RoadVitals

1990 Ford Crown Victoria Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
3
Newest Dec 16, 1998
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
3 investigations on file

Recall campaigns

3 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

98V322000

SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT

Dec 16, 1998
175,000 units potentially affected
The defect: VEHICLE DESCRIPTION: CERTAIN 1996-1999 FORD CROWN VICTORIA POLICE, FLEET, NATURAL GAS, AND 1996-1999 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT WERE PRODUCED WITH A LOWER CONTROL ARM BALL JOINT CONTAINING A ONE PIECE BEARING; AND 1990-1996 FORD CROWN VICTORIA POLICE, FLEET, AND NGV VEHICLES AND 1990-1996 LINCOLN TOWN CAR LIMOUSINE VEHICLES THAT HAVE BEEN SERVICED WITH EITHER A BALL JOINT CONTAINING THE ONE-PIECE BEARING OR A FRONT LOWER CONTROL ARM CONTAINING A BALL JOINT WITH A ONE-PIECE BEARING. THE ONE-PIECE BEARING WITHIN THE LOWER CONTROL ARM BALL JOINT CAN WEAKEN SLOWLY DURING USE AND EVENTUALLY CRACK. THIS COULD RESULT IN SEPARATION OF THE BALL AND CAP OF THE JOINT, ALLOWING THE CONTROL ARM TO DROP TO THE GROUND.
The risk: IF THIS OCCURS WHILE THE VEHICLE IS MOVING, REDUCED STEERING CONTROL COULD OCCUR, INCREASING THE RISK OF A CRASH.
The remedy: DEALERS WILL REPLACE THE LOWER CONTROL ARM BALL JOINTS (2).
FORD MOTOR COMPANYManufacturer number 98S37View on NHTSA.gov
92V075000

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS

May 19, 1992
25,000 units potentially affected
The defect: THE REAR BRAKE LINES HAVE INADEQUATE CLEARANCE BETWEEN THE BRAKE TUBE AND THE VEHICLE UNDERBODY IN THE AREA OF THE LEFT REAR WHEEL OPENING.
The risk: INADEQUATE CLEARANCE CAN CAUSE ABRASION OF THE BRAKE LINEAND A LEAK CAN DEVELOP, RESULTING IN LOSS OF BRAKE FLUID TO THE REAR BRAKESYSTEM AND INCREASED STOPPING DISTANCES.
The remedy: REPAIR ANY BRAKE LINES THAT HAVE AN INDICATION OF CONTACT OR HAVE THE POTENTIAL FOR CONTACT WITH THE BODY OF THE VEHICLE. RELOCATE LINES, IF NECESSARY.
FORD MOTOR COMPANYView on NHTSA.gov
90E043001

AIR BAGS:FRONTAL

Oct 30, 1990
172,000 units potentially affected
The defect: THREADED INFLATOR COMPONENTS MAY HAVE BEEN DAMAGED DURING ASSEMBLY WHICH MAY ALLOW COMPONENTS TO SEPARATE WHEN INFLATOR RECEIVES A SIGNAL TO DEPLOY THE AIR BAG.
The risk: INFLATOR COMPONENT SEPARATION ALLOWS HOT COMBUSTION GASES TO ESCAPE INTO THE PASSENGER COMPARTMENT WHICH COULD RESULT IN INJURIES TO VEHICLE OCCUPANTS.
The remedy: REPLACE AIR BAG MODULES CONTAINING POTENTIALLY DEFECTIVE INFLATORS.
FORD MOTOR COMPANYView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

PE92069ClosedPreliminary Evaluation

STEERING COLUMN FIRES

Opened Aug 3, 1992
Closed Nov 30, 1992

There is no summary currently available

STEERING
EA92002ClosedEngineering Analysis

BRAKE LINE PUNCTURES

Opened Jan 15, 1992
Closed May 21, 1992

There is no summary currently available

SERVICE BRAKES, HYDRAULICLed to recall 92V075000
PE91125ClosedPreliminary Evaluation

BRAKE LINE PUNCTURES

Opened Sep 11, 1991
Closed Jan 15, 1992

There is no summary currently available

SERVICE BRAKES, HYDRAULIC

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .