RoadVitals

1993 International Harvester 4000

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
3
Latest May 10, 2002
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 1993 International Harvester 4000. 3 safety recalls have been issued covering this model year; and 1 manufacturer communication is on file.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

3 campaigns cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov

TIRES; WHEELS

May 10, 2002
801 units potentially affected
The defect: CERTAIN HEAVY DUTY TRUCKS, TRUCK TRACTORS, AND BUSES EQUIPPED WITH 195/75R22.5 TIRES MOUNTED ON 7.5 INCH WIDE WHEELS FAIL TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS." THESE TIRES AND RIMS DO NOT MATCH.
The risk: TIRES MOUNTED ON RIMS THAT ARE TOO NARROW COULD EXPERIENCE A DECREASE IN SIDEWALL DURABILITY, AND COULD ALSO EXPERIENCE HIGHER TREADWEAR FOR TIRES MOUNTED ON THE STEERING AXLE.
The remedy: DEALERS WILL INSTALL NEW RIMS OF AN ACCEPTABLE WIDTH (8.25 - 9 9INCHES) FOR THE 295/75R22.5 TIRE SIZE. OWNER NOTIFICATION BEGAN AUGUST 23, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.
INTERNATIONAL TRUCK AND ENGINEManufacturer number 01505View on NHTSA.gov

WHEELS:HUBCAP/COVER

Mar 1, 1996
206 units potentially affected
The defect: THE FRONT WHEEL HUB CAN DEVELOP CRACKS AT THE WHEEL MOUNTING STUDS. WHEN MOUNTED TO THE HUB, THE HYDRAULIC BRAKE DISC ROTOR DOES NOT PROPERLY SUPPORT THE HUB AT THE WHEEL STUDS CAUSING EXCESSIVE STRESS AND FATIGUE CRACKS IN THE HUB.
The risk: SHOULD SUFFICIENT CRACKS OCCUR, THE MOUNTING FLANGE PORTION OF THE HUB ALONG WITH THE WHEEL COULD SEPARATE FROM THE VEHICLE WITHOUT WARNING. SHOULD THIS OCCUR WHILE THE VEHICLE IS DRIVEN, THE DRIVER COULD LOSE CONTROL OF THE VEHICLE AND/OR THE SEPARATED WHEEL AND HUB COULD STRIKE ANOTHER VEHICLE, PEDESTRIAN OR PROPERTY.
The remedy: DEALERS WILL INSTALL NEW, REDESIGNED HUBS ON THESE VEHICLES.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov

SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS

Mar 22, 1995
4,947 units potentially affected
The defect: AIR SYSTEM BLOCKAGE IN THE AIR DRYER OCCURS DEGRADING THE MOISTURE REMOVING CAPABILITIES OF THE DRYER WHEN THE VEHICLE IS OPERATED IN A COLD ENVIRONMENT AND MOISTURE ACCUMULATES AND FREEZES IN THE AIR DRYER OR IN THE LINE BETWEEN THE DRYER AND THE AIR SYSTEM RESERVOIR. THE AIR DRYER CAN BECOME OVER PRESSURIZED CAUSING THE AIR DRYER CARTRIDGE TO SEPARATE FROM THE MOUNTING BASE.
The risk: IF THE AIR DRYER SEPARATES FROM THE BASE, THE CARTRIDGECAN SEPARATE SUFFICIENTLY ENOUGH TO CAUSE PERSONAL INJURY OR PROPERTY DAMAGE.
The remedy: DEALERS WILL EQUIP AIR SYSTEMS WITH A PRESSURE RELIEF VALVE TO BE LOCATED BETWEEN THE COMPRESSOR AND THE AIR DRYER. THIS PRESSURE RELIEF VALVE IS INTENDED TO VENT IF EXCESSIVE PRESSURE DEVELOPS IN THE AIR DRYER.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Manufacturer communications

A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.

BCM9300028

VISIBILITY:POWER WINDOW DEVICES AND CONTROLS

IMPROVED POWER WINDOW REGULATORS. *TW

Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Compare model years

Complaint and recall counts across every year of this model

International Harvester 4000 by model year
YearComplaintsRecallsInvestigationsIssue Index
2001030
2000080
1999070
1998050
1997010
1996020
1995030
1994030
1993Viewing030
1989010
1988010
1987010
1986010

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.