2006 Suzuki SV1000S Problems
Owner-reported complaints filed with NHTSA, grouped by component
Data refreshed
What this page shows
Everything below is an owner-reported complaint submitted to NHTSA about the 2006 Suzuki SV1000S, grouped by the component NHTSA recorded on the report. These are not confirmed defects, and they are not recalls. NHTSA does not verify most reports before publishing them, and a category with more reports in it is not evidence that a part is defective.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Reports by component
Ranked by how many owner reports name each component category
- Engine360.0%
- Electrical120.0%
- Transmission120.0%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Each component in detail
What the reports in each category say, in the owners' own words
Engine
Reports naming the engine itself — including stalling, misfires, oil consumption, cooling and internal engine components.
From owner reports, verbatim
MOTORCYCLE STARTED TO VIBRATE MORE AT HANDLE BARS AND BECAME UNCOMFORTABLE TO RIDE. ELECTRICAL OUTPUT FROM THE MAGNETO WAS ALSO STARTING TO DROP IN DC OUTPUT. SELF INVESTIGATION INTO ISSUE REVEALED THAT THE INTERNAL MAGNETO ROTOR THAT NORMALLY HAS 6 MAGNETS EPOXIED TO IT, NOW ONLY HAD 5 EPOXIED IN THE CORRECT PLACE. THE OTHER 1 HAD BROKEN THE BOND AND WERE SLIDING AROUND CAUSING DAMAGE AND WERE ALL BUNCHED UP CAUSING THE VIBRATION ISSUE ALONG WITH THE LOW VOLTAGE OUTPUT TO THE ELECTRICAL SYSTEM. ENGINE WAS CLEANED OUT, AND PART REPLACED WITH NEW SUZUKI OEM PART. *TR
LOUD ABNORMAL KNOCKING SOUND COMING FROM ENGINE WITH CLUTCH LEVER RELEASED. SAME SOUND NEARLY INAUDIBLE WITH CLUTCH LEVER PULLED IN. PRIMARY DRIVE NUT ON CRANKSHAFT THAT SECURES PRIMARY DRIVE GEAR ASSEMBLY LOOSENED AND PARTIALLY UNTHREADED. NUT THEN MAKES WITH CONTACT WITH THE INNER RIGHT HAND ENGINE CASE AND RUBS. THE PRIMARY DRIVE GEAR IS THEN ALLOWED TO SLIDE ON THE CRANKSHAFT OUTWARDS TOWARDS THE CLUTCH ASSEMBLY AND MAKES CONTACT, THE PRIMARY DRIVE GEAR SPRING WASHER IS THEN BROKEN ALLOWING THE PRIMARY DRIVE GEAR ASSEMBLY TO SEPERATE AND LET THE INTERNAL SPRINGS FALL OUT. VARIOUS PIECES OF METAL FRAGMENTS CAN FALL INTO THE OIL SUMP. POSSIBILITY OF CLUTCH DRIVEN GEAR DAMAGE AS WELL AS CAMSHAFT DRIVE GEAR DAMAGE OR ENGINE FAILURE IF LEFT UNCHECKED. PRIMARY DRIVE GEAR SPRINGS AND SPRING WASHERS REPLACED. PRIMARY DRIVE GEAR ASSEMBLY NUT TORQUED TO SPECIFICATION. REMOVE BROKEN PARTS FROM OIL SUMP IF PRESENT. REPLACE CRANKCASE COVER GASKET, ENGINE OIL, AND COOLANT.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Electrical
Reports naming the electrical system — wiring, battery, charging, control modules, infotainment and electrical accessories.
From owner reports, verbatim
MOTORCYCLE STARTED TO VIBRATE MORE AT HANDLE BARS AND BECAME UNCOMFORTABLE TO RIDE. ELECTRICAL OUTPUT FROM THE MAGNETO WAS ALSO STARTING TO DROP IN DC OUTPUT. SELF INVESTIGATION INTO ISSUE REVEALED THAT THE INTERNAL MAGNETO ROTOR THAT NORMALLY HAS 6 MAGNETS EPOXIED TO IT, NOW ONLY HAD 5 EPOXIED IN THE CORRECT PLACE. THE OTHER 1 HAD BROKEN THE BOND AND WERE SLIDING AROUND CAUSING DAMAGE AND WERE ALL BUNCHED UP CAUSING THE VIBRATION ISSUE ALONG WITH THE LOW VOLTAGE OUTPUT TO THE ELECTRICAL SYSTEM. ENGINE WAS CLEANED OUT, AND PART REPLACED WITH NEW SUZUKI OEM PART. *TR
Too few reports in this category for a page of its own — they appear in the full complaint list.
Transmission
Reports naming the automatic or manual transmission, including shifting behaviour, shudder, slipping and transmission control modules.
From owner reports, verbatim
LOUD ABNORMAL KNOCKING SOUND COMING FROM ENGINE WITH CLUTCH LEVER RELEASED. SAME SOUND NEARLY INAUDIBLE WITH CLUTCH LEVER PULLED IN. PRIMARY DRIVE NUT ON CRANKSHAFT THAT SECURES PRIMARY DRIVE GEAR ASSEMBLY LOOSENED AND PARTIALLY UNTHREADED. NUT THEN MAKES WITH CONTACT WITH THE INNER RIGHT HAND ENGINE CASE AND RUBS. THE PRIMARY DRIVE GEAR IS THEN ALLOWED TO SLIDE ON THE CRANKSHAFT OUTWARDS TOWARDS THE CLUTCH ASSEMBLY AND MAKES CONTACT, THE PRIMARY DRIVE GEAR SPRING WASHER IS THEN BROKEN ALLOWING THE PRIMARY DRIVE GEAR ASSEMBLY TO SEPERATE AND LET THE INTERNAL SPRINGS FALL OUT. VARIOUS PIECES OF METAL FRAGMENTS CAN FALL INTO THE OIL SUMP. POSSIBILITY OF CLUTCH DRIVEN GEAR DAMAGE AS WELL AS CAMSHAFT DRIVE GEAR DAMAGE OR ENGINE FAILURE IF LEFT UNCHECKED. PRIMARY DRIVE GEAR SPRINGS AND SPRING WASHERS REPLACED. PRIMARY DRIVE GEAR ASSEMBLY NUT TORQUED TO SPECIFICATION. REMOVE BROKEN PARTS FROM OIL SUMP IF PRESENT. REPLACE CRANKCASE COVER GASKET, ENGINE OIL, AND COOLANT.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — owner-reported complaints and the components recorded on them
Data on this page last refreshed .