RoadVitals

2001 Pierce Impel

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
1
Latest Sep 21, 2010
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 2001 Pierce Impel. 1 safety recall has been issued covering this model year; and 26 manufacturer communications are on file.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

1 campaign cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
10V423000

STEERING

Sep 21, 2010
2,652 units potentially affected
The defect: PIERCE IS RECALLING CERTAIN MODEL YEAR 1998 THROUGH 2008 ARROW XT, LANCE, VELOCITY, ENFORCER, IMPEL, AND DASH CUSTOM FIRE APPARATUS VEHICLES MANUFACTURED FROM MAY 30, 1998 THROUGH NOVEMBER 25, 2008. THE STEERING GEAR BRACKET MAY FRACTURE AND BREAK. IF THIS OCCURS THE STEERING GEAR MAY DETACH FROM THE VEHICLE.
The risk: DETACHMENT OF THE STEERING GEAR WILL RESULT IN A LOSS OF STEERING CONTROL THAT COULD CAUSE A CRASH.
The remedy: PIERCE WILL NOTIFY OWNERS AND DEALERS WILL INSTALL A NEW STEERING GEAR MOUNTING BRACKET FREE OF CHARGE. THE SAFETY RECALL BEGAN ON OCTOBER 12, 2010. OWNERS ARE BEING INSTRUCTED TO INSPECT THE STEERING GEAR BRACKET PRIOR TO EACH TRIP. THE REMEDY TO REPAIR THIS DEFECT IS EXPECTED TO BEGIN NO EARLIER THE JANUARY 31, 2011. OWNERS MAY CONTACT PIERCE AT 1-888-974-3723.
PIERCE MANUFACTURINGManufacturer number 74B207View on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Manufacturer communications

A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.

PB_572.4

Introduction of tri-crimp, Spiralock™ chassis/aerial hardware.

PB_750

To improve the fitment and operational reliability of manual window cranks by installing a fabricated collar over the regulator splines, eliminating looseness and reducing effort when raising or lowering the window.

SB_746

Single axle tillers can be retrofitted to have a 91° jackknife angle, an improvement from the previous jackknife angle of 88°. New tillers are configured with this change as per Sales Bulletin PSB1063.

SB_747

IMMI, the creator and supplier for Rolltek and other Supplemental Restraint System (SRS) products, is implementing design changes due to obsolescence of select parts. Most recently, the AB8 Front Impact Protection (FIP) sensors are no longer available and cannot be ordered. If you believe there is an issue with the AB8 FIP sensor, please contact customer service for technical support. We now require all active and inactive diagnostic codes be included when starting a Technical Incident for an SRS issue. Having the codes at the start of the incident ticket process will provide efficient troubleshooting and increase the accuracy of the suggested corrective actions.

SB_733

This bulletin provides a procedure by which to apply a software update to applicable Command Zone devices installed in Pierce custom chassis apparatus using a Single Packet Update (SPU) file loaded via the CZ Webpages application. This procedure is applicable to apparatus equipped with either CL-711 or CL-714 series Displays.

SB_735

This bulletin provides a procedure by which to apply an Over-The-Air Programming (OTAP) software update to applicable Command Zone devices installed in Pierce custom chassis apparatus with a CL-714 series Display and with Telematics Control Unit version 7.0.3 or greater.

Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Compare model years

Complaint and recall counts across every year of this model

Pierce Impel by model year
YearComplaintsRecallsInvestigationsIssue Index
2026010—
2025020—
2024010—
2023020—
2022030—
2021040—
2020060—
2019060—
2018060—
2017060—
2016090—
2015090—
2014030—
2013070—
2012050—
2011080—
2010090—
20090130—
20081150—
20073120—
2006050—
2005040—
2004030—
2003020—
2002010—
2001Viewing010—
2000010—
1999010—
1998010—

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.