RoadVitals

NHTSA safety investigation

NHTSA Investigation EA09014

Engineering Analysis · Honda (American Honda Motor Co.) · SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE

ClosedEngineering Analysis

An investigation is not a finding that a defect exists.

NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.

Model years namedModel years in our database that NHTSA associated with this inquiry. Being named in an investigation says nothing about whether an individual vehicle has any problem.
4
2 models
Opened
Oct 19, 2009
Engineering Analysis
Closed
May 11, 2010

What NHTSA is examining

The agency's own description of the inquiry, quoted as published

Air in brake system

By letter dated March 15, 2010, American Honda Motor Corp. (HMC) notified the National Highway Traffic Safety Administration (NHTSA) that it will conduct a safety recall (NHTSA Recall No. 10V-098) to address a defect in approximately 412,000 model year (MY) 2007 and 2008 Honda Odyssey and Element vehicles equipped with an ABS/VSA/TCS modulator. The recalled Odyssey vehicles were built from August 2006 August 2008.The recalled Element vehicles were built from July 2006 to July 2008. According to Honda, during an initial self-check process that occurs shortly after each engine ignition cycle, the self-diagnostic software for the VSA modulator allows a vacuum condition that can exist for several hours, allowing air to enter the VSA modulator pump.Over time, and thousands of engine ignition cycles, it is possible for enough air to enter the system to result in a brake pedal that feels soft or lower to the floor.If the customer does not have any brake service or maintenance performed over a period of months or years, the system can continue to accumulate enough air to affect braking performance.To correct the safety defect, Honda dealers will remove existing air in the brake system then apply sealant and caps to the VSA modulator to prevent air from entering the brake system, free of charge. The action taken by Honda is sufficient to resolve the issues raised by this investigation. The agency will continue to monitor this issue and reserves the right to take further action if warranted by the circumstances.Accordingly, this investigation is closed.

An investigation is a separate record from a recall and from a manufacturer communication. A manufacturer campaign to repair a safety defect or a failure to meet a federal safety standard.

Investigation details

Identifiers, dates and outcome as recorded by NHTSA

Action number
EA09014
Investigation type
Engineering Analysis (EA)
Status
Closed
Manufacturer
Honda (American Honda Motor Co.)
Component
SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE
Opened
Oct 19, 2009
Closed
May 11, 2010
Associated recall campaign
10V098000

Vehicles named in this investigation

4 model years across 2 models

Being named here means NHTSA included the vehicle in the scope of its inquiry. It is not a statement that these vehicles have a defect.