2015 Mazda Mazda3 Driver assistance Problems

The contact owns a 2015 Mazda Mazda3. The contact stated that while driving at various speeds, or while attempting to reverse, the rear camera flashed on and off for approximately five minutes and then started working as intended. No warning light was illuminated. The vehicle was repaired under the NHTSA Campaign Number: 23V487000 (BACK OVER PREVENTION) by the owner of the vehicle; however, the fix failed to repair the vehicle. The contact stated that the failure had occurred after the recall repair was performed. The manufacturer was not notified of the failure. The failure mileage was 180,000.

NHTSA ID

11731350

Incident

Apr 15, 2026

Mileage

180,000 mi

The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (BACK OVER PREVENTION). However, the dealer refused to complete the recall repairs due to the vehicle having a Salvage Title. The contact stated that the rearview camera displayed a black screen while the vehicle was in reverse(R). The contact stated that the failure obstructed the driver's visibility, which prevented the driver from safely operating the vehicle. The manufacturer was made aware of the issue and referred the contact back to the dealer. The vehicle remained unrepaired. The failure mileage was approximately 86,000.

NHTSA ID

11696444

Incident

Oct 22, 2025

Mileage

86,000 mi

On Thursday October 9th I drove to work at 11pm and parked my car. I backed up into my space using my back-up camera as I had always did since I had purchased my car in 2019. The next morning when I got home and put my car in reverse to back into my space, I noticed that the back-up camera did not come on. The radio continued to play on the screen, but in never switched over to the camera so that I could use this component to park. After trying several times to try to figure out what the issue was I gave up. I had an appointment that same morning, so I parked my car and came back about an hour later to leave and started my car, pulled out of my space, then put my car in reverse and the camera was back up and running again. I found this to be strange. Most likely this will happen again. I googled/researched this to see if there was a recall for this issue in this make and model and came across a few articles where others had the same or similar complaints. So it all lead me here. It seems as if there is a malfunction in these cameras, if it is happening to others, and happened to me, then it's happening. So what's happening...is my question? Why are these camera not recalled? Do we wait until it shuts down in the middle of us backing up or what? What's next? Can I get someone at Mazda to look at my camera, and replace it? Or is this something I have to live with? I should not have to, neither should I have to pay some outrageous price to get it replace on my own dime. There is definitely an issue with this camera in this make and model. So is anyone going to be fair and do something about this, or wait until there is an accident behind it? If it's a defect in the product, just simply replace it.

NHTSA ID

11620926

Incident

Oct 10, 2024

The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated that the back-up camera screen image was flickering and became distorted while reversing. The cause of the failure was not determined. The failure mileage was 60,000. VIN tool confirms parts not available.

NHTSA ID

11616156

Incident

Oct 15, 2022

Mileage

60,000 mi

The contact owns a 2015 Mazda Mazda3. The contact stated that occasionally while the vehicle was shifted into reverse, the review camera image would not display on the digital screen. In addition, the contact stated that the image looked distorted. The contact received a notification of 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was contacted, but the vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 85,000.

NHTSA ID

11613125

Incident

Mar 15, 2024

The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated while reversing, the rearview camera image failed to display. The local dealer was notified of the failure, but the vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure, but no assistance was provided. The failure mileage was approximately 82,000. VIN tool confirms parts not available.

NHTSA ID

11610923

Incident

Aug 15, 2023

Mileage

82,000 mi

The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that while reversing, the rearview camera image was distorted, blank or failed to activate as needed. The local dealer was contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 63,000. VIN tool confirms parts not available.

NHTSA ID

11600126

Incident

Jan 8, 2024

Mileage

63,000 mi

The contact owns a 2015 Mazda Mazda3. The contact stated that while reversing, the rear-view camera image was distorted, black, and failed to appear on the center display. The vehicle was taken to the local dealer, where an unknown software was reprogrammed; however, the failure persisted. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 53,953. VIN tool confirms parts not available.

NHTSA ID

11597244

Incident

Jun 27, 2017

Mileage

53,953 mi

The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA ID

11590087

Incident

May 22, 2024

See attached document for complaint

NHTSA ID

11576769

Incident

Jan 5, 2024

The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was made aware of the issue and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

NHTSA ID

11574083

Incident

Aug 1, 2023

The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The local dealer was notified of the issue and confirmed that the parts were not yet available. The manufacturer was not notified of the issue. The contact had not experienced a failure. VIN tool confirms part not available.

NHTSA ID

11571865

Incident

Feb 14, 2024

This in regards to NHTSA Recall #: 23V-487. It has been 173 days since this recall was announced and I have not received any correspondence from the manufacturer. The recall has been sitting with no remedy available for 6 months. I want to know when Mazda is expected to have a fix to this vehicle?

NHTSA ID

11563306

Incident

Jan 3, 2024

The contact owns a 2015 Mazda Mazda3. The contact stated that on numerous occasions after he opened and closed the trunk of the vehicle or while shifted into reverse, the rear-view camera image intermittently became distorted or blank. The contact then received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. An undisclosed dealer was contacted and stated to the contact that there was no such recall for the failure. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 67,000. VIN tool confirms parts not available.

NHTSA ID

11547192

Incident

Sep 28, 2022

Mileage

67,000 mi

HOT WEATHER ACCELERATION AND BLIND SPOT MONITORING SYSTEM (BSM) ISSUE: IN EXTREMELY HOT WEATHER BSM OFF LIGHT TURNS ON REPEATEDLY WHILE THE VEHICLE IS IN MOTION OR STARTING FROM COMPLETE STOP. AT THE SAME TIME THE INFOTAINMENT SYSTEM DISPLAY FLICKERS IN SYNC WITH THE BSM OFF LIGHT APPEARANCE. WHEN THIS OCCURS THERE IS A CLICKING SOUND COMING FROM THE FRONT OF THE CAR/WHERE THE ENGINE IS LOCATED. THE SOUND IS ACCOMPANIED BY TEMPORARY LOSS OF ACCELERATION WHEN IN MOTION OR STARTING TO MOVE FROM A COMPLETE STOP. WHEN THIS OCCURS WHILE STARTING FROM A COMPLETE STOP, THE ENGINE REVOLUTIONS (REV) DROPS BELOW 1K RPM DESPITE GAS PEDAL INPUT THUS THE CAR WOULD NOT MOVE/ACCELERATE FOR ABOUT 5 SECONDS. WHEN IT OCCURS WHEN THE CAR IS IN MOTION SUCH AS ON THE HIGHWAY OR MERGING ONRAMP INTO THE HIGHWAY THE CAR UNSAFELY SLOWS DOWN DESPITE GAS PEDAL INPUT. AGAIN THIS ISSUE IS OBSERVED DURING UNUSUALLY HOT DAYS EG. JULY 22, 2017 IN ST. LOUIS, MISSOURI.

NHTSA ID

11018752

Incident

Jul 22, 2017

Mileage

27,000 mi