RoadVitals

2016 Mack LR6

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
1
Latest May 11, 2015
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
1
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 2016 Mack LR6. 1 safety recall has been issued covering this model year; 1 NHTSA investigation names it; and 92 manufacturer communications are on file.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

1 campaign cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
15V275000

ENGINE AND ENGINE COOLING:ENGINE

May 11, 2015
2,124 units potentially affected
The defect: Mack Trucks, Inc. (Mack) is recalling certain model year 2011-2016 Mack MRU and LEU trucks manufactured June 25, 2010, to April 30, 2015, and 2015-2016 LR6 trucks manufactured from December 18, 2014 through March 6, 2015. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.
The risk: If engine oil comes into contact with a hot surface, there could be an increased risk of a fire.
The remedy: Cummins will notify owners on behalf of Mack, and Cummins service centers will administer the repairs which include securing the ends of the 90-degree elbow and reprogramming the electronic control module (ECM) with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 12, 2015. Owners may contact Mack customer service at 1-800-528-6586 or Cummins Inc. at 1-800-343-7357. Mack's number for this recall is SC0391.
Mack Trucks, Inc.Manufacturer number SC0391View on NHTSA.gov

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect.

PE20005ClosedPreliminary Evaluation

mDrive Transmission Failure to Disengage

Opened Apr 28, 2020
Closed Apr 4, 2022

On April 28, 2020, the Office of Defects Investigation (ODI) opened PE20-005 to investigate reports of 2013-2015 Mack CHU and CXU trucks equipped with mDrive transmissions continuing to push forward when stopping, possibly increasing the risk of a crash. After more field reports were discovered, the scope of the investigation was expanded to cover MY 2013-2016 vehicles. The mDrive transmission is Mack's version of Volvo's I-Shift transmission, an automated manual transmission that allows gear shifting without the use of a clutch pedal. Early I-Shift transmissions were recalled (13V-268) to address a missing redundant clutch disengagement switch that could prevent the clutch from automatically disengaging when the brake was applied. If a loss of signal from the brake air pressure switch occurred, the clutch would remain engaged while braking.Although Mack's mDrive transmission adopted the latest Volvo I-Shift design and was built with the redundant clutch switch, ODI received field reports alleging that the mDrive transmission would not disengage when coming to a stop like the Volvo I-Shift transmissions in recall 13V-268.After more than a year of information requests, data exchanges and grouping, and analyzing data, ODI was able to correlate two versions of transmission software (ID 23084009 and ID 23084004), with two frequently replaced parts ('solenoid valve' and 'cylinder assy clutch') as outliers. However, Mack dismissed the replacement parts as being normal service parts for worn clutch systems.According to Mack, unlike the I-Shift recall, loss of one or more of the switches would not keep the clutch engaged but might cause a delay in the clutch disengaging, possibly due to the software/control system settings, the worn parts and system reaction time.To demonstrate the possible switch failure outcomes, Mack outfitted a subject model truck with a panel that could disable each switch on command. During test drives at the Mack facility, the demonstrator truck stopped when the brake was applied each time, and the truck did not stall when the brake was applied, even when the clutch was engaged. Even though failure of one of the switches could delay clutch disengagement, the stopping distance would still be shorter than one of the recalled Volvo I-Shift transmission trucks. With this information, as well as a lack of known crash incidents related to this complaint, ODI concludes that the Mack vehicles do not present an unreasonable risk to motor vehicle safety. Although ODI is closing this PE, Mack/Volvo should continue improving the transmission control unit software to further refine the clutch disengagement strategy. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exist. Claims are still being submitted and the Agency will continue to monitor the issue and reserves the right to take further action if warranted by new circumstances.

POWER TRAIN:MANUAL TRANSMISSION

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Manufacturer communications

A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.

CBR-1008 202404

POWER TRAIN

CBR: Equipped With An Automated Manual Transmission Model D or F ( AMT-D, AMT-F, mDrive) Missing X1 Value In VDA And Default Settings Guidelines, ParameterP1AOB; Fault Code P1052-54, Error 40,Or Error 18 Encountered During Clutch Or Tran.

CBR-2350 202402

ELECTRICAL SYSTEM

CBR -Telematics Gateway (TGW) Connect Ability Issues

CBR-202 202402

POWER TRAIN

CBR - Automated Manual Transmission ( AMT ) Flywheel Pilot Bearing Wear On Input Shaft.

CBR-2347 202402

ELECTRICAL SYSTEM

CBR - Active "Set Park Brake" Message On Drivers Information Display (DID).

CBR-2014 202402

SUSPENSION

CBR - Driveline Noise, Suspension Ride Height Too High, Suspension Will Not Exhaust - Chassis Built 2016w01 And Newer.

CBR-2333 202401

ELECTRICAL SYSTEM

CBR: TGW Will Not Connect After SIM Card Replacement

Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Compare model years

Complaint and recall counts across every year of this model

Mack LR6 by model year
YearComplaintsRecallsInvestigationsIssue Index
2016Viewing011—
2015010—
2014000—
2013000—
2012000—
2011000—

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.