2012 Mitsubishi Lancer Problems

The front subframe(cross member) blew out, due to excessive corrosion. Causing the control arm to dismount as well as separation of the CV axle from the transmission, while traveling down the road losing complete steer of the vehicle. Luckily I was coming to a stop sign and not traveling on the highway. My vehicle was last inspected in April of 2023 with no warning signs of there being an issue. I've recently done some research and gathered information regarding models from 08-10 Mitsubishi lancers having the exact same issue. I contacted my dealer about the issue and they stated there are no current recalls on my year vehicle. Although they also started that the part number on my subframe is the same part number that failed on the 09-10 models. There should be a recall on 2012 Mitsubishi lancer subframe(front cross member) I hope this issue is resolved! I was fortunate to not have been injured! My vehicle has not currently been inspected after the accident because I had it towed back to my house after the accident because I was unsure what to do about the situation. The vehicle is available to be towed to be inspected if need be. A police officer did pass me and checked to make sure I was alright while I was stranded in the middle of the road while waiting for a tow truck.

THE AYC/ACD PUMP FAILURE

I own a 2012 Mitsubishi Lancer and I have been experiencing issues with the engine. The check engine light comes on constantly then disappears for about 2 weeks and then comes back soon after. This has been a ongoing thing since i got the car a few months ago. Also, my battery light will come on (with noise and notice) then quickly turn off and not come back on. This happens on and off also. I did some research and I believe it is a belt issue.

NHTSA safety report 06/2021 — while driving approximately 45-50 mph, the ABS warning light and traction control light suddenly came on the display so I reduced speed and had planned to proceed to the next service station which was approximately 1.5 miles away. However, when I was approximately 1/2 mile from the station the engine stalled, the vehicle slightly jerked, and the the engine died. At this point, I shifted into neutral and cruised a couple hundred feet to a safe pull-off point. Upon inspection of the vehicle, the battery was completely dead and would not hold a charge when jumped. This prompted me to check the alternator where I noticed the loose belt and broken tensioner which I had repaired at my own expense the following day.

WINDOW WIPER WILL FAIL IN MIDDLE SWIPE. WHEN TURNED OFF AND BACK ON, IT MAY START AGAIN HOWEVER IT SOMETIMES GETS STUCK IN THE MIDDLE OF THE WIPING MOTION. OUTLANDER SPORT FROM YEAR 2011-2016 HAD A CURRENT RECALL FOR WIPER LINKAGE CORROSION (784902762095). THE MITSUBISHI OUTLANDER SPORT MODEL AND THE LANCER MODEL SHARE MANY COMMON PARTS.

THE WIPER MOTOR WILL FAIL RANDOMLY, THE BLADE WILL JUST STOP MOVING. WHEN THE WIPER IS TURNED OFF AND THEN BACK ON, IT WILL START WORKING AGAIN BUT THEN FAIL AGAIN. THIS OCCURS WHEN THE CAR IS STATIONARY OR MOVING. THERE IS A RECENT RECALL FOR THE 2011-2015 MITSUBISHI OUTLANDER SPORT MODEL (RECALL NUMBER 16V792000) WITH "INTERNAL CORROSION OF THE WINDSHIELD WIPER MOTOR AND THE POSSIBLE FAILURE OF THE MOTOR." WHICH HAS THE SAME WIPER COMPONENTS AS THE LANCER MODEL.

EL CARRO CUANDO VA SUBIENDO CUESTA LARGAS NO ACCELERA SE QUEDA SIN FUERZA Y DICE QUE BAJE LA VELOCIDAD SI EL SOLO LO BAJA Y NO PERMITE ACCELERAL Y EL MOTOR TIENE UN RUIDO QUENO ES NORMAL NI LO HACIA ANTES

TL* THE CONTACT OWNS A 2012 MITSUBISHI LANCER. WHILE DRIVING APPROXIMATELY 30 MPH, THE VEHICLE ACCELERATED INDEPENDENTLY WHEN THE CONTACT REMOVED HER FOOT FROM THE ACCELERATOR PEDAL. THE VEHICLE WAS TAKEN TO A MECHANIC WHO WAS UNABLE TO DETERMINE THE CAUSE OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED AND THE MANUFACTURER WAS NOT NOTIFIED. THE APPROXIMATE FAILURE MILEAGE WAS 24,000.

RECEIVED VEHICLE AT 10KM, AFTER 2 OIL CHANGES, AT 16000KM MILIEGE DROPPED FROM 700KM ON A TANK OF GAS TO 300KM TANK OF GAS. AT 24000KM HEAVY TRANSMISSION AND ENGINE NOISES OCCURRED. GEARS SLIPPING OUT WHILE ACCELERATING CAUSING RPMS TO SHOOT UP TO 6000-7000 WHILE VEHICLE NOT MOVING. TIMING BELT AND PULLEYS NOT WORKING PROPERLY CAUSING TO MUCH ENGINE NOISE. METAL GRINDING AND WHISTLING SOUND COMING FROM UNDER CARRIAGE OF VEHICLE. REAR DIFFERENTIAL AND CV JOINT PROBLEM. REPORTED PROBLEM TO DEALERSHIP AND TECHINCIANS EACH TIME I GO IN. THEIR RESPONSE IS ITS JUST TIRE NOISE AND YOUR VEHICLE IS RUNNING SMOOTHLY EACH TIME. NOW AT 68,000 KM, REAR DIFFERENTIAL IS GONE, ENGINE BARELY HOLDING UP, SUSPENSION ON DRIVER SIDE IS IS LOWER THAN PASSENGER SIDE. WHEEL BEARING NOISES PRESENT. 4X4 AWC SYSTEM ISN'T WORKING. VEHICLE IS DRAGGING AND IS AT QUARTER EFFICIENCY. ON TIME WITH SERVICE AND OIL CHANGE, KEEP BRINGING UP SAME COMPLAINTS AND REPORTED BACK THAT ITS JUST TIRE NOISE. ALL 4 TIRES CHANGES, BRAKES CHANGED AND ROTORS. NOW THAT THINGS ARE BREAKING DOWN. DEALERSHIP AT BANK STREET MITSUBISHI DENIES DOING ANY NEGLIGENCE OVER THE COURSE OF 4 YEARS AND SAYING OUR TECHS WOULDN'T HAVE MISSED THOSE PROBLEMS. VEHICLE TAKEN TO 6 LOCAL MECHANICS AND ALL REPORTING SAME PROBLEM, TAKEN TO OTHER MITSUBISHI DEALERSHIPS AND REPORTED NEGLIGENCE ON TECHNICIANS AND MECHANICS FROM BANK STREET MITSUBISHI THAT THESE ISSUES SHOULD HAVE BEEN DONE IN THE PAST SINCE THEY ARE DEFECTS. CALLED MITSUBISHI CANADA. MANAGER THERE SAYS OUR TECHS ARE ONE OF THE BEST AT THAT LOCATION. NOW THEY WANT TO VOID WARRANTY DUE TO THEIR MISTAKES SINCE PARTS NEED TO BE REPLACED. SERVICE MANAGER DOESN'T WANT HIGH INVOICE BILLS. WHILE REPAIRING PARTS, TECHS DAMAGING OTHERS. AND NOT REPORTING IT. MAKING COSTUMERS PAY FOR TECHS MISTAKES. ISSUE STILL ON GOING. MANAGER AND TECHS AVOIDING ACCOUNTABILITY FOR THEIR ACTIONS.

TL* THE CONTACT OWNS A 2012 MITSUBISHI LANCER. THE CONTACT STATED THAT WHILE DRIVING 70 MPH, THE VEHICLE SUDDENLY RAN OUT OF GASOLINE FUEL. THE CONTACT WAS UNAWARE OF THE LOW FUEL IN THE VEHICLE DUE TO THE FUEL GAUGE READING THREE QUARTERS OF A TANK FULL. THE CONTACT TOOK THE VEHICLE TO THE DEALER FOR A DIAGNOSTIC TEST, WHICH CONFIRMED THAT THE FUEL SENSOR WAS DEFECTIVE. THE DEALER REPLACED THE FUEL SENSOR BUT THE REPAIR DID NOT REMEDY THE PROBLEM. THE CONTACT STATED THE FUEL SENSOR WAS REPLACED TWICE. NONE OF THE REPAIRS REMEDIED THE DEFECTIVE FUEL GAUGE FAILURE. THE CONTACT DID NOT CALL THE MANUFACTURER. THE FAILURE MILEAGE WAS 24,830.

The front subframe(cross member) blew out, due to excessive corrosion. Causing the control arm to dismount as well as separation of the CV axle from the transmission, while traveling down the road losing complete steer of the vehicle. Luckily I was coming to a stop sign and not traveling on the highway. My vehicle was last inspected in April of 2023 with no warning signs of there being an issue. I've recently done some research and gathered information regarding models from 08-10 Mitsubishi lancers having the exact same issue. I contacted my dealer about the issue and they stated there are no current recalls on my year vehicle. Although they also started that the part number on my subframe is the same part number that failed on the 09-10 models. There should be a recall on 2012 Mitsubishi lancer subframe(front cross member) I hope this issue is resolved! I was fortunate to not have been injured! My vehicle has not currently been inspected after the accident because I had it towed back to my house after the accident because I was unsure what to do about the situation. The vehicle is available to be towed to be inspected if need be. A police officer did pass me and checked to make sure I was alright while I was stranded in the middle of the road while waiting for a tow truck.

TL* THE CONTACT OWNS A 2012 MITSUBISHI LANCER. THE CONTACT STATED THAT WHILE DRIVING APPROXIMATELY 5 MPH AND MAKING A TURN, A SQUEAKING NOISE EMITTED FROM THE STEERING WHEEL. THE VEHICLE WAS TAKEN TO AN AUTHORIZED DEALER SIX TIMES FOR THE SAME MALFUNCTION. THE TECHNICIAN WAS UNABLE TO LOCATE OR DUPLICATE THE PROBLEM. THE MANUFACTURER WAS NOTIFIED OF THE DEFECT. THE APPROXIMATE FAILURE MILEAGE WAS 4,000.

The front subframe(cross member) blew out, due to excessive corrosion. Causing the control arm to dismount as well as separation of the CV axle from the transmission, while traveling down the road losing complete steer of the vehicle. Luckily I was coming to a stop sign and not traveling on the highway. My vehicle was last inspected in April of 2023 with no warning signs of there being an issue. I've recently done some research and gathered information regarding models from 08-10 Mitsubishi lancers having the exact same issue. I contacted my dealer about the issue and they stated there are no current recalls on my year vehicle. Although they also started that the part number on my subframe is the same part number that failed on the 09-10 models. There should be a recall on 2012 Mitsubishi lancer subframe(front cross member) I hope this issue is resolved! I was fortunate to not have been injured! My vehicle has not currently been inspected after the accident because I had it towed back to my house after the accident because I was unsure what to do about the situation. The vehicle is available to be towed to be inspected if need be. A police officer did pass me and checked to make sure I was alright while I was stranded in the middle of the road while waiting for a tow truck.

The contact owns a 2012 Mitsubishi Lancer. The contact stated that the vehicle was taken to an independent mechanic for routine maintenance, and he was informed that the sub frame was rusted. The contact was informed that there was a huge hole in the sub frame. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not contacted about the failure. The approximate failure mileage was 65,000.

ANOTHER DRIVER RAN A STOP SIGN, I HIT THEIR VECHILE HEAD ON. MY AIRBAGS DID NOT DEPLOY.

THE AYC/ACD PUMP FAILURE

TL* THE CONTACT OWNS A 2012 MITSUBISHI LANCER. THE CONTACT STATED THAT WHILE DRIVING APPROXIMATELY 35 MPH, THE TRACTION CONTROL WARNING LIGHT ILLUMINATED BEFORE THE VEHICLE MADE A SHARP RIGHT TURN AND BECAME DIFFICULT TO STEER. THE VEHICLE WAS TAKEN TO A NEARBY INDEPENDENT MECHANIC WHERE IT WAS DIAGNOSED THAT THE SUBFRAME WAS FRACTURED DUE TO EXCESSIVE CORROSION. THE VEHICLE WAS NOT YET REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE LOCAL DEALER WAS NOT CONTACTED. THE FAILURE MILEAGE WAS 123,000.