2016 Ford Redundant F-350

The Office of Defect Investigations (ODI) has received 27 complaints alleging diesel fuel leaks due to a fracture in the secondary fuel filter housing in model year (MY) 2015-2021 Ford Motor Company (Ford) F-250, 350, 450, and 550 Super Duty vehicles equipped with 6.7L diesel engines. Of these complaints, 12 describe an engine compartment fire. The proximity of the secondary fuel filter to high heat sources creates a potential for autoignition thermal events and fires. ODI has contacted the vehicle manufacturer, Ford, and the filter manufacturer, Allevard Sogefi USA (Sogefi), and learned that the low-pressure fuel system is capable of a maximum operating pressure of 8.5 Bar, while the secondary fuel filter is only tested to seven (7) Bar during the manufacturing process. Additionally, changes starting in 2022 by both Ford and Sogefi align with a lack of similar complaints on MY 2022 and newer vehicles. ODI is opening this Preliminary Evaluation (PE) to evaluate the severity of the potential problem and to fully assess the potential safety-related problems. To review the ODI reports cited in the Opening Resume ODI Report Identification Number document, go to NHTSA.gov.

Certain 2011-2022 Model Year Super Duty Vehicles Equipped with 6.7L Engine - Emission Control Information Label Update for Qualified Vehicles

Touchscreen navigation system - arabic language - blank screen

In some of the affected vehicles, the front control/display interface module (FCDIM) may have been unintentionally programmed for the European market instead of the North American market

PICKUP - 6.7L DIESEL ENGINE - RUNS ROUGH DURING EXHAUST REGENERATION PROCESS - BUILT ON OR BEFORE 2/23/2016 ISSUE Some 2015-2016 F-Super Duty 250-450 Pickup vehicles equipped with a 6.7L diesel engine and built on or before 2/23/2016 may exhibit a runs rough/misfire condition only during the exhaust regeneration process. This condition typically occurs on light throttle tip in between 64-113 Km/h (40-70 MPH) and will not set diagnostic trouble codes (DTCs). The concern may be intermittent and a knocking noise may be present during the concern. SERVICE PROCEDURE 1. Reprogram the powertrain control module (PCM) to the latest calibration using Integrated Diagnostic System (IDS) release 99.03 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com 2. Did the customer indicate the message center displayed a Cleaning Exhaust Filter message prior to the concern? a. Yes - proceed to Step 3. b. No - proceed to Step 6. 3. Remove the left cylinder head. Refer to Workshop Manual (WSM), Section 303-01. 4. Replace all eight (8) exhaust valves and valve seals. Refer to WSM, Section 303-01. (Figure 1)

Pickup - 6.7L Diesel Engine - Runs rough during exhaust regeneration process - built on or before 02/23/2016

In monitoring our technical service inquiries and technical service bulletins from Ford, there is the potential for moderate to severe steering wheel oscillation (wobble) to occur. After extensive testing and outside feedback, the following details have been established to correct or prevent steering wheel oscillation occurrences in lifted 05-16 Ford Super Duty 4wd pickups.