RoadVitals

1994 International Harvester 3900 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Sep 13, 1996
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

96V174000

SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP

Sep 13, 1996
580 units potentially affected
The defect: THE WIRING FROM THE ELECTRONIC CONTROL UNIT WAS CONNECTED TO THE WRONG WHEEL SENSOR OR TO THE WRONG BRAKE MODULATOR VALVE. IT IS POSSIBLE THAT EITHER OR BOTH WIRING MAY HAVE OCCURRED AT EITHER THE FRONT OR REAR AXLE OR BOTH AXLES.
The risk: SHOULD THE ANTI-LOCK BRAKING SYSTEM (ABS) WIRING BE CROSSED, IT WOULD RESULT IN A SIGNIFICANT DEGRADATION IN VEHICLE STOPPING DISTANCE. A SIGNAL WOULD BE SENT TO THE WRONG BRAKE CHAMBER WHEN A BRAKE IMBALANCE IS DETECTED. THIS CONDITION INCREASES THE RISK OF A VEHICLE ACCIDENT.
The remedy: DEALERS WILL INSPECT THE ABS WIRING AND, IF NECESSARY, PROPERLY CONNECT.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov
93V201000

VEHICLE SPEED CONTROL

Dec 3, 1993
1,050 units potentially affected
The defect: THE HAND THROTTLE CABLE MAY BE MIS-ALIGNED WITH THE ACCELERATOR ROD CAUSING THE HAND THROTTLE CABLE TO "SAW" INTO THE ACCELERATOR ROD. THIS CAN CAUSE THE ACCELERATOR AND HAND THROTTLE CABLE TO BIND IN A PARTIAL OR FULL THROTTLE POSITION.
The risk: SHOULD THE ACCELERATOR ROD AND HAND THROTTLE CABLE BINDIN PARTIAL OR FULL THROTTLE POSITION, LOSS OF VEHICLE CONTROL COULD OCCUR,RESULTING IN AN ACCIDENT.
The remedy: NAVISTAR DEALERS WILL REPLACE THE PRESENT ACCELERATOR ROD WITH A NEW ACCELERATOR ROD WITH A HARDENED END. OWNERS ARE ADVISED TO DISCONNECT THE HAND THROTTLE UNTIL A NEW ACCELERATOR ROD IS AVAILABLE.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources