RoadVitals

1979 Oldsmobile 88 Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
3
Newest Nov 13, 1979
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

3 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

79V247000

SEAT BELTS:FRONT:ANCHORAGE

Nov 13, 1979
1,326,404 units potentially affected
The defect: THE HEADS MAY BREAK OFF THE FRONT OUTBOARD SEAT BELT ANCHOR BOLTS DURING NORMAL VEHICLE OPERATION EVEN UNDER NO LOAD CONDITIONS. THIS IS DUE TO THE COMBINATION OF BOLTS USED, HIGH INSTALLATION TORQUE AND ARRANGEMENT OF THE BODY ANCHORAGE.
The remedy: DEALER WILL REPLACE ALL ORIGINAL EQUIPMENT FRONT OUTBOARD SEAT BELT ANCHOR BOLTS ON THE AFFECTED VEHICLES AT NO COST TO OWNER.
GENERAL MOTORS CORP.View on NHTSA.gov
79V121000

SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM:HOSES, LINES/PIPING, AND FITTINGS

May 22, 1979
134 units potentially affected
The defect: THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 106, "BRAKE HOSES". THESE VEHICLES WERE MANUFACTURED WITH GASOLINE FUEL HOSES IN PLACE OF THE VACUUM HOSE BETWEEN THE INTAKE MANIFOLD AND CARBON CANISTER IN THE POWER BRAKE VACUUM LINE. SHOULD THIS HOSE RUPTURE, IT WOULD RESULT IN A LOSS OF POWER ASSIST TO THE BRAKE SYSTEM. THIS WOULD INCREASE THE DISTANCE REQUIRED TO STOP THE VEHICLE.
The remedy: THE DEALER WILL REPLACE THE INCORRECT HOSE WITH THE CORRECT VACUUM HOSE.
GENERAL MOTORS CORP.View on NHTSA.gov
78V247000

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER

Nov 13, 1978
67 units potentially affected
The defect: A GASKET WAS MISTAKENLY PLACED BETWEEN THE BRAKE MASTER CYLINDER AND THE POWER BOOST WHICH PREVENTED THE TWO PARTS FROM FITTING TOGETHER PROPERLY. DAMAGE MAY HAVE RESULTED TO THE MOUNTING EARS OF THE MASTER CYLINDER AND THE HYDRO-BOOST. THIS CONDITION COULD LEAD TO BRAKE FAILURE.
The remedy: THE DEALER WILL INSTALL A NEW BRAKE MASTER CYLINDER AND HYDRO-BOOST UNIT, FREE OF CHARGE, ON ALL AFFECTED VEHICLES.
GENERAL MOTORS CORP.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .