RoadVitals

1995 International Harvester 2500 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Aug 2, 1995
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

95V144000

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS

Aug 2, 1995
278 units potentially affected
The defect: THESE VEHICLES WERE BUILT WITH AN IMPROPERLY PLUMBED BRAKE SYSTEM WHICH AFFECTS THE BRAKING ON THE REAR AXLE WHEN RUNNING EITHER BOBTAIL OR PULLING A TRAILER.
The risk: THIS CONDITION CAN AFFECT THE STOPPING ABILITY OF THE VEHICLE BECAUSE THE FRONT STEER AXLE BRAKES AND TRAILER'S BRAKES WOULD BE DOING MOST OF THE BRAKING. INCREASED STOPPING DISTANCES WOULD BE REQUIRED CAUSING ACCELERATED WEAR ON THE STEER AXLE AND THE TRAILER BRAKES.
The remedy: NAVISTAR DEALERS WILL INSPECT VEHICLES AND REPAIR BY INSTALLING BRAKE LINES AND FITTINGS AS REQUIRED.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov
95E009002

STEERING:LINKAGES:TIE ROD ASSEMBLY

May 9, 1995
196 units potentially affected
The defect: DURING ASSEMBLY, THE TIE ROD END NUTS WERE NOT PROPERLY TORQUED. EXTREMELY LOW TORQUE CAN ALLOW MOVEMENT BEWEEN THE BALL STUD AND THE TIE ROD ARM CAUSING DAMAGE.
The risk: THIS CONDITION CAN AFFECT THE DRIVER'S ABILITY TOSTEER THE VEHICLE INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.
The remedy: DEALERS WILL CHECK THE TORQUE ON THE BALL STUDS OF THE SUSPECT AXLES AND BRING THE TORQUE UP TO ROCKWELL'S SPECIFICATIONS.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources