED THEY WOULD LOOK INTO THE SITUATION BUT NO FURTHER INFORMATION IS AVAILABLE. I BELIEVE THIS IS VERY POOR AS IT A SAFETY CONCERN THAT IS NOT BEING GIVEN ANY REAL PRIORITY. THE MANUFACTURE CONTINUES TO LAUNCH CARS THIS YEAR YET OUR PASSENGERS ARE NOT SAFE. THIS DEPARTMENT IS OUR LAST CHANCE AT TRYING TO KEEP OUR PASSENGERS SAFE IN A MOTOR VEHICLE THAT HAS A KNOWN DEFECT.

NHTSA ID

11280294

Incident

Apr 8, 2019

Mileage

1,240 mi

THE BRAKING SYSTEM HAS LOCKED THE BRAKES BY ITSELF WITHOUT ANY USER INPUT OR PRESSING OF THE BRAKE PEDAL. THIS HAS OCCURRED 3X, THE FIRST 2 WHILE THE CAR WAS MOVING, THE LAST WHILE IT WAS PARKED IN A GARAGE, THE 1ST AND 3RD TIMES RENDERED THE CAR IMMOVABLE, THE 2ND WAS MOVABLE AFTER A RESTART. TWICE THE CAR NEEDED TO BE TOWED TO THE DEALER, WHO HAS BEEN UNABLE TO DUPLICATE THE PROBLEM THUS UNABLE TO FIX IT. THE 3X HAVE OCCURRED IN ~3K MILES, THE 1ST AT ~1850 MILES. THE FIRST REPAIR ATTEMPT INVOLVED REPLACING THE BRAKING SYSTEM ECU AND A BRAKE PEDAL SWITCH, PERFORMED AS A "SHOTGUN" APPROACH SINCE NO CAUSE COULD BE DETERMINED. THE 2ND AND 3RD ATTEMPTS INVOLVED FERRARI WASHING THEIR HANDS OF THE PROBLEM. I FILED TO LEMON LAW THE CAR, AND FERRARI MAINTAINS THERE IS NOTHING WRONG WITH IT AFTER THE FIRST "FIX", WHICH IS CLEARLY ABSURD DUE TO THE 2ND AND 3RD OCCURRENCES. ASKING ONLINE IN A FERRARI FORUM PRODUCED ONLY ONE PERSON SAYING THE SAME PROBLEM OCCURRED IN THEIR CLOSE-TO-IDENTICAL FERRARI CAR , WHICH PRESUMABLY SHARES A VERY SIMILAR IF NOT IDENTICAL BRAKING SYSTEM. THE CAR HAS AN UNUSUAL "HILL-HOLDER" FEATURE WHICH ENGAGES EVEN WHILE ON FLAT GROUND, AND IT IS THIS WHICH I BELIEVE TO BE MALFUNCTIONING. THE INABILITY TO MOVE A CAR THAT HAS SUDDENLY AND WITHOUT WARNING LOCKED ITS BRAKES AND BROUGHT THE CAR TO A STOP IS NOT ONLY FRIGHTENING, BUT IS POTENTIALLY LETHAL.

NHTSA ID

11112925

Incident

May 25, 2017

Mileage

1,850 mi

Recall 78 Customer Acknowledgement -- We are informing the customer that if any aftermarket components or modifications are present on the vehicle that it may hinder the software installation necessary for Recall C24000078 and normal operation of the instrument cluster.

Replacing CCP pressure sensors

Ferrari Predictive Maintenance – Incompletely compiled Ferrari Next documents

2020 Technical Documentation Update (No. 02)

2019 Technical Documentation Update (No. 10)

Ferrari Predictive Maintenance - Intervals and deadlines for scheduled maintenance activities