RoadVitals

2000 International Harvester 4000 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
8
Newest May 21, 2003
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

8 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

03V193000

SUSPENSION:FRONT:HUB

May 21, 2003
2,163 units potentially affected
The defect: ON CERTAIN HEAVY AND MEDIUM DUTY TRUCKS AND BUSES EQUIPPED WITH TRUCK HUB UNITS MANUFACTURED BY SKF EXCLUSIVELY FOR USE ON ARVINMERITOR'S FF98X SERIES NON-DRIVE STEER AXLES, THE HUB UNIT BEARINGS CAN WEAR PREMATURELY.
The risk: SEIZURE OF THE BEARINGS CAN CAUSE WHEEL SEPARATION OR WHEEL END FIRE.
The remedy: DEALERS WILL REPLACE ALL FRONT AXLE HUBS. OWNER NOTIFICATION BEGAN ON NOVEMBER 12, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.
INTERNATIONAL TRUCK & ENGINE CORPORATIONManufacturer number 03510View on NHTSA.gov
02V137000

TIRES; WHEELS

May 10, 2002
801 units potentially affected
The defect: CERTAIN HEAVY DUTY TRUCKS, TRUCK TRACTORS, AND BUSES EQUIPPED WITH 195/75R22.5 TIRES MOUNTED ON 7.5 INCH WIDE WHEELS FAIL TO COMPLY WITH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS." THESE TIRES AND RIMS DO NOT MATCH.
The risk: TIRES MOUNTED ON RIMS THAT ARE TOO NARROW COULD EXPERIENCE A DECREASE IN SIDEWALL DURABILITY, AND COULD ALSO EXPERIENCE HIGHER TREADWEAR FOR TIRES MOUNTED ON THE STEERING AXLE.
The remedy: DEALERS WILL INSTALL NEW RIMS OF AN ACCEPTABLE WIDTH (8.25 - 9 9INCHES) FOR THE 295/75R22.5 TIRE SIZE. OWNER NOTIFICATION BEGAN AUGUST 23, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.
INTERNATIONAL TRUCK AND ENGINEManufacturer number 01505View on NHTSA.gov
01V140004

STEERING:LINKAGES:TIE ROD ASSEMBLY

Aug 2, 2001
18,348 units potentially affected
The defect: VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AXLE ASSEMBLIES WHICH MAY HAVE BEEN MANUFACTURED WITH TRW MODEL 20EDL BALL SOCKETS/DRAG LINKS. THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET IN SOME APPLICATIONS.
The risk: IF THIS CONDITION OCCURS, THE DRIVER CAN LOSE STEERING CONTROL, POSSIBLY RESULTING IN A VEHICLE CRASH.
The remedy: DEALERS WILL REPLACE THE DRAG LINK ASSEMBLIES. OWNER NOTIFICATION BEGAN AUGUST 28, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.
INTERNATIONAL TRUCK AND ENGINEManufacturer number 01510View on NHTSA.gov
01V044010

STEERING:LINKAGES:TIE ROD ASSEMBLY

Mar 19, 2001
3,762 units potentially affected
The defect: VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TIE ROD ASSEMBLIES CONTAINING 24-DL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.
The risk: IF THIS CONDITION OCCURS, THE DRIVER CAN LOSE PARTIAL CONTROL OF THE RIGHT FRONT WHEEL, POSSIBLY RESULTING IN A CRASH.
The remedy: DEALERS WILL REPLACE THE DEFECTIVE BALL SOCKETS AND/OR DRAG LINKS. OWNER NOTIFICATION BEGAN MARCH 23, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.
INTERNATIONAL TRUCK AND ENGINEManufacturer number 01504View on NHTSA.gov
00V246205

STEERING:LINKAGES:DRAG:LINK:CONNECTION

Oct 16, 2000
15,257 units potentially affected
The defect: VEHICLE DESCRIPTION: SCHOOL AND HEAVY DUTY TRUCKS EQUIPPED WITH TRW DRAG LINKS. EACH DRAG LINK ASSEMBLY CONTAINS TWO 20-EDL MODEL BALL SOCKET ASSEMBLIES. CERTAIN OF THE BALL-SOCKET BEARINGS HAVE A BELOW SPECIFICATION CASE DEPTH AND/OR HARDNESS WHICH CAN LEAD TO PREMATURE WEAR OUT OF THE SOCKET.
The risk: THIS CAN LEAD TO PREMATURE WEAR WITH POSSIBLE SEPARATION OF THE BALL STUD FROM THE SOCKET, INCREASING THE RISK OF LOSS OF CONTROL OF THE VEHICLE.
The remedy: DEALERS WILL REMOVE AND REPLACE AFFECTED DRAG LINKS.
INTERNATIONAL TRUCK AND ENGINEManufacturer number 00513View on NHTSA.gov
00V232401

SERVICE BRAKES, AIR:ANTILOCK

Aug 21, 2000
62,480 units potentially affected
The defect: VEHICLE DESCRIPTION: TRACTORS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU). THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.
The risk: THIS CONDITION COULD CAUSE THE ABS ECU TO EXHAUST THE AIR AT THE AIR BRAKE MODULATORS FOR ONE OR MORE OF THE WHEELS. THIS COULD RESULT IN EXTENDED BRAKING DISTANCES AND A POSSIBLE CRASH.
The remedy: DEALERS WILL REPLACE THE ABS ECU.
INTERNATIONAL TRUCK AND ENGINEManufacturer number 00511View on NHTSA.gov
00V232301

SERVICE BRAKES, AIR:ANTILOCK

Aug 21, 2000
79,465 units potentially affected
The defect: VEHICLE DESCRIPTION: MEDIUM AND HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU). THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.
The risk: THIS CONDITION COULD CAUSE THE ABS ECU TO EXHAUST THE AIR AT THE AIR BRAKE MODULATORS FOR ONE OR MORE OF THE WHEELS. THIS COULD RESULT IN EXTENDED BRAKING DISTANCES AND A POSSIBLE CRASH.
The remedy: DEALERS WILL REPLACE THE ABS ECU.
INTERNATIONAL TRUCK AND ENGINEManufacturer number 00510View on NHTSA.gov
00V176000

SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP

Jul 3, 2000
104,302 units potentially affected
The defect: VEHICLE DESCRIPTION: SCHOOL AND HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS. THE ABS SENSOR WIRES ON ROTATING PARTS CHAFES WHICH CAN LEAD TO A FALSE SIGNAL BEING SENT TO THE BENDIX ABS ELECTRONIC CONTROL UNIT (ECU).
The risk: THIS COULD CAUSE THE AIR ABS ECU TO EXHAUST THE AIR AT THE AIR BRAKE MODULATORS FOR ONE OR MORE OF THE WHEELS.
The remedy: DEALERS WILL INSPECT THE SENSOR WIRING ROUTING AND RE-ROUTE OR REPLACE THE ABS SENSORS AS REQUIRED.
INTERNATIONAL TRUCK AND ENGINEManufacturer number 00505View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources