RoadVitals

2016 International Transtar

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
3
Latest Apr 6, 2023
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 2016 International Transtar. 3 safety recalls have been issued covering this model year; and 188 manufacturer communications are on file.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

3 campaigns cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
23V248000

ELECTRICAL SYSTEM:WIRING

Apr 6, 2023
42,054 units potentially affected
The defect: Navistar, Inc. (Navistar) is recalling certain 2016-2017 International TranStar, 2017-2019 International ProStar, International LoneStar, 2017-2020 International DuraStar, WorkStar, and 2018-2019 IC Bus HC Commercial buses. The heating, ventilation, and air-conditioning (HVAC) blower motor circuit may have an insufficient wiring terminal that can overheat.
The risk: An overheated electrical circuit can increase the risk of a fire.
The remedy: Dealers will replace the HVAC blower motor load circuit wiring terminal, free of charge. Owner notification letters are expected to be mailed June 5, 2023. Owners may contact Navistar's customer service at 1-800-448-7825. Navistar's number for this recall is 23510.
Navistar, Inc.Manufacturer number 23510View on NHTSA.gov
17V575000

STEERING; STEERING:LINKAGES:TIE ROD ASSEMBLY

Sep 20, 2017
1,175 units potentially affected
The defect: Navistar, Inc. (Navistar) is recalling certain 2016 International DuraStar, LoneStar, ProStar, TerraStar, TranStar, WorkStar, 9900i, and IC Bus HC vehicles equipped with certain Spicer D or E series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.
The risk: If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering, increasing the risk of a crash.
The remedy: Navistar will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary, free of charge. The recall began on November 8, 2017. Owners may contact Navistar customer service at 1-331-332-1590. Navistar's number for this recall is 17507.
Navistar, Inc.Manufacturer number 17507View on NHTSA.gov
15V693000

POWER TRAIN:MANUAL TRANSMISSION

Oct 23, 2015
5 units potentially affected
The defect: Navistar, Inc. (Navistar) is recalling certain model year 2016 International ProStar trucks manufactured January 5, 2015, to January 7, 2015, and 2016 International TranStar trucks manufactured on January 6, 2015, and equipped with certain Eaton Fuller FR-Series 10-speed manual transmissions. When the transmission shift lever is moved from reverse to neutral, the reverse gear may stay engaged. When the transmission shift lever is moved from reverse to a forward gear position, the transmission may mechanically lock because both the reverse gear and forward gear are simultaneously engaged.
The risk: Even though the transmission has been shifted out of reverse into neutral, the vehicle may unexpectedly move backwards, increasing the risk of a crash.
The remedy: Navistar will notify owners, and dealers will inspect the transmission. Any affected transmission will be repaired or replaced, free of charge. The recall began on November 20, 2015. Owners may contact Navistar customer service at 1-800-343-7357. Navistar's number for this recall is 15516.
Navistar, Inc.Manufacturer number 15516View on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Manufacturer communications

A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.

IK2600052

ELECTRICAL SYSTEM

This article describes how to fix a speedometer that does not read accurately. An inaccurate speedometer can be caused by changing the tire size, changing rear axle ratio (RAR), or by parameters being inadvertently changed during a programming event. Use the formulas and calculator below to correct the pulses per mile (PPM).

IK1900198

ELECTRICAL SYSTEM

This article only applies to Models w/ 0016UZL Built Between 06/23/2014 – 05/11/2020 OR Models w/ 0016UZL w/ Safety Recall 14516 Completed Reference the appropriate Technician Manual for models outside of this population. Safety Recall 14516 has been issued for units built before June 23, 2014. For LT and 2018+ LoneStar: If there is a complaint of the bunk blower turning off after an auto start event, the BCM needs to be updated to Data Version 323 or higher. • The bunk blower turning off was only present in BCM Data Version 309 to Data Version 322 To properly diagnose the system, you must ensure the recall has been performed. Only the "Cold Loop" sealed refrigerant core PN # 2614669C1 is to be replaced when the refrigerant circuit fails. DO NOT REPLACE THE COMPLETE UNIT IF THE A/C IS NOT FUNCTIONING. Complete unit is not Warrantable Refer to the BASIC TROUBLESHOOTING below before replacing any components. This will help you identify which component is at fault or any electrical issues. Refer to PARTS INFORMATION to properly identify the parts that may require replacement The A/C portion of the system is listed below in the parts section. The 16UZL No-Idle HVAC system is designed to disengage when the engine is started, and can be turned on with the key in any position. This battery-powered no-idle HVAC system provides heating and cooling of the sleeper area without use of the vehicle engine. The system is comprised of the no-idle HVAC components located in the sleeper HVAC module, a separate fuel-operated coolant heater mounted under the sleeper, and four additional batteries housed in a second battery box. The no-idle HVAC system shares the air handling assembly and several major components with the truck's standard HVAC system. Most importantly, the shared evaporator core contains refrigerant circuits for both the no idle system and the truck's standard A/C system. With this configuration, some procedures required to service the no idle A/C system will require opening the refrigerant circuit of the truck's standard A/C system. Trucks equipped with the 16UZL No-Idle HVAC system have two separate HVAC systems (Standard Truck A/C and the MaxxPower unit); it is important to identify each clearly, so you are troubleshooting the correct system. Per the Operator's Manual page 10: Run the heater at least once a month during the year (for a minimum of 15 minutes).

IK2600090

ENGINE

New CARB Idle Reduction Change Request

IK4300035

ELECTRICAL SYSTEM

This tool is designed to compare Diamond Logic feature data across multiple vehicle configuration files. It allows users to quickly load files either manually or directly from the Diamond Logic Builder Vehicles folder using VIN-based selection. As files are added or removed, the comparison runs automatically with no manual action required. The program presents results in an interactive table that shows feature codes, descriptions, access levels, and whether each feature is present in each selected file. Built-in search, filtering, and sorting make it easy to locate specific features or focus only on differences between files. Column visibility can be customized to show or hide descriptions and access information as needed. Users can remove files individually or clear all files at once, with results updating instantly. The tool also includes reporting and export options that reflect exactly what is visible on screen, allowing results to be printed, copied, saved as text, or exported to CSV for use in Excel or other spreadsheet tools. Overall, the program streamlines the process of comparing vehicle feature configurations, helping users quickly identify differences, validate setups, and document results without manual comparison or external tools.

IK2600255

ENGINE

This document provides guidance for assessing the feasibility of implementing a customer-requested change to an engine or vehicle parameter/feature. Customer requested changes will be approved in accordance with the requirements specified in 40 CFR Part 1037 to ensure continued compliance with greenhouse gas (GHG) regulations.

IK2600047

ENGINE

Engine replacements for all International engines will need to follow this procedure.

Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Compare model years

Complaint and recall counts across every year of this model

International Transtar by model year
YearComplaintsRecallsInvestigationsIssue Index
2019000—
2018020—
2017020—
2016Viewing030—
2015060—
2014060—
20130111—
20120111—
2011090—
2010030—
2009010—
2008010—
2007000—
2006000—
2005000—
2004000—
2003010—
2002010—
2001010—

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.