RoadVitals

1979 Ford F-250 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
9
Newest Aug 27, 2007
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

9 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

07E064000

FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP

Aug 27, 2007
34,000 units potentially affected
The defect: CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.
The risk: A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.
The remedy: FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.
FEDERAL-MOGUL CORPORATIONView on NHTSA.gov
79V201000

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:ROTOR

Nov 2, 1979
500 units potentially affected
The defect: DIMENSIONAL DIFFERENCES IN THE 1980 VERSUS THE 1979 ASSEMBLIES MAY ALLOW THE INNER BRAKE LINING/SHOE TO MOVE OUTWARD TO A POSITION WHERE IT IS NO LONGER RETAINED IN THE SHOE SLOT WHEN THE FRONT BRAKE INNER LININGS BECOME WORN TO THE POINT OF NEEDING REPLACEMENT. THE INNER BRAKE SHOE COULD THEN WEDGE BETWEEN THE ROTOR AND SPINDLE, POSSIBLY CAUSING A SUDDEN LOCK-UP OF ONE FRONT WHEEL. THIS CAN OCCUR WITHOUT BRAKE APPLICATION AND WOULD ADVERSELY AFFECT STEERING CONTROL. THESE DIMENSIONAL DIFFERENCES COULD ALSO ALLOW ADDITIONAL TRAVEL OF THE BRAKE PISTON SUCH THAT A LOSS OF BRAKE FLUID FROM THE FRONT BRAKE SYSTEM MAY OCCUR. THIS WOULD RESULT IN INCREASED STOPPING DISTANCES.
The remedy: THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE HUB AND ROTOR ASSEMBLIES AND SPINDLE SEALS.
FORD MOTOR COMPANYView on NHTSA.gov
79V117000

SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES

May 15, 1979
82,000 units potentially affected
The defect: THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.
The remedy: DEALER WILL REPLACE THE SUSPECT BRAKE RETAINING PIN.
FORD MOTOR COMPANYView on NHTSA.gov
79V035000

STEERING:LINKAGES:KNUCKLE:SPINDLE:ARM

Jan 29, 1979
62,000 units potentially affected
The defect: THE INVOLVED VEHICLES WERE ASSEMBLED WITH IMPROPERLY MANUFACTURED STEERING ARM KNUCKLES. SHOULD AN IMPROPERLY MANUFACTURED STEERING ARM KNUCKLE FRACTURE AND SEPARATE, THE STEERING LINKAGE TIE ROD MAY DISENGAGE FROM THE KNUCKLE.
The remedy: THE DEALER WILL INSPECT FOR CRACKING IN THE STEERING ARM KNUCKLES ON ALL VEHICLES AND, IF NECESSARY, REPLACE THEM FREE OF CHARGE.
FORD MOTOR COMPANYView on NHTSA.gov
79V038000

FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:MOUNTING

Jan 26, 1979
105 units potentially affected
The defect: THE INVOLVED VEHICLES WERE MANUFACTURED WITHOUT A FUEL TANK SHIELD AT THE FRONT RIGHT CORNER OF THE MIDSHIP FUEL TANK. AS A RESULT, THE VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY". IN THE EVENT OF A VEHICLE ACCIDENT, EXCESSIVE FUEL SPILLAGE COULD RESULT.
The remedy: THE DEALER WILL INSTALL THE REQUIRED FUEL TANK SHIELD WITHOUT CHARGE TO OWNER.
FORD MOTOR COMPANYView on NHTSA.gov
79V023000

VISIBILITY:WINDSHIELD

Jan 15, 1979
12 units potentially affected
The defect: THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, "WINDSHIELD MOUNTING", IN THAT SOME OF THE VEHICLES WERE BUILT WITHOUT THE SPECIFIED WINDSHIELD WEATHERSTRIP RETAINING COMPONENTS.
The remedy: THE DEALER WILL INSTALL THE WINDSHIELD WEATHERSTRIP RETAINING COMPONENTS AT NO COST TO OWNER.
FORD MOTOR COMPANYView on NHTSA.gov
78V256000

POWER TRAIN:AUTOMATIC TRANSMISSION

Nov 27, 1978
7,000 units potentially affected
The defect: THE INVOLVED VEHICLES WERE EQUIPPED WITH AUTOMATIC TRANSMISSIONS IN WHICH THE PARKING PAWL WAS NOT HEAT-TREATED. DURING NORMAL VEHICLE OPERATION, A PARKING PAWL THAT HAS NOT BEEN HEAT-TREATED COULD BECOME DEFORMED OR WORN TO THE POINT THAT THE TRANSMISSION WILL NOT LOCK IN "PARK". AS A RESULT, THE VEHICLE COULD ROLL FREE IF THE DRIVER DOES NOT SET THE PARKING BRAKE WHEN PARKING OR LEAVING VEHICLE UNATTENDED.
The remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE PARKING PAWL WITH ONE THAT HAS BEEN HEAT-TREATED.
FORD MOTOR COMPANYView on NHTSA.gov
78V201000

POWER TRAIN:AUTOMATIC TRANSMISSION

Sep 15, 1978
22,000 units potentially affected
The defect: THESE TRANSMISSIONS MAY CONTAIN IMPROPERLY MANUFACTURED PARKING PAWL ACTUATING RODS. CONSEQUENTLY, THE UNHARDENED CAM SURFACE OF THESE RODS CAN ALLOW THE ROD TO DEFORM DURING USE WITH RESULTANT INCREASE IN SHIFT EFFORTS AND DIFFICULTY IN RELEASING THE PARKING PAWL AND ENGAGING THE PARKING GEAR.
The remedy: DEALER WILL REPLACE THE TRANSMISSION PARKING PAWL ACTUATING ROD WITHOUT CHARGE TO OWNER.
FORD MOTOR COMPANYView on NHTSA.gov
78V197000

FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:MOUNTING

Sep 11, 1978
103 units potentially affected
The defect: THE INVOLVED VEHICLES DO NOT CONTAIN A FUEL TANK SHIELD AT THE FRONT RIGHT CORNER OF THE MID-SHIP FUEL TANK. IN THE EVENT OF A FRONTAL IMPACT, EXCESSIVE FUEL SPILLAGE FROM THE FUEL TANK MAY OCCUR. THIS FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".
The remedy: DEALER WILL INSTALL THE NECESSARY FUEL TANK SHIELD WITHOUT CHARGE TO OWNER.
FORD MOTOR COMPANYView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .