RoadVitals

2016 Pierce Saber Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
8
Newest Mar 30, 2021
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

8 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

21V222000

EXTERIOR LIGHTING:BACK UP LIGHTS; EXTERIOR LIGHTING:BRAKE LIGHTS; EXTERIOR LIGHTING:TAIL LIGHTS; EXTERIOR LIGHTING:TURN SIGNAL

Mar 30, 2021
4 units potentially affected
The defect: Pierce Manufacturing (Pierce) is recalling certain 2016-2018 Enforcer, Freightliner and Saber vehicles equipped with ECCO Holdings Code 3 7x9 Stop-Tail-Turn Reverse All-in-One LED stop, tail, turn, and reverse lights. The rear LED lights may be too bright. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and Associated Equipment."
The risk: The excessive brightness may negatively affect the vision of other drivers, increasing the risk of a crash.
The remedy: Pierce will notify owners, and dealers will provide a filter kit to be installed in the rear lights, free of charge. The recall is expected to begin April 26, 2021. Owners may contact Pierce customer service at 1-888-974-3723.
Pierce ManufacturingView on NHTSA.gov
18V050000

EQUIPMENT

Jan 11, 2018
123 units potentially affected
The defect: Pierce Manufacturing (Pierce) is recalling certain 2015-2016 Arrow XT, Enforcer, Quantum, Saber, Velocity, and Commercial emergency vehicles equipped with Hale pressure relief valves in the water pumps used for fire fighting. Rings securing the valves may corrode over time after exposure to water, causing the ring to fail and the pressure relief valve to open, reducing the water pressure available for fire fighting.
The risk: A reduction in water pressure may hinder fire fighting efforts, increasing the risk of injury.
The remedy: Pierce has notified owners, and dealers will install a remedy kit, free of charge. The recall began on February 9, 2018. Owners may contact Pierce customer service at 1-888-974-3723 or Hale Products at 1-800-533-3569. Pierce's number for this recall is 74B287.
Pierce ManufacturingManufacturer number 74B287View on NHTSA.gov
17V570000

STEERING; STEERING:LINKAGES:TIE ROD ASSEMBLY

Sep 14, 2017
56 units potentially affected
The defect: Pierce Manufacturing (Pierce) is recalling certain 2015-2016 Arrow XT, Enforcer, Impel, Quantum, Saber, and Velocity vehicles, equipped with certain Spicer D-Series and E-Series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.
The risk: If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering and increasing the risk of a crash.
The remedy: Pierce will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary. If the tie rod stud and knuckle on units cannot be sufficiently torqued, the dealer will replace the knuckle and tie rod end assembly, free of charge. The recall began on November 30, 2017. Owners may contact Pierce customer service at 1-414-832-3000.
Pierce ManufacturingView on NHTSA.gov
16V585000

POWER TRAIN:MANUAL TRANSMISSION

Aug 5, 2016
470 units potentially affected
The defect: Pierce Manufacturing (Pierce) is recalling certain model year 2015-2016 Arrow, Dash, Enforcer, Impel, Quantum, Saber, and Velocity fire trucks manufactured June 29, 2015, to June 30, 2016. The affected vehicles may be equipped with certain C20 and C21 split-shaft transmissions from Waterous. This transmission sends power to the wheels of an emergency response vehicle or power to an add-on unit such as a water pump used for fighting fires. A component within the shift unit may be damaged and as a result, the operator may not be able to switch the power output.
The risk: If the power output cannot be changed, once the fire truck arrives at the scene, it may not be able to pump water to aid in extinguishing the fire, increasing the risk of injury.
The remedy: Piece will notify owners, and dealers will remove the shift unit assembly and replace the clevis pin and retaining rings, free of charge. The recall began on September 2, 2016. Owners may contact Pierce customer service at 1-888-974-3723. Pierce's number for this recall is 74B277.
Pierce ManufacturingManufacturer number 74B277View on NHTSA.gov
16V390000

EQUIPMENT

Jun 1, 2016
114 units potentially affected
The defect: Pierce Manufacturing (Pierce) is recalling certain model year 2015-2016 Arrow XT, Enforcer, Impel, Quantum, Saber, and Velocity emergency vehicles manufactured August 4, 2015, to August 24, 2016, equipped with pumps to provide pressurized water to aid in fighting fires. These pumps have 6" intake strainers that may have been improperly soldered during production and, as a result, the strainers may come apart during use, allowing parts of the strainer and debris to enter the pump, possibly damaging the pump.
The risk: If the strainer and/or debris enters the pump, and the operator is forced to shut down the pump, reducing firefighting effectiveness, there could be an increased risk of injury.
The remedy: Pierce will notify owners to check the strainer for missing solder at the joints. Any strainers missing solder will be replaced, free of charge. The recall began on June 16, 2016. Owners may contact Pierce customer service at 1-888-974-3723 or Hale Products Customer Service Center at 1-800-533-3569. Pierce's number for this recall is 74B272.
Pierce ManufacturingManufacturer number 74B272View on NHTSA.gov
16V148000

ELECTRICAL SYSTEM:WIRING

Mar 10, 2016
267 units potentially affected
The defect: Pierce Manufacturing (Pierce) is recalling certain model year 2014-2016 Enforcer and Saber emergency vehicles manufactured from March 3, 2014, through February 3, 2016. The clamps on the heater hose may have been improperly installed allowing engine coolant to leak into the passenger compartment.
The risk: If coolant leaks into the passenger compartment, it may contact electrical components causing a shorting of circuits and a loss of function of features controlled by those circuits, including loss of power to vehicle which may result in a stall and increase the risk of a crash. The hot coolant may also contact occupants and possibly cause burn injuries.
The remedy: Pierce will notify owners, and dealers will inspect the hose clamp installation. Any improperly installed clamps will be corrected free of charge. The recall began on April 11, 2016. Owners may contact Pierce customer service at 1-888-974-3723. Pierce's number for this recall is 74B269.
Pierce ManufacturingManufacturer number 74B269View on NHTSA.gov
16V123000

POWER TRAIN:DRIVELINE:DRIVESHAFT

Mar 2, 2016
239 units potentially affected
The defect: Pierce Manufacturing (Pierce) is recalling certain model year 2016 Arrow-XT, Dash, Enforcer, Impel, Quantum, Saber, and Velocity fire and emergency vehicles manufactured October 13, 2015, to February 9, 2016. The fastener cap over the bearing on the universal joint of the drive shaft may have been improperly tightened.
The risk: If the cap was not properly tightened, the cap may detach from the vehicle and become a road hazard. Additionally, the universal joint may separate and the vehicle may not be able to be driven, increasing the risk of a crash.
The remedy: Pierce will notify owners, and dealers will check and correct the tightness of all bolts for the universal joint caps, as needed, free of charge. The recall began on March 25, 2016. Owners may contact Pierce customer service at 1-888-974-3723. Pierce's number for this recall is 74B270.
Pierce ManufacturingManufacturer number 74B270View on NHTSA.gov
15V706000

POWER TRAIN:AXLE ASSEMBLY

Oct 26, 2015
5 units potentially affected
The defect: Pierce Manufacturing (Pierce) is recalling certain model year 2015-2016 Arrow XT, Velocity, Enforcer, and Saber vehicles manufactured November 20, 2014, to September 29, 2015. The affected vehicles are equipped with front drive axles whose hex nuts on the flange yoke may not have been properly tightened.
The risk: If the hex nuts are not tightened to specification, the driveshaft may disconnect from the drive axle, resulting in a loss of propulsion and increasing the risk of a crash.
The remedy: Pierce will notify owners, and dealers will inspect the hex nuts, tightening them as necessary, free of charge. The recall began on November 12, 2015. Owners may contact Pierce customer service at 1-888-974-3723. Pierce's number for this recall is 74B266.
Pierce ManufacturingManufacturer number 74B266View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .