RoadVitals

2001 May Coal Body Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
1
Newest Nov 13, 2000
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

1 campaign cover this model year — what the defect is, what it could cause, and what the remedy is

00E074000

EXTERIOR LIGHTING:TAIL LIGHTS:SWITCH

Nov 13, 2000
115 units potentially affected
The defect: EQUIPMENT DESCRIPTION: MAY COAL DUMP BODIES MANUFACTURED BETWEEN MAY 1, 1998 AND JULY 15, 2000. THESE BODIES DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT," FOR ONE OR MORE OF THE FOLLOWING REASONS: A) COAL BODIES EQUIPPED WITH NON-REFLECTIVE LAMP LENSES, BODY REAR AND BODY SIDE REFLECTIVE DEVICES MAY NOT HAVE BEEN INSTALLED; B) THE STOP/TURN/TAIL LAMPS ARE MOUNTED ON THE END OF THE TRUCK CHASSIS (ACCORDING TO THE STANDARD, THE FACE OF THOSE LAMPS SHOULD BE NO MORE THAN 12 INCHES FROM THE EXTREME REAR OF THE VEHICLE); C) THE THREE LAMP IDENTIFICATION LAMP CLUSTER IS MOUNTED ON THE END OF THE TRUCK CHASSIS (ACCORDING TO THE STANDARD, THE FACE OF THOSE LAMPS SHOULD BE NO MORE THAN 12 INCHES FROM THE EXTREME REAR OF THE VEHICLE;) D) ON CERTAIN COAL BODIES EQUIPPED WITH PERMANENT "BOARD(S) OVER GATE," THE IDENTIFICATION LAMP CLUSTER IS MOUNTED ON THE END OF THE TRUCK CHASSIS (ACCORDING TO THE STANDARD, THE FACE OF THOSE LAMPS SHOULD BE NO MORE THAN 12 INCHES FROM THE EXTREME REAR OF THE VEHICLE); AND E) REAR CLEARANCE LAMPS, MOUNTED WITH THEIR CENTER LINES WITHIN 6 INCHES OF THE EXTREME OUTER SIDE OF THE BODY, WERE NOT INSTALLED ON COAL BODIES EQUIPPED WITH STOP/TURN/TAIL LAMPS MOUNTED AT THE REAR OF THE TRUCK CHASSIS.
The risk: ANY OF THESE CONDITIONS CAN MAKE THE VEHICLE LESS CONSPICUOUS WHICH COULD RESULT IN A VEHICLE CRASH.
The remedy: BENSON WILL NOTIFIY ITS CUSTOMERS TO TAKE THEIR VEHICLE TO A PARTICIPATING DEALER TO HAVE THE REMEDY PREFORMED FREE OF CHARGE.
BENSON INTERNATIONAL, INC.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources