RoadVitals

2004 Hummer H2 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
4
Newest Feb 1, 2006
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
2 investigations on file

Recall campaigns

4 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

06E010000

STEERING

Feb 1, 2006
1,360 units potentially affected
The defect: CERTAIN FABTECH AFTERMARKET REPLACEMENT PITMAN ARMS, P/NOS. FTS71000 AND FTS71001, INSTALLED FOR USE ON CERTAIN 2001-2006 GM C/K 2500 PICK UP TRUCKS AND SPORT UTILITY VEHICLES. THE PIN LOCATED INSIDE THE PITMAN ARM CAN SHEAR OFF DUE TO A REVERSE BENDING FATIGUE CONDITION, RESULTING IN A TOTAL LOSS OF STEERING CONTROL.
The risk: LOSS OF STEERING CONTROL COULD LEAD TO A VEHICLE CRASH WITH POTENTIAL INJURY OR DEATH.
The remedy: FABTECH WILL NOTIFY OWNERS AND REPLACE THE PITMAN AND IDLER ARMS FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING FEBRUARY 2006. OWNERS MAY CONTACT FABTECH AT 909-597-7800.
FABTECH MOTORSPORTSView on NHTSA.gov
05V163000

SEAT BELTS:REAR/OTHER

Apr 22, 2005
1,359,824 units potentially affected
The defect: ON CERTAIN CREW CAB PICKUP TRUCKS AND SPORT UTILITY VEHICLES, THE 2ND ROW CENTER OCCUPANT SEAT BELT ROUTING MAY MAKE IT DIFFICULT TO POSITION THE LAP PORTION OF THE SAFETY BELT LOW AROUND THE HIPS OF OCCUPANTS, ESPECIALLY SMALLER OCCUPANTS, SEATED IN THIS POSITION. APPROPRIATE USE OF A CHILD SEAT OR BOOSTER SEAT, AS RECOMMENDED FOR SMALL CHILDREN, DOES IMPROVE THE FIT CONDITION FOR THIS USER GROUP. IN ADDITION TO INSTRUCTIONS ON PROPER INFANT AND YOUNG CHILD RESTRAINT (WITH CHILD SEATS OR BOOSTERS), SPECIAL VERBIAGE FOR RESTRAINING OLDER CHILD IS INCLUDED IN THE OWNER'S MANUAL. ALSO, THE SUGGESTED SEAT BELT FIT/ROUTING FOR ADULTS, IRRESPECTIVE OF SEATING POSITION, IS DESCRIBED IN THE OWNER'S MANUAL TEXT.
The risk: A LAP PORTION OF THE SEAT BELT ROUTING THAT IS NOT LOW AND SNUG ON THE HIPS CAN ALLOW THE LAP BELT TO RIDE UP ON AN OCCUPANT'S ABDOMEN INSTEAD OF FITTING LOW AROUND THEIR HIPBONES, AND THEREFORE, CAN EXPOSE THEM TO MORE RISK OF ABDOMINAL AND INTERNAL ORGAN INJURY.
The remedy: DEALERS WILL CUT OPEN THE GUIDE LOOP, REMOVE A PORTION OF THE LOOP, AND THEN THE REMAINING TWO SIDES SHOULD BE FOLDED OVER AND SECURED WITH A RETAINER FREE OF CHARGE. THE RECALL BEGAN ON JULY 21, 2005. OWNERS MAY CONTACT CADILLAC AT 1-866-982-2339, CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463, OR HUMMER AT 1-800-732-5493.
GENERAL MOTORS CORP.Manufacturer number 05037View on NHTSA.gov
05V043000

SERVICE BRAKES, HYDRAULIC

Feb 8, 2005
77,411 units potentially affected
The defect: CERTAIN TRUCKS, SPORT UTILITY VEHICLES, AND VANS EQUIPPED WITH BOSCH HYDRO-BOOST BRAKE ASSEMBLIES, THE HYDRAULIC BRAKE BOOSTER PRESSURE ACCUMULATOR MAY CRACK AND SEPARATE FROM THE HYDRO-BOOST ASSEMBLY DURING NORMAL OPERATING CONDITIONS.
The risk: IF A SEPARATION OCCURRED AND THE HOOD OF THE VEHICLE WERE OPEN, FRAGMENTS FROM THE ACCUMULATOR COULD CAUSE INJURY TO PEOPLE IN THE IMMEDIATE AREA. THE PRESENCE OF THIS CRACK OR FRACTURED SURFACE COULD ALLOW THE HYDRAULIC FLUID TO LEAK FROM THE ACCUMULATOR CIRCUIT OF THE BOOSTER ASSEMBLY. THE LOSS OF FLUID WOULD CAUSE INCREASED STEERING AND BRAKING EFFORT AND A CRASH MAY OCCUR WITHOUT PRIOR WARNING.
The remedy: DEALERS WILL TEST THE HYDRO-BOOST ASSEMBLY FOR FUNCTIONAL OPERATION OF THE TWO-FUNCTION VALVE. IF THE HYDRO-BOOST ASSEMBLY FAILS THE TEST, DEALERS WILL REPLACE THE ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON MARCH 23, 2005. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, GMC TRUCKS AT 1-866-996-9463 AND HUMMER AT 1-800-732-5493.
GENERAL MOTORS CORP.Manufacturer number 05006View on NHTSA.gov
04V045000

SERVICE BRAKES, HYDRAULIC

Feb 4, 2004
68,875 units potentially affected
The defect: CERTAIN SPORT UTILITY VEHICLES, PICKUP TRUCKS, AND PASSENGER VANS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 135, ?PASSENGER CAR BRAKE SYSTEMS.? SOME OF THESE VEHICLES WERE PRODUCED WITH AN OUT-OF-SPECIFICATION BRAKE HYDRO-BOOST HOUSING RELIEF VALVE BORE.
The risk: CONSEQUENTLY, THE VALVE O-RING SEAL MAY FRACTURE. STEERING EFFORTS MAY BE SLIGHTLY INCREASED WHILE BRAKING OR PARKING. UNDER CERTAIN DRIVING CONDITIONS, A FRACTURED SEAL MAY REQUIRE A SLIGHT INCREASE IN THE APPLIED BRAKE PEDAL EFFORT TO ACHIEVE THE SAME VEHICLE DECELERATION RATE AS PRIOR TO THE SEAT FRACTURE.
The remedy: DEALERS ARE TO REPLACE THE HYDRO-BOOST RELIEF VALVE. THE RECALL BEGAN ON JUNE 18, 2004. OWNERS SHOULD CONTACT CADILLAC AT 1-866-982-2339; CHEVROLET AT 1-800-630-2438; GMC AT 1-866-996-9463; OR HUMMER AT 1-866-486-6376.
GENERAL MOTORS CORP.Manufacturer number 04004View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

EA05017ClosedEngineering Analysis

HUMMER H2 STEERING KNUCKLE FAILURES

Opened Oct 28, 2005
Closed Apr 30, 2007

ODI UPGRADED THIS INVESTIGATION AT THE CONCLUSION OF PE04-080.THE ALLEGED DEFECT INVOLVES THE FAILURE OF THE STEERING KNUCKLE AT THE LOWER BALL JOINT BOSS, RESULTING IN A SEPARATION OF THE LOWER BALL JOINT FROM THE KNUCKLE.A LOWER BALL JOINT SEPARATION COULD RESULT IN A LOSS OF STEERING AND/OR A DISABLED VEHICLE. IT APPEARS THAT THE FRACTURES OF H2 STEERING KNUCKLES CAN BE ATTRIBUTED TO WHEEL/TIRE COLLISION FORCES BEING TRANSFERRED DIRECTLY TO THE STEERING KNUCKLE.THE ORIGINAL KNUCKLE DESIGN APPEARS TO BE SUFFICIENT FOR THE H2 APPLICATION.EVIDENCE FROM INSPECTED VEHICLES, PHOTOGRAPHS, POLICE REPORTS AND EDR DATA INDICATES COLLISION IMPACT EVENTS PLACED STRESS ON THE STEERING KNUCKLE CAUSING IT TO FRACTURE.FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS WITH REGARD TO THE SUBJECT COMPONENT.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION ON THIS ISSUE IF WARRANTED.

SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT
PE04080ClosedPreliminary Evaluation

STEERING KNUCKLE FRACTURE

Opened Dec 2, 2004
Closed Oct 28, 2005

DURING THE PE, ODI INVESTIGATED THE HUMMER H2 FOR FRACTURES WHICH WERE OCCURRING AT THE FRONT STEERING KNUCKLE LOWER BOSS.WHEN THE KNUCKLE LOWER BOSS FRACTURES, THE LOWER BALL JOINT STUD IS RELEASED AND THE ENTIRE KNUCKLE AND WHEEL/TIRE ASSEMBLY SEPARATES FROM THE VEHICLE.ODI IS UPGRADING THIS INVESTIGATION TO GAIN A FULL TECHNICAL UNDERSTANDING OF THE FACTORS WHICH CONTRIBUTED TO THESE FAILURES.

STEERING:LINKAGES:TIE ROD ASSEMBLY

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .