2014 KTM 690 Duke Problems
Owner-reported complaints filed with NHTSA, grouped by component
Data refreshed
What this page shows
Everything below is an owner-reported complaint submitted to NHTSA about the 2014 KTM 690 Duke, grouped by the component NHTSA recorded on the report. These are not confirmed defects, and they are not recalls. NHTSA does not verify most reports before publishing them, and a category with more reports in it is not evidence that a part is defective.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Reports by component
Ranked by how many owner reports name each component category
- Fuel system583.3%
- Body & structure116.7%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Each component in detail
What the reports in each category say, in the owners' own words
Fuel system
Reports naming fuel storage or delivery — tanks, pumps, lines, injectors and fuel leaks.
From owner reports, verbatim
Fuel Leaks from filler neck when accelerating after filling the tank. Also, water enters the tank from rain, or washing the motorcycle. Bike ran perfectly before the rainy season started here in FL. After two weeks of commuting in the rain every day the bike barely runs, and when it does, it's unrideable. As it stalls randomly and can take some time to start it back up again. Drain the tank, put fresh gas in it, and it is good to go for another week till it starts the same process over again. Warped tank under filler.
DEFECT IN GAS TANK CAUSING GAS TO LEAK FROM THE TANK BETWEEN THE SEAL AND GAS CAP. GAS LEAKS OUT WHILE RIDING GETTING IT ALL OVER THE TANK. NOT SAFE!
Too few reports in this category for a page of its own — they appear in the full complaint list.
Body & structure
Reports naming the vehicle structure, frame, body panels, doors, hood and trim.
From owner reports, verbatim
THERE IS A MANUFACTURE DEFECT CAUSING THE PLASTIC GAS TANK TO SWELL, CRACK AND BECOMING FLEXIBLE TO THE TOUCH DUE TO THE PRESSURE AND GASSES FROM THE FUEL. THE RESULT OF THE GAS TANK SWELLING, IT WILL SPRAY GAS ONTO THE BIKE AND THE RIDER WHILE IN MOTION DUE TO IT NOT SEALING PROPERLY AROUND THE FLANGE. THIS IS A REOCCURRING ISSUE WITH NO FIX TO THE PROBLEM. I PURCHASED MY 2014 KTM 690 DUKE NEW ON JANUARY 1, 2017. I HAD THE TANK REPLACED BY THE LOCAL KTM DEALER (TJ CYCLES IN AUSTIN, TEXAS) IN FEBRUARY AND THE ISSUE HAS OCCURRED AGAIN. THERE ARE MULTIPLE FORUMS ABOUT THIS ISSUE REGARDING OTHER 690 DUKE OWNERS GOING THROUGH THE SAME PROBLEM WITH NO PERMANENT RESOLUTION IN SIGHT.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — owner-reported complaints and the components recorded on them
Data on this page last refreshed .