2020 Ford Explorer Recalls

On September 23, 2020, Ford Motor Company (Ford) filed a noncompliance recall report under 49 CFR Part 573 (NHTSA Recall No. 20V-575), recalling 620,246 Model Year (MY) 2020 Ford F-150, F-250, F-350, F-450, F-550, Explorer, Mustang, Transit, Expedition, Escape, Ranger and Edge, and Lincoln Nautilus and Corsair vehicles for a noncompliance with Federal Motor Vehicle Safety Standard (FMVSS) 111, Rear Visibility. Ford's recall described the noncompliance as insufficient electrical conductivity within the printed circuit board (PCB) internal to the camera leading to intermittent rearview camera operation. The supplier of the cameras was Magna Electronics.According to Ford's chronology in the Part 573, during the period February-April 2020, Ford identified and monitored warranty claims pertaining to intermittent or inoperative rearview cameras. Ford reviewed supplier product changes, focusing on changes introduced by the supplier in the October-November 2019 time frame. The Part 573 stated that the issue was brought to Ford's Critical Concerns Review Group (CCRG) for review on May 12, 2020.On July 7, 2020, NHTSA's Vehicle Research and Testing Center (VRTC) informed the Office of Defects Investigation (ODI) of a trend of MY 2020 Escape vehicles with rearview camera malfunctions. ODI contacted Ford the next day, providing five Vehicle Owner Questionnaires (VOQs) alleging inoperative rearview cameras. On July 15, 2020, Ford met with NHTSA to discuss the rearview camera issue. In a subsequent August 24, 2020 meeting, ODI and NHTSA's Office of Vehicle Safety Compliance (OVSC) met with Ford to discuss the recall status and additional VOQs. Ford presented rate and scope data for many of its MY 2020 products during the August 2020 meeting indicating high failure rates for certain models.This RQ is being opened to investigate both the timeliness and scope of Ford's rearview camera recall (20V-575), and Ford's compliance with reporting requirements.The subject reports referenced in the opening resume are identified by the following ODI reference numbers which can be reviewed at NHTSA.gov: 11349813, 11344126, 11342696, 11341486, 11340254, 11337274, 11331444, 11330875, 11329235, 11316960, 11343521, 11341884, 11337226, 11344018, and 11339573.

The Office of Defects Investigation (ODI) received a petition on August 22, 2025, requesting a defect investigation into an alleged defect of the “underbody shields” on model year (MY) 2020 Ford Explorer vehicles. The petition alleges premature degradation and detachment of the plastic underbody shields, potentially leading to road debris. The petition itself can be reviewed at NHTSA.gov under ODI number 11682326. A search of the subject vehicle population was undertaken using complaints submitted to ODI. No related complaints were found in NHTSA’s database for the subject vehicle population. Subsequently, ODI conducted a broader search for related complaints and field reports involving MY 2020-2025 Ford Explorer and Lincoln Aviator models, as these vehicles utilize substantially similar underbody shields. No complaints or reports were found citing any allegations pertaining to any of the underbody shields. ODI also reviewed manufacturer information and data and did not identify a trend related to the Petitioner’s allegations. Based on the absence of consumer complaints and reports, ODI has not identified a material risk of a complete detachment or a projectile hazard related to this condition. The petitioner's description of detectable symptoms - including noise and vibration that progressively worsen and visible sagging of the shields underneath the vehicle - indicates a failure mode that provides drivers with ample notice to seek service before a potential detachment. In view of the insufficient evidence of a vehicle-based defect pertaining to the underbody shields of the subject vehicle, ODI is denying this Defect Petition. A Federal Register Notice (FRN) further detailing NHTSA’s reasons for denial of the petition will be published. The Agency reserves the right to take additional action if warranted by future circumstances. To review the report cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.

On July 17, 2023, the Office of Defect Investigation (ODI) opened this Recall Query (RQ) after receiving 2 consumer complaints alleging loss of vehicle forward power and/or loss of transmission torque of the rear wheels in model year (MY) 2020-2022 Ford Explorer vehicles (subject vehicles). The RQ was opened to focus on the effectiveness of the remedies of Recalls 22V-255 and 23V-199 related to the alleged problem. Recall 22V-255 involved replacing the bushing and axle cover in the following subject vehicles: 3.3L FHEV Police built before October 14, 2020, and 3.3L Gas Police vehicle built before January 31, 2021. For 2.3L RWD, 3.0L PHEV, 3.3LFHEV, and 3.0LST retail (non-police) vehicles, the recall provided an PCM software update to engage the Electronic Park Brake (EPB) when Park is commanded. The recall addressed a breakage of the rear axle bolt that can cause the driveshaft/half shafts to disconnect, resulting in a loss of transmission torque to the rear wheels necessary to hold park. If the parking brake is not applied, the loss of the primary park torque will allow the vehicle to roll in park increasing the risk of crash and injury. Recall 23V-199 addressed 674 of the subject vehicles produced from February 2, 2019 to April 4, 2022, which received an incorrect remedy under Recall 22V-255. The affected vehicles had received a previous Powertrain Control Module (PCM) update which did not include an automatic EPB engagement when vehicle is shifted to park. On October 17, 2023, Ford filed a new safety recall (Recall 23V-675) covering 238,364 MY 2020-2022 Explorer vehicles with the following powertrains: 3.3L FHEV Police, 3.3L Gas Police, 3.0L Gas Police, 2.3L RWD, 3.0L PHEV, 3.3L FHEV, 3.0L RWD and 3.0L AWD, produced from October 22, 2018 to July 6, 2022, equipped with a 3-point mounted axle design. Ford stated that the cause of the bolt fracture is due to joint design not robust to peak axle input torques and manufacturing variability. The primary contributor is insufficient bearings for maximum joint loads. This can result in bearing deformation, increasing bending stress on the bolt, which may lead to fatigue failure. On January 19, 2023, Ford amended Recall 23V-675 to add 1,942 MY 2020-2022 Explorer vehicles with the following powertrain: 3.0L RWD Platinum and King Ranch variant, produced from October 22, 2018 to July 6, 2022, equipped with a 3-point mounted axle design. In addition to the safety recall, Ford will conduct a customer satisfaction program for the following MY 2020-2022 Explorer vehicles with the following powertrains: 2.3L AWD, 3.3L Gas Retail, 3.0L Gas AWD Platinum and King Ranch, produced from October 22, 2018 to July 6, 2022. Ford stated that the Explorer powerpack variants not covered under Recalled 23V-675 do not present an unreasonable risk to motor vehicle safety due to the combination of lower peak torque levels and torque management strategies to share inputs between front and rear axles, reducing occurrence of higher torque.  According to Ford, this is also evidenced by the lower current and projected failure rates. In view of the recall action being taken by Ford, ODI is closing this RQ. NHTSA will continue to monitor complaints from the customer satisfaction program vehicles and reopen this issue, if necessary. The agency reserves the right to take additional action if warranted by future circumstances. To review the reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.