RoadVitals

2012 Forest River Rockwood Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
1
Newest Nov 7, 2013
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
1 investigation on file

Recall campaigns

1 campaign cover this model year — what the defect is, what it could cause, and what the remedy is

13V554000

SUSPENSION:REAR:AXLE:NON-POWERED AXLE ASSEMBLY; TIRES

Nov 7, 2013
721 units potentially affected
The defect: Forest River is recalling certain model year 2012-2013 Rockwood, Windjammer, Vlite and Flagstaff travel trailers manufactured February 3, 2012, through February 4, 2013. When an affected trailer hits a large bump or pot hole, the trailer tire may contact the bottom of the floor.
The risk: As a result, the tire may become damaged and possibly blow out which may cause a loss of control, increasing the risk of a crash.
The remedy: Forest River will notify owners, and dealers will add a lift kit between the frame and the axle mounting brackets, free of charge. Owners may contact Forest River at 1-574-825-7178.
Forest River, Inc.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

RQ14004ClosedRecall Query

Trailer tire may contact floor

Opened Sep 10, 2014
Closed Jul 9, 2015

ODI opened RQ14-004 based on 3 Vehicle Owner Questionnaires (VOQs) which reported a condition similar to recall 13V-554.This recall addressed insufficient clearance between the tire and trailer floor.The condition was due to a frame supplier change which resulted in reduced clearance between the top of the tire and the bottom of the wheel wellOf the three VOQs reported in the opening resume two were not included in recall 13V-554 and one was.Both of the vehicles not included used a different frame than the recalled trailers.Upon thorough examination of the condition experienced by the owners it was found that neither unit exhibited insufficient tire clearance between the bottom of the floor and top of the tire.Forest River's initial Information Request Response (IRR) submission did not adequately address all the questions asked by ODI.Following a meetingwith Forest River personnel on March 20, 2015 an IRR was submitted on May 22, 2015, which satisfied ODI.This submission is included in the public repository.When asked how Forest River identified the recall population they used a production change to determine the start and end dates.On February 3, 2012 Forest River introduced a new frame.The engineering drawings used to launch this new frame failed to identify the frame rail height.Furthermore, Forest River failed to verify that the new frame rail height was the same as the one it replaced.This created a half inch reduction in clearance.This issue was not identified and remedied untilFebruary 4, 2013 which is the end of the recall population. A thorough review of the complaint and warranty informationreceived during this investigation was preformed.After removing claims that could be associated with recall 13V-554 a defect trend was not identified on the remaining population.The only crash which also included an injurycould not be positively associated with the alleged defect. This investigation is closed.The closing of this investigation does not constitute a finding by NHTSA that no safety-related defect exists.The agency reserves the right to take further action if warranted by the circumstances.The ODI reports cited above can be reviewed at: http://www-odi.nhtsa.dot.gov/owners/SearchNHTSAID under the following complaint identification numbers: 10598458, 10598344, 10538519.

SUSPENSION:REAR:SPRINGS:LEAF SPRING ASSEMBLY:U-BOLT, LEAF SPRING TO AXLE

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .