RoadVitals

2018 Winnebago Minnie Winnie Owner Complaints

Reports submitted to NHTSA by owners and drivers, shown in full

Data refreshed

Complaints on fileComplaints are reports submitted to NHTSA by owners and drivers. NHTSA does not verify most reports before publishing them, and a complaint does not establish that a defect exists. Volume is influenced by how many of a vehicle were sold, how long it has been on the road, and how much attention an issue has received.
4
Latest Sep 10, 2022
Crash or fire reportedComplaints whose submitter recorded that a crash or a fire occurred. These are the reporter's own answers on the NHTSA form, not verified findings.
0
Filed in the last 12 monthsReports filed with NHTSA in the trailing 365 days. Recent volume reflects attention and vehicle age as much as anything else.
0
Reports on file since Apr 23, 2018

What this page shows

Our database holds 4 NHTSA owner-reported complaints for the 2018 Winnebago Minnie Winnie. Each one is a report filed by an owner or driver and published by NHTSA without most of them being verified. A complaint is not a confirmed defect, not a recall and not a manufacturer bulletin. Narratives are shown exactly as filed.

Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.

Complaints, most recent first

Showing 1–4 of 4

Body & structure
Filed Sep 10, 2022

Component is the RV door latch manufactured by TriMark model no. t507. The failure of this lock was that when inside the vehicle the plunger does not fully retract allowing the door to open. If you go on YouTube and search TriMark RV lock repair you will see the multiple failures of not being able to enter/exit the vehicle. In case of a vehicle fire I would not have the physical ability to find a exit. When I removed the interior of the lock there was a small broken piece of plastic. I assume this piece aided in retracting the plunger allowing the door to be open. I am greatly concerned (scared) at what harm this door latch failure could cause. I believe these latches are installed on the majority of RV’s. Please do something to get these from being installed. Thank You [XXX] INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).

NHTSA ID
11483828
Incident
Sep 8, 2022
Filed Mar 8, 2021

BOTH SIDES OF MY TRAVEL TRAILER FRAME HAS DEVELOPED CRACKS WHERE A BOLT GOES THROUGH TO CONNECT A FRAME CROSS MEMBER FROM THE LEFT SIDE OF THE FRAME TO THE RIGHT SIDE OF THE FRAME NEAR THE AXLES. THE FRAME IS AN NXG MADE BY BAL/NORCO INDUSTRIES. THE CRACKS DEVELOPED OVER THE LAST 2.5 YEARS. THE TRAILER HAS LESS THAN 15,000 MILES ON IT.

NHTSA ID
11399759
Incident
Mar 8, 2021
Mileage
15,000 mi
Filed Apr 29, 2020

THE FRAME ON BOTH SIDES OF MY TRAVEL TRAILER HAS CRACKS WHERE A BOLT GOES THROUGH TO CONNECT A FRAME CROSS MEMBER FROM THE LEFT SIDE OF THE FRAME TO THE RIGHT SIDE OF THE FRAME NEAR THE AXLES. THE FRAME IS AN NXG MADE BY BAL/NORCO INDUSTRIES. THE CRACKS DEVELOPED SOMETIME OVER THE LAST 2 YEARS. THE TRAILER HAS LESS THAN 20,000 MILES ON IT.*DT*JB*DT*JB

NHTSA ID
11322710
Incident
Apr 24, 2020
Mileage
20,000 mi
Body & structure
Filed Apr 23, 2018

****NOTE - NEED MORE INFORMATION, REQUESTED THE VIN ON 4/24/2018**** BED FRAME SUPPORT FAILURE. FLIMSY CONSTRUCTION ALLOWED BED FRAME WOODEN MEMBERS TO CRACK AND CAUSE SUPPORT FAILURE. BED MATTRESS WAS BEGINNING TO CAVE THRU INTO LOWER CARGO BAY. I HAD TO REBUILD AND STRENGTHEN THE ENTIRE DESIGN FOR IT TO BE SAFE. OTHER OWNERS ARE REPORTING THE SAME PROBLEMS. THIS TRAILER WAS NEVER USED, AND THUS HAPPENED WHILE MAKING UP THE BED WITH SHEETS AND BLANKETS WHILE ON TOP OF THE MATTRESS. *TT *TR

NHTSA ID
11089548
Incident
Apr 21, 2018
Mileage
70 mi

Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.

Data sources

Data on this page last refreshed .