RoadVitals

2015 Terex Advance Front Discharge Concrete Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
2
Newest Jul 2, 2015
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

2 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

15V423000

EQUIPMENT

Jul 2, 2015
120 units potentially affected
The defect: Terex Advance (Terex) is recalling certain model year 2015 Front Discharge Concrete Mixer Trucks manufactured April 1, 2015, to June 23, 2015. In the affected trucks, the bolts that secure the concrete mixing drum to the drum drive plate may not have been properly tightened.
The risk: If the bolts are not properly tightened, the drum may separate from the vehicle, increasing the risk of injury or a crash.
The remedy: Terex will notify owners, and dealers will install new bolts using a thread locker, after removing the paint from under the fasteners. These repairs will be done free of charge. The recall began on Sptember 23, 2015. Owners may contact Terex customer service at 1-800-433-6691.
Terex AdvanceView on NHTSA.gov
14V793000

SUSPENSION:FRONT:SPRINGS:LEAF SPRING ASSEMBLY

Dec 16, 2014
553 units potentially affected
The defect: Terex Advance (Terex) is recalling certain model year 2013-2015 Front Discharge Concrete Mixer Trucks manufactured August 20, 2012, to December 5, 2014. Due to improperly secured castellated retaining nuts on the front axle leaf spring rear pin and the steering system, the rear end of the front axle leaf spring may partially disconnect from the front suspension hanger.
The risk: If the front axle spring becomes partially disconnected from the front suspension hanger, steering difficulty may result, increasing the risk of a crash.
The remedy: Terex will notify owners, and dealers will inspect and correct the retaining nut installation, as necessary, free of charge. The recall began on May 15, 2015. Owners may contact Terex customer service at 1-800-433-6691.
Terex AdvanceView on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources