RoadVitals

2015 Terex Advance Mixer FD4000

Recalls, owner-reported complaints, investigations and safety data

Owner complaintsComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
0
Safety recallsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
1
Latest May 26, 2016
InvestigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0

Overview

Our database contains no NHTSA owner-reported complaints for the 2015 Terex Advance Mixer FD4000. 1 safety recall has been issued covering this model year.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Safety recalls

1 campaign cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
16V371000

POWER TRAIN:AXLE ASSEMBLY

May 26, 2016
117 units potentially affected
The defect: Terex Advance (Terex) is recalling certain model year 2015-2016 Mixer FD3000, FD4000, and FD6000B vehicles manufactured August 1, 2014, to September 30, 2015, and equipped with drive axles manufactured by Marmon-Herrington. The affected axles may have hex nuts on the flange yoke that may not have been properly tightened.
The risk: If the hex nuts are not tightened to specification, the driveshaft may disconnect from the drive axle, resulting in a loss of propulsion and increasing the risk of a crash.
The remedy: Terex will notify owners and provide instructions to properly torque the bolts. The recall began on July 15, 2016. Owners may contact Terex customer service at 1-800-433-6691.
Terex AdvanceView on NHTSA.gov

Recent owner complaints

Reports submitted to NHTSA, shown in the owner's own words

No owner complaints recorded for this model year

Either none have been filed with NHTSA, or this vehicle is too new for reports to have accumulated.

Compare model years

Complaint and recall counts across every year of this model

Terex Advance Mixer FD4000 by model year
YearComplaintsRecallsInvestigationsIssue Index
2016010—
2015Viewing010—

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.