RoadVitals

1993 Saturn Sw Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Data refreshed

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Aug 10, 1993
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
2 investigations on file

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

93V132000

ELECTRICAL SYSTEM:ALTERNATOR/GENERATOR/REGULATOR

Aug 10, 1993
352,833 units potentially affected
The defect: THE GENERATOR ELECTRICAL WIRING IS NOT PROTECTED AGAINST EXCESSIVE CURRENT FLOW WHICH MAY BE CAUSED BY AN ELECTRICAL SHORT CIRCUIT IN THE GENERATOR.
The risk: SHOULD AN ELECTRICAL SHORT CIRCUIT OCCUR IN THEGENERATOR, THE GENERATOR WIRING HARNESS WOULD EXPERIENCE EXCESSIVE CURRENT FLOW.UNDER CERTAIN CONDITIONS, ENOUGH HEAT COULD BE GENERATED TO IGNITE SURROUNDINGMATERIALS. IF THIS OCCURS, AN UNDERHOOD FIRE COULD RESULT WITH OR WITHOUT THEENGINE RUNNING AND WITHOUT PRIOR WARNING.
The remedy: THE GENERATOR WIRING HARNESS WILL BE REPLACED WITH ONE THAT WILL OPEN AS A FUSE WOULD UNDER CERTAIN EXCESSIVE CURRENT FLOW CONDITIONS.
GENERAL MOTORS CORP.View on NHTSA.gov
93V094000

ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES

May 25, 1993
14,459 units potentially affected
The defect: THE POSITIVE BATTERY CABLE TERMINAL AT THE STARTER SOLENOID MAY BE FORMED INCORRECTLY. INCORRECTLY FORMED TERMINALS CAN CONTACT THE STARTER SOLENOID HOUSING AND CAUSE AN ELECTRIC SHORT CIRCUIT.
The risk: AN ELECTRICAL SHORT CIRCUIT BETWEEN THE BATTERY CABLE ANDTHE STARTER HOUSING CAN RESULT IN AN UNDERHOOD FIRE.
The remedy: INSPECT AND, IF NECESSARY, ADJUST THE CLEARANCE BETWEEN THE POSITIVE BATTERY CABLE TERMINAL SO THAT IT DOES NOT CONTACT THE STARTER SOLENOID HOUSING.
GENERAL MOTORS CORP.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Safety investigations

NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.

EA95003ClosedEngineering Analysis

CRUISE CONTROL FAILURES

Opened Feb 24, 1995
Closed May 31, 1996

THIS INVESTIGATION DOCUMENTED HTE FUNCTIONAL ABERATIONS THAT HAVE OCCURRED IN THE PERFORMANCE OF THE SUBJECT CRUISE CONTROL SYSTEM.MOST OF THE MALFUNCTIONS INVOLVED FAILURE OF THE SYSTEM TO PROPERLY REGULATE VEHICLE SPEED WHEN ENGAGED, FAILURE OF THE SYSTEM TO ENGAGE, OR SELF-DISENGAGEMENT OF THE SYSTEM. THESE PROBLEMS WERE INVESTIGATED AND STEPS TAKEN BY THE MANUFACTURER TO REMEDY THEIR OCCURRENCES.SERVICE PROCEDURES WERE ISSUED FOR VEHICLES IN USE, AND A DESIGN MODIFICATION MADE FOR NEW VEHICLES.NO CONFIRMED ALLEGATIONS OF FAILURE OF THE SYSTEM TO DISENGAGE UPON COMMAND WERE IDENTIFIED.IMPROVED QUALITY CONTROL PROCEDURES AND DESIGN MODIFICATIONSIN THE SYSTEM WERE UNDERTAKEN TO ENSURE A MORE CONSISTENT LEVEL OF SYSTEM PERFORMANCE.THE DETAILS OF THESE FINDINGS AND THE RESULTING CONCLUSIONS ARE CONTAINED INTHE SUBJECT ENGINEERING ANALYSIS CLOSING REPORT.A SAFETY-RELATED DEFECT TREND WAS NOT IDENTIFIED AT EHIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT CONSTITUTE A FINDING BY NHTSA THAT A SAFETY-RELATED DEFECT DOES NOT EXIST.THE AGENCY WILL TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.

EQUIPMENT
PE94079ClosedPreliminary Evaluation

CRUISE CONTROL FAILURE

Opened Nov 7, 1994
Closed Feb 24, 1995

There is no summary currently available

EQUIPMENT

Elsewhere on this vehicle

Data sources

Data on this page last refreshed .