RoadVitals

2012 Winnebago Era Recalls

Safety recall campaigns filed with NHTSA that cover this model year

Recalls apply to specific vehicles, not to every vehicle of a model year. Check your VIN with NHTSA or your manufacturer's dealer to confirm whether a recall affects your vehicle.

Check a VIN on NHTSA.gov
Recall campaignsA safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
8
Newest Oct 27, 2020
Carrying an NHTSA advisoryCampaigns where NHTSA told owners not to drive the vehicle, or to park it outside, until the repair is done.
0
Open investigationsNHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
0

Recall campaigns

8 campaigns cover this model year — what the defect is, what it could cause, and what the remedy is

SEAT BELTS; SEAT BELTS:FRONT:ANCHORAGE

Oct 27, 2020
1,806 units potentially affected
The defect: Winnebago Industries, Inc (Winnebago) is recalling certain 2012-2021 Era 170X vehicles. The weld nut was installed on the wrong side of the bracket where the shoulder belt attaches, reducing the retention strength of the seat belt.
The risk: In the event of a crash, the shoulder belt upper anchorage may not provide adequate protection to the passenger, increasing the risk of injury.
The remedy: Winnebago will notify owners, and dealers will coordinate the inspection of affected units and the installation of a serrated flange nut in the intended weld nut location, free of charge. The recall is expected to begin December 21, 2020. Owners may contact Winnebago Customer Care at 1-800-537-1885.
Winnebago Industries, IncView on NHTSA.gov

EQUIPMENT

Jan 17, 2019
3,351 units potentially affected
The defect: Winnebago Industries, Inc. (Winnebago) is recalling certain 2012-2018 Winnebago ERA motorhomes. The overhead cabinet shelf may have been improperly attached, allowing the cabinet face to detach and fall into the cab area.
The risk: If the cabinet shelf detaches, contents from the cabinet may hit and/or distract the driver, increasing the risk of injury or a crash.
The remedy: Winnebago will notify owners, and dealers will install two support brackets, additional screws, and a maximum capacity warning label, free of charge. The recall began February 27, 2019. Owners may contact Winnebago customer service at 1-641-585-6939 or 1-800-537-1885.
Winnebago Industries, IncView on NHTSA.gov

EQUIPMENT:RECREATIONAL VEHICLE/TRAILER:LPG SYSTEMS:LINES AND FITTINGS

Aug 15, 2018
1,654 units potentially affected
The defect: Winnebago Industries, Inc. (Winnebago) 2012-2013 Winnebago Era, View, and Via motorhomes and Itasca Navion and Reyo motorhomes. The high pressure liquid propane hoses may harden at the crimp fitting, possibly resulting in a propane leak.
The risk: A propane leak in the presence of an ignition source can increase the risk of a fire.
The remedy: Winnebago will notify owners, and dealers will inspect the propane hose, replacing it as necessary, free of charge. The recall began September 17, 2018. Owners may contact Winnebago customer service at 1-641-585-6939 or 1-800-537-1885. Winnebago's number for this recall is 151.
Winnebago Industries, IncManufacturer number 151View on NHTSA.gov

EQUIPMENT:OTHER:LABELS

Aug 5, 2015
1,732 units potentially affected
The defect: Winnebago Industries, Inc. (Winnebago) is recalling certain model year 2012-2016 Winnebago Era recreational vehicles manufactured November 11, 2010, to July 20, 2015. The certification label affixed to the vehicles provide an incorrect front tire inflation pressure. Accordingly, these vehicles fail to comply with the requirements of 49 CFR Part 567, "Certification."
The risk: Incorrect tire pressure information could cause an owner or operator to under or over inflate the tires, increasing the risk of a tire failure and a crash.
The remedy: Winnebago will notify owners, and dealers will provide new certification labels with the correct tire inflation pressure specifications, free of charge. The recall began on September 18, 2015. Owners may contact Winnebago customer service at 1-641-585-3535.
Winnebago Industries, IncManufacturer number 133View on NHTSA.gov

ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS

Dec 3, 2012
2,495 units potentially affected
The defect: Winnebago is recalling certain model year 2009-2013 model Era motorhomes, 2010-2013 Via and Itasca Reyo motorhomes, and 2011-2013 View and Itasca Navion motorhomes; manufactured November 13, 2007, through August 20, 2012. The proper fuses were not installed for the refrigerator circuits.
The risk: Without the proper fuse, heat can build which could lead to a vehicle fire.
The remedy: Winnebago will notify owners, and dealers will replace the fuses. The recall began on December 21, 2012. Consumers may contact Winnebago Industries owner relations at 1-641-585-6939.
WINNEBAGO INDUSTRIES INC.Manufacturer number 127View on NHTSA.gov

EQUIPMENT:RECREATIONAL VEHICLE/TRAILER:LPG SYSTEMS:LINES AND FITTINGS

Aug 8, 2012
165 units potentially affected
The defect: Winnebago is recalling certain model year 2012-2013 Winnebago and Itasca motor homes. A cutting machine may have scored the copper propane tubing resulting in unknown long-term reliability.
The risk: If the copper tubing fails, propane can escape leading to a fire or explosion which can result in property damage, personal injury, or death.
The remedy: Winnebago will notify owners, and dealers will replace the copper tubing, free of charge. The recall began on September 6, 2012. Owners may contact Winnebago Industries Owner Relations at 1-641-585-6939.
WINNEBAGO INDUSTRIES INC.Manufacturer number 126View on NHTSA.gov

SUSPENSION:REAR:SPRINGS

Nov 10, 2011
3 units potentially affected
The defect: WINNEBAGO IS RECALLING CERTAIN MODEL YEAR 2012 ERA MOTOR HOMES, MANUFACTURED FROM JULY 25, 2011, THROUGH AUGUST 4, 2011AND BUILT ON SPRINTER/DAIMLER CHASSIS. THE SUPPLIER OF THE REAR SPRINGS ROLLED THE SPRING EYE DIAMETER OUT OF TOLERANCE DURING PRODUCTION, AND THEN CORRECTED THE DIAMETER WITHOUT HEATING THE PARTS. THIS COULD POTENTIALLY LEAD TO A CRACK OF THE SPRING EYE OVER TIME.
The risk: IF A SPRING EYE WERE TO CRACK, THE REAR SPRING COULD COLLAPSE, SUDDENLY UPSETTING THE VEHICLES HANDLING, WHICH COULD INCREASE THE RISK OF A CRASH.
The remedy: WINNEBAGO IS WORKING WITH SPRINTER/DAIMLER TO NOTIFY OWNERS. SPRINTER/DAIMLER IS HANDLING THE REMEDY FOR THIS CAMPAIGN, PLEASE SEE 11V-323. SPRINTER/DAIMLER DEALERS WILL REPLACE THE REAR SPRINGS AS NECESSARY FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 30, 2011. OWNERS MAY CONTACT SPRINTER AT 1-877-762-8267.
WINNEBAGO INDUSTRIES INC.View on NHTSA.gov

EQUIPMENT:OTHER:LABELS

Aug 3, 2011
51 units potentially affected
The defect: WINNEBAGO IS RECALLING CERTAIN MODEL YEAR 2012 ERA MOTOR HOMES MANUFACTURED FROM NOVEMBER 11, 2010, THROUGH JULY 13, 2011, FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS." THESE VEHICLES ARE EQUIPPED WITH THE WRONG VEHICLE WEIGHT LABEL.
The risk: NONCOMPLIANCE ISSUE - WEIGHT INFORMATION ON THE WRONG FORMAT LABEL.
The remedy: OWNERS WILL BE PROVIDED WITH NEW LABELS AND INSTALLATION INSTRUCTIONS. AT THE CUSTOMER'S OPTION, A DEALER CAN PERFORM THE INSTALLATION FOR THEM. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 19, 2011. OWNERS MAY CONTACT WINNEBAGO AT 1-641-585-6939.
WINNEBAGO INDUSTRIES, INC.Manufacturer number 123View on NHTSA.gov

What a recall is

Safety recall
A safety recall is issued when a manufacturer or NHTSA determines that a vehicle has a safety-related defect or does not comply with a federal motor vehicle safety standard. Recall repairs are free. Whether a specific vehicle is covered depends on its VIN — a recall listed for a model year does not necessarily apply to every vehicle of that year.
Safety investigation
NHTSA opens an investigation to examine whether a safety defect may exist. An open investigation is not a determination that a defect exists, and many investigations close without a recall. Investigations can, however, lead to one.
Manufacturer communication
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.

Elsewhere on this vehicle

Data sources