RoadVitals

1990 International 4900 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Mar 18, 1993
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

93V040000

STEERING:LINKAGES

Mar 18, 1993
1,076 units potentially affected
The defect: THE TIE ROD USED ON THE DANA FA-64 FRONT DRIVE AXLE HAS A THREADED SLEEVE TO PERMIT TOE-IN ADJUSTMENT WITHOUT REMOVING AN END. THE TIE ROD BAR IS NECKED DOWN TO INCORPORATE THE SLEEVE. A STRESS RISER IS CREATED AT THE THREADED PORTION OF THE ADJUSTMENT SLEEVE WHICH MAY CAUSE A FATIGUE FRACTURE AND FAILURE OF THE TIE ROD WHERE IT SCREWS INTO THE SLEEVE.
The risk: FAILURE OF THE TIE ROD ON THE FRONT AXLE RESULTS IN LOSSOF STEERING CONTROL AND A POSSIBLE VEHICLE CRASH.
The remedy: REPLACE THE TIE ROD WITH A TIE ROD THAT DOES NOT USE AN ADJUSTMENT SLEEVE.
INTERNATIONAL TRUCK AND ENGINEView on NHTSA.gov
89V224000

SERVICE BRAKES, HYDRAULIC:POWER ASSIST:HYDRAULIC:HOSES, LINES/PIPING, AND FITTINGS

Dec 11, 1989
10,459 units potentially affected
The defect: THE THROTTLE VALVE INSIDE THE HYDRAULIC BRAKE BOOSTER MAY DEFORM FROM BUILDUP OF HEAT AND PRESSURE AND CLOSE-OFF FLUID RETURN PORTS.
The risk: THIS COULD CAUSE EXCESSIVE PRESSURE BUILDUP IN THEBOOSTER CAUSING THE BRAKES TO SELF APPLY WITH A SEVERE UNEXPECTED STOP. THISCONDITION COULD ALSO RESULT IN LOSS OF POWER STEERING ASSIST. EITHER CONDITIONCOULD RESULT IN AN ACCIDENT.
The remedy: REPLACE BRAKE BOOSTER ASSEMBLY.
NAVISTAR INTL CORP.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources