RoadVitals

2008 J&j Truck Bodies Lwcul

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
1
Latest Oct 8, 2009
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 2008 J&j Truck Bodies Lwcul. 1 safety recall has been issued covering this model year.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

1 campaign cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
09V406000

EQUIPMENT

Oct 8, 2009
284 units potentially affected
The defect: SOMERSET WELDING AND STEEL IS RECALLING CERTAIN J&J TRUCK BODIES MODEL YEAR 2006-2009 DUMPTRUCKS MANUFACTURED WITH LIGHTWEIGHT CROSSMEMBERLESS ULTRALIGHT (LWCUL) BODIES WITH MAILHOT FRONT MOUNT HOISTS. AFTER REPEATED CYCLING OF THE DUMP BODY, THE WELDS HOLDING THE UPPER HOIST MOUNT SUBASSEMBLY BACK PLATE TO THE BULKHEAD MAY UNDERGO FATIGUE AND FAIL. THE LOWER WELD MAY SEPARATE FROM THE BULKHEAD AND EVENTUALLY THE CRACKING WILL PROPAGATE THROUGH THE VERTICAL WELDS ALONG THE TWO SIDES OF THE PLATE ALLOWING THE PLATE TO SEPARATE FROM THE BULKHEAD.
The risk: THE SEPARATION OF THE BACK PLATE FROM THE BULK HEAD MAY CAUSE THE HOIST TO FALL DOWN AND FORWARD, POTENTIALLY STRIKING THE BACK OF THE TRUCK CAB, CAUSING THE DUMP BODY TO RAPIDLY FALL. THE RAPID FALLING OF THE DUMP BODY INCREASES THE RISK OF INJURY TO SURROUNDING PERSONS AND, IF FAILURE OCCURS WHILE THE VEHICLE IS IN MOTION, INCREASES THE RISK OF A CRASH FAILURE.
The remedy: SOMERSET WELDING AND STEEL WILL INSPECT AND REPLACE OR REPAIR THE NECESSARY COMPONENTS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 23, 2009. OWNERS MAY CONTACT SOMERSET WELDING AND STEEL AT 1-814-443-2671.
SOMERSET WELDING & STEEL, INC.View on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Compare model years

Complaint and recall counts across every year of this model

J&j Truck Bodies Lwcul by model year
YearComplaintsRecallsInvestigationsIssue Index
2009010—
2008Viewing010—
2007010—
2006010—

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.