PARKING BRAKE
2024 Ford F-650 Incomplete Chassis
Recalls, owner-reported complaints, investigations and safety data
Overview
Our database contains no NHTSA owner-reported complaints for the 2024 Ford F-650 Incomplete Chassis. 2 safety recalls have been issued covering this model year; and 39 manufacturer communications are on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Safety recalls
2 campaigns cover this model year
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govPOWER TRAIN:AUTOMATIC TRANSMISSION:INTERNAL:PARK PAWL
Recent owner complaints
Reports submitted to NHTSA, shown in the owner's own words
No owner complaints recorded for this model year
Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.
Manufacturer communications
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
ELECTRICAL SYSTEM; POWER TRAIN
Some 2023-2026 F-53 Motorhome Chassis/F-59 Commercial Stripped Chassis and 2024-2026 F-650/F-750/E-Series vehicles equipped with a 6R140 transmission may be limited to 5th gear and reverse gear only. Additionally, the driver will be able to shift back to park. Diagnostic trouble codes (DTC) P2701, P2704, P0757, and/or P0733 may be stored in the powertrain control module (PCM). This may be due to PCM software being unable to command the transmission solenoid clutch actuators when the battery has a low state of charge (SOC) and/or the vehicle has been jump started. To restore proper transmission functionality, charge the battery as stated in the Workshop Manual (WSM), Section 414-01 Charging System > General Information. Cycle the ignition on then off and leave the vehicle off for 5 minutes to confirm the condition is no longer present. To prevent this issue from reoccurring, refer to the Owner's Manual > Storing Your Vehicle > Preparing Your Vehicle for Storage > 12V Battery. Replacement of transmission components will not resolve this condition. Inform the customer that the condition has no impact on tr
ELECTRICAL SYSTEM; POWER TRAIN
This article supersedes TSB 25-2200 to update the parts list to add the new camshaft and tappet service kit and add F-650/F-750. Some of the vehicles listed in the Model statement above may exhibit an upper engine ticking or tapping noise at idle. Customers may also report experiencing rough engine performance, engine misfire, or a malfunction indicator lamp (MIL) with diagnostic trouble code (DTC) P0301-P0308 in the powertrain control module (PCM). This may be due to camshaft and/or valve tappet having excess wear within the engine assembly.
ELECTRICAL SYSTEM; ENGINE
Certain 2024 - 2025 Model Year Diesel F-650/F-750 Vehicles Glow Plug Module Wire Harness Shielding On some of the affected vehicles, the wire harness connected to the glow plug dosing module may chafe due to abrasive contact with the front wheel arch liner. Over time, chafing of the wire harness may lead to a check engine light in the cluster, reduced engine power or engine no-start.
On the affected vehicles, the engine oil fill cap may be marked with ‘5W-20’ instead of the correct ‘5W-30’ marking. As a result, confusion may result regarding the correct engine oil.
POWER TRAIN
Some 2023-2024 F-Super Duty vehicles built on or before 22-Jul-2024 and equipped with a 6.7L engine may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC) P203B, P206B, and/or P2201:92 stored in the powertrain control module (PCM). This may be due to the software in the PCM. To correct the condition, follow the Service Procedure to reprogram the PCM using the latest software level of the Ford Diagnosis and Repair System (FDRS) scan tool.
Some 2024 F-Super Duty/F-150 vehicles may exhibit a concern where the vehicle's center display screen gets stuck in a reboot loop of the Ford logo and eventually goes black. This may be due to a concern with the software on the telematics control unit module (TCU). To correct the condition, follow the Service Procedure to reprogram the TCU and then perform a battery disconnect to make sure the accessory protocol interface module (APIM) receives the correct date from TCU.
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.