RoadVitals

1994 Spartan Gladiator Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
4
Newest May 12, 1999
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

4 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

99V118000

SEAT BELTS:FRONT:ANCHORAGE

May 12, 1999
1,753 units potentially affected
The defect: VEHICLE DESCRIPTION: FIRE TRUCKS. THESE FIRE TRUCKS ARE ALL 4-DOOR MODELS WHICH CONTAIN DUAL, FORWARD FACING PASSENGER SEATS. THE HARDWARE UTILIZED TO MOUNT THE SEAT BOX TO THE CAB FLOOR AND TO THE BACKWALL STRUCTURE, AND ALSO TO MOUNT THE TYPE 1 SEAT BELT SYSTEMS, WAS INADEQUATE TO MEET THE REQUIREMENTS OF FMVSS NOS. 207/210, ""SEATING SYSTEMS" AND "SEAT BELT ASSEMBLY ANCHORAGES."
The risk: THE SEAT BOX MOUNTING/RESTRAINING HARDWARE CAN LOOSEN OR FAIL ALLOWING THE SEAT/SEAT BOX ASSEMBLY TO BREAK FREE OF ITS MOUNTING TO THE CAB FLOOR AND/OR BACKWALL WHICH COULD CAUSE INJURY TO THE OCCUPANTS OF THOSE SEATS.
The remedy: DEALERS WILL REPLACE THE SEAT BOX MOUNTING FASTENERS.
SPARTAN MOTORS, INC.Manufacturer number SPEC 98049View on NHTSA.gov
99V010000

STRUCTURE

Jan 20, 1999
3,210 units potentially affected
The defect: VEHICLE DESCRIPTION: FIRE TRUCKS. THE CAB TILT SYSTEM CONTAINS A 12 VOLT ELECTRICAL SOLENOID ASSEMBLY AS AN ACCESSORY TO THE CAB TILT ELECTRIC MOTOR/HYDRAULIC PUMP ASSEMBLY. RAIN, SNOW, SALT SPRAY OR OTHER CORROSIVE ENVIRONMENT CAN CORRODE THE SOLENOID OR "BRIDGE" THE ENERGIZING COIL WIRE TERMINAL CAUSING THE CAB TILT SYSTEM TO OPERATE UNCONTROLLABLY.
The risk: THIS COULD CAUSE THE CAB TILT SYSTEM TO ACTUATE WITHOUT CONTROL, INCREASING THE RISK OF PERSONAL INJURY.
The remedy: DEALERS WILL INSTALL A HERMETICALLY SEALED SOLENOID ASSEMBLY.
SPARTAN MOTORS, INC.Manufacturer number 97019View on NHTSA.gov
98V286000

SUSPENSION

Nov 6, 1998
39 units potentially affected
The defect: VEHICLE DESCRIPTION: FIRE TRUCKS. IF THE DRIVER ACCELERATES IN A TURN ABOVE 20 MPH FORWARD SPEED, THE LOCK PIN IS ACTUATED AND CAUSES THE AXLE TO RESIST RETURNING TO THE STRAIGHT AHEAD POSITION AFTER THE TURN IS COMPLETED BECAUSE THE LOCK PIN IS BINDING ON THE CLAMP PLATE SURFACE.
The risk: ENGAGING THE LOCK PIN IN THE LCMP PLATE HOLE AT HIGH FORWARD SPEEDS CAUSES EXCESSIVE WEAR IN THE LOCK PIN AND/OR THE CLAMP PLATE HOLE. LANE CHANGES AND OTHER VEHICLE MANEUVERS WILL GREATLY INCREASE CONTACT FREQUENCY AND CAUSES WEAR, INCREASING THE RISK OF LOSS OF VEHICLE CONTROL.
The remedy: DEALERS WILL REPLACE THE TAG AXLES ON THESE FIRE TRUCKS.
SPARTAN MOTORS, INC.View on NHTSA.gov
95E003014

SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS

Jul 13, 1995
10 units potentially affected
The defect: AIR SYSTEM BLOCKAGE IN THE AIR DRYER OCCURS DEGRADING THE MOISTURE REMOVING CAPABILITIES OF THE DRYER WHEN THE VEHICLE IS OPERATED IN A COLD ENVIRONMENT AND MOISTURE ACCUMULATES AND FREEZES IN THE AIR DRYER OR IN THE LINE BETWEEN THE DRYER AND THE AIR SYSTEM RESERVOIR. THE AIR DRYER CAN BECOME OVERPRESSURIZED CAUSING THE AIR DRYER CARTRIDGE TO SEPARATE FROM THE MOUNTING BASE.
The risk: IF THE AIR DRYER SEPARATES FROM THE BASE, THE CARTRIDGE CAN SEPARATE SUFFICIENTLY ENOUGH TO CAUSE PERSONAL INJURY OR PROPERTY DAMAGE.
The remedy: DEALERS WILL EQUIP AIR SYSTEMS WITH A PRESSURE RELIEF VALVE TO BE LOCATED BETWEEN THE COMPRESSOR AND THE AIR DRYER. THIS PRESSURE RELIEF VALVE IS INTENDED TO VENT IF EXCESSIVE PRESSURE DEVELOPS IN THE AIR DRYER.
SPARTAN MOTORS, INC.View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources