SERVICE BRAKES, AIR:ANTILOCK:ABS WARNING LIGHT
2001 Strick Trailer Recalls
Safety recall campaigns filed with NHTSA that cover this model year
Data refreshed
Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.
Check a VIN on NHTSA.govRecall campaigns
2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is
SERVICE BRAKES, AIR:SUPPLY:CHECK VALVE
What a recall is
- Safety recall
- A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
- Safety investigation
- NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
- Manufacturer communication
- Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Safety investigations
NHTSA inquiries naming this vehicle. An investigation is not a finding of a defect, and it is not a recall.
STRICK WHEEL-END FAILURES
THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTED OR CONTINUES TO EXIST.FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE AGENCY WILL CONTINUE TO MONITOR THIS PROBLEM CLOSELY AND RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.SEE ATTACHED TECHNICAL REPORT FOR FULL DETAILS.
STRICK SEMI TRAILER HUB FAILURES
ODI OPENED THIS INVESTIGATION BASED ON A FLEET COMPLAINT WHERE INFORMATION WAS FURNISHED INDICATING THAT WHEEL BEARINGS WERE FAILING AT AN UNUSUALLY HIGH RATE.IN 29 CASES THESE FAILURES ALLEGEDLY RESULTED IN A WHEEL END FIRE OR A WHEEL SEPARATION.DURING THE INVESTIGATION IT WAS DETERMINED THAT THE SUBJECT VEHICLES WERE BUILT WITH LOW MAINTENANCE WHEEL ENDS.DOCUMENTS OBTAINED BY ODI INDICATE THAT WIDESPREAD CONFUSION EXISTED IN THIS INDUSTRY CONCERNING MAINTENANCE REQUIREMENTS.THE ISSUES WERE:FREQUENCY OF MAINTENANCE, AMOUNT OF GREASE TO BE USED, AND PROPER METHOD OF INSPECTION.SEVERAL MEETINGS WERE HELD INVOLVING THE AXLE MANUFACTURER, (ARVINMERITOR), LUBRICATION MANUFACTURER (MOBIL), SEVERAL TRAILER MANUFACTURERS AND FLEETS.CURRENTLY ODI HAS DATA WHICH INDICATES THAT 255 TRAILERS FROM A CERTAIN BUILD PERIOD HAVE WHEEL ENDS FAILING AT A HIGHER RATE THAN PEER TRAILERS WITH THE SAME WHEEL ENDS.ODI IS UPGRADING THIS INVESTIGATION TO DETERMINE WHY THE ONE GROUP IS FAILING AT A HIGHER RATE THAN OTHERS WITH THE SAME WHEEL ENDS.IN ORDER TO RESOLVE THIS MATTER, ODI WILL BE CONTACTING THE AXLE MANUFACTURER, THE BEARING AND GREASE MANUFACTURERS, FLEETS AND WILL FURTHER INVESTIGATE THE ISSUE WITH STRICK DIRECTLY.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — recall campaigns and safety investigations
Data on this page last refreshed .