RoadVitals

1982 Kenworth L700 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
6
Newest Dec 7, 1986
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

6 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

86V003000

UNKNOWN OR OTHER

Dec 7, 1986
90 units potentially affected
The defect: LINE PRESSURE SURGES OCCUR WHEN THE TRANSMISSION IS IN HIGH GEAR LOCKUP DUE TO A PLUMBING ERROR. CONSEQUENCE OF DEFECT: LINE PRESSURE SURGES COULD CAUSE BODILY HARM THROUGH ERRATIC FIRE HOSE DELIVERY ACTION.
The remedy: REWORK PLUMBING TO PREVENT LINE PRESSURE SURGES.
PACCAR, INCORPORATEDView on NHTSA.gov
83V022000

STEERING:LINKAGES:DRAG:LINK:CONNECTION

Mar 1, 1983
100 units potentially affected
The defect: STEERING COMPONENTS MAY INTERFERE WITH EACH OTHER AND COULD LEAD TO SEPARATION OF STEERING LINKAGE. THE DRAGLINK, A COMPONENT IN THE STEERING LINKAGE THAT TRANSMITS TURNING MOVEMENTS TO THE WHEELS, MAY HAVE A CLAMP ON THE AXLE END WHICH HAS BEEN INCORRECTLY POSITIONED ON THE INBOARD SIDE OF THE DRAGLINK.
The remedy: DEALER WILL INSPECT THE FRONT STEERING FOR THE MISPLACED CLAMP AND RELOCATE IT CORRECTY. IF DAMAGED, THE DRAGLINK WILL BE REPLACED. DEALER WILL COR RECT THE CLEARANCE OF THE SUSPENSION RADIUS RODS TO PREVENT INTERFERENCE, IF NECESSARY.
PACCAR, INCORPORATEDView on NHTSA.gov
83V021000

SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS

Mar 1, 1983
100 units potentially affected
The defect: THE REAR BRAKES MAY NOT RELEASE AS QUICKLY AS SPECIFICATIONS REQUIRE. CERTAIN TRUCKS WERE EQUIPPED WITH AN INCORRECT SIZE AIR BRAKE LINE INSTALLED BETWEEN THE REAR BRAKE RELAY VALVE AND THE AXLE TEE FITTING. THE CONDITION IS NOT IN COMPLIANCE WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD 121, "AIR BRAKE SYSTEMS".
The remedy: THE DEALER WILL REPLACE ANY INCORRECTLY SIZED HOSES WITH THE CORRECT PART AT NO CHARGE.
PACCAR, INCORPORATEDView on NHTSA.gov
83V023000

SUSPENSION:FRONT:SPRINGS:LEAF SPRING ASSEMBLY:U-BOLT, LEAF SPRING TO AXLE

Mar 1, 1983
100 units potentially affected
The defect: THE U SHAPED BOLTS THAT CONNECT THE SPRINGS AND SPRING SPACERS TO THE FRONT AXLE MAY NOT HAVE BEEN INSTALLED PROPERLY. THIS CONDITION COULD ALLOW THE AXLE TO SHIFT AND COULD DEGRADE THE STEERING CHARACTERISTICS OF THE VEHICLE.
The remedy: THE DEALER WILL INSPECT AND REPLACE DAMAGED NUTS OR U BOLTS, OR TIGHTEN THE BOLTS AND NUTS TO SPECIFICATIONS. IT MAY BE NECESSARY TO INSERT ADDITIONAL SPACERS IN THE SPRINGS.
PACCAR, INCORPORATEDView on NHTSA.gov
83V024000

SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS

Mar 1, 1983
100 units potentially affected
The defect: FRONT AXLE AIR BRAKE CHAMBER IS ATTACHED WITH A CLAMP AND BOLT ASSEMBLY THAT MAY NOT HAVE BEEN POSITIONED CORRECTLY, AND MAY CHAFE AGAINST THE FRONT BRAKE HOSE. CHAFING COULD RESULT IN AN AIR LEAK AND LOSS OF AIR TO THE FRONT BRAKES.
The remedy: THE DEALER WILL INSTALL NEW FITTINGS ON THE FRAME END OF FRONT BRAKE HOSE AND REPLACE HOSES WITH A LONGER PART. THE FITTINGS WILL BE CORRECTLY LOCATED AND THE BRAKE CHAMBER CLAMP WILL BE POSITIONED CORRECTLY.
PACCAR, INCORPORATEDView on NHTSA.gov
82V090000

SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS

Sep 21, 1982
25 units potentially affected
The defect: ON CERTAIN VEHICLES IMPROPER AIR HOSE ASSEMBLY PROCEDURES MAY HAVE RESULTED IN PIECES BEING LEFT IN THE HOSE. THESE PIECES COULD BLOCK THE HOSE AND CAUSE A MALFUNCTION.
The remedy: AIR BRAKE HOSES WILL BE INSPECTED AND, IF DEFECTIVE, WILL BE REPLACED WITHOUT CHARGE.
PACCAR, INCORPORATEDView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources