2013 Winnebago Sightseer Problems
Owner-reported complaints filed with NHTSA, grouped by component
Data refreshed
What this page shows
Everything below is an owner-reported complaint submitted to NHTSA about the 2013 Winnebago Sightseer, grouped by the component NHTSA recorded on the report. These are not confirmed defects, and they are not recalls. NHTSA does not verify most reports before publishing them, and a category with more reports in it is not evidence that a part is defective.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
Reports by component
Ranked by how many owner reports name each component category
- Body & structure150.0%
- Seat belts150.0%
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
Each component in detail
What the reports in each category say, in the owners' own words
Body & structure
Reports naming the vehicle structure, frame, body panels, doors, hood and trim.
From owner reports, verbatim
the hood bracket glue failed and the hood bracket was detached. The vehicle was unsafe to drive but need to be moved from a gas station. More damage was done during the move. We have not had a dealer or inspector looking at the vehicle. There were no warning messages of the problem failure. This failure has been reported on other Winnebago Sightseers on other websites. There is a recall for the year 2014-2023 but not for the 2013 Winnebago as yet.
Too few reports in this category for a page of its own — they appear in the full complaint list.
Seat belts
Reports naming seat belts, buckles, retractors and pretensioners.
From owner reports, verbatim
WHILE DRIVING ON THE HIGHWAY THROUGH AN ARIZONA TOWN AT 35 MPH THE LIGHT TURNED TO RED JUST WITHIN BREAKING DISTANCE. IN ORDER TO COME TO A STOP IN FRONT OF THE STOP LINE, I HAD TO BRAKE HARDER THAN USUAL. THIS CAUSED THE PASSENGER TO BE SLAMMED INTO THE SAFETY BELT AND INJURED. THE SAFETY BELT CAUSED SEVERE PRESSURE ON THROAT AND WIND PIPE. THE PASSENGER WAS 5 FOOT 3 INCHES. REASON FOR INCIDENT: THE UPPER FIXATION POINTS OF THE SAFETY BELTS IN THE WINNEBAGO SIGHTSEERS ARE VERY HIGH. FOR SHORTER PEOPLE THE SAFETY BELT WILL RUN ACROSS THE THROAT AND WINDPIPE OF THE DRIVER AND PASSENGER, RESPECTIVELY. HEIGHT ADJUSTMENTS ARE NOT POSSIBLE. REQUEST FOR HEIGHT ADJUSTABLE SAFETY BELT FIXATIONS AT AN AUTHORIZED SERVICE SHOP HAS BEEN DECLINED. REASON FOR DECLINE WAS THAT THIS WAS A WINNEBAGO DESIGN THAT MUST NOT BE ALTERED AND WINNEBAGO DOES NOT OFFER ANY SOLUTION. SERVICE MANAGER STATED THAT MANY REQUESTS HAD ALREADY COME FROM OTHER SIGHTSEER OWNERS BUT ALL REQUESTS HAD BEEN DECLINED BY WINNEBAGO. POSSIBLE CONSEQUENCES FOR SHORT DRIVER AND PASSENGERS: DURING A REAL EMERGENCY BREAKING SITUATION OR CRASH THE SHORT DRIVER/PASSENGER WILL BE BADLY SLAMMED INTO THE SAFETY BELT. IF THE SAFETY BELT RUNS ACROSS THE THROAT AND WINDPIPE SEVERE INJURIES MAY RESULT. IN VERY BAD CASES THE IMPROPER ROUTING OF THE SAFETY BELT MAY RESULT IN SUFFOCATION AND/OR SNAPPING THE NECK, THUS CAUSING FATALITIES. *TR
Too few reports in this category for a page of its own — they appear in the full complaint list.
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers.
Elsewhere on this vehicle
Data sources
- NHTSA Office of Defects Investigation — owner-reported complaints and the components recorded on them
Data on this page last refreshed .