Recalls, owner-reported complaints, investigations and safety data
Data refreshed
Our database contains 9 NHTSA owner-reported complaints for the 2006 Yamaha FZ1, most frequently naming the body & structure, electrical and engine categories. 1 manufacturer communication is on file.
Complaints are reports submitted by owners and drivers to NHTSA. They are not verified and do not establish that a defect exists.
When owners filed reports about this model year
| Month | Complaints filed | Cumulative |
|---|---|---|
| Jul 2012 | 1 | 1 |
| Oct 2014 | 1 | 2 |
| Dec 2014 | 1 | 3 |
| Feb 2016 | 1 | 4 |
| Mar 2016 | 1 | 5 |
| Jun 2017 | 1 | 6 |
| Dec 2018 | 1 | 7 |
| May 2020 | 1 | 8 |
| Sep 2023 | 1 | 9 |
Complaints grouped by the component NHTSA recorded
Percentages are of component mentions. A single complaint can name more than one component, so these do not sum to the total complaint count.
No recalls in our database for this model year
That does not guarantee a specific vehicle is unaffected — recalls are issued against VINs, and new campaigns are announced regularly. Check a VIN on NHTSA.gov.
Reports submitted to NHTSA, shown in the owner's own words
The weld that holds the different sections of the frame of the motorcycle has a crack. The weld from the manufacture is defective. The crack is in parallel and in the middle of the weld. It is clearly visible on both sides of the bike just below the gas tank. The crack can cause the bike to fall apart during riding putting the rider and nearby traffic in mortal danger.
DUE TO MANUFACTURER DESIGN THE MAGNETS ON THE STATOR FLY WHEEL BECAME COMPROMISED. THE RESULT IS A FAILED CHARGING SYSTEM. POSSIBLE INTERNAL MOTOR DAMAGE AS WELL. I WAS ON THE FREEWAY WHEN I SMELLED THE COMPONENTS BURNING UP AND MY SEAT BECAME VERY HOT. *TR
WHILE TURNING LEFT THROUGH A CITY INTERSECTION THE ENGINE DIED FORCING ME TO PUSH MOTORCYCLE THROUGH REMAINDER OF TURN TO AVOID A COLLISION WITH APPROACHING TRAFFIC. ALTHOUGH THE MILEAGE/TIME ON MY PARTICULAR VEHICLE IS OUT OF FACTORY WARRANTY, A SMALL AMOUNT OF RESEARCH SHOWS THIS TO BE A COMMON ISSUE WITH YAMAHA FZ1, FZ8, & 2004-2006 YAMAHA R1 (SAME ENGINE CONFIGURATION). ALSO THE MANUFACTURER HAS RELEASED A REDESIGNED COMPONENT TO ADDRESS THIS SITUATION.
TL* THE CONTACT OWNS A 2006 YAMAHA FZ1. WHILE DRIVING 40 MPH, THE MOTORCYCLE FELT UNSTABLE. THE CONTACT PULLED OVER AND NOTICED THAT THE FRAME OF THE MOTORCYCLE HAD FOLDED AND SUBSEQUENTLY COLLAPSED. THE CONTACT SAW THAT THE FRAME HAD FAILED AND FRACTURED IN HALF. THE MOTORCYCLE WAS NOT TAKEN TO A DEALER OR MECHANIC. THE DEALER WAS NOT CONTACTED. THE MOTORCYCLE WAS NOT REPAIRED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE AND WAS DECIDING ON A COURSE OF ACTION. THE APPROXIMATE FAILURE MILEAGE WAS 18,000.
FRAME CRACKED ALONG FACTORY WELD ON THE RIGHT SIDE INSIDE/OUTSIDE VERTICAL AND LOWER HORIZONTAL. THE MOTORCYCLE HAS NEVER BEEN DROPPED OR CRASHED AND PASSED MARYLAND STATE SAFETY INSPECTION YESTERDAY. WHEN WASHING THE BIKE TODAY, I NOTICED A LINEAR CRACK THAT RAN VERTICALLY ALONG THE WELD ON THE RIGHT SIDE OF THE FRAME BELOW THE TANK. NO WRECKS, EXCESSIVE STRESS OR TEMPERATURE CHANGE PRECEDED CRACK. THE BIKE HAD ONLY MADE A 3 MILE TRIP FROM THE INSPECTION STATION TO MY HOME WHEN I NOTICED THE CRACK. THIS IS CLEARLY A MANUFACTURING DEFECT AND IT IS AN OUTRAGE THAT THESE FRAMES WEREN'T RECALLED FOR SAFETY.
ROTOR ASSEMBLY MAGNETS CAME UNGLUED WHILE RIDING AND RUIN ENGINE FORCING THE MOTORCYCLE TO STOP RUNNING AT HIGH SPEED.
MY SON AND MYSELF WENT FOR A SHORT RIDE IN THE WARM OF THE DAY AFTER ATTENDING CHURCH. AFTER RIDING ABOUT AN HOUR WE STOPPED AT A FRIENDS HOUSE WHERE THE FRIEND CAME OUT TO CHECK OUT MY BIKE.WE THEN NOTICED THE CRACK ON THE RIGHT SIDE OF THE FRAME JUST ABOVE THE ENGINE.THE CRACK GOES ALL THE WAY DOWN THE WELD LINE OF THE FRAME AND UNDER THE BOTTOM OF THE FRAME IN THE WELD LINE,COULD BE ON THE BACK SIDE OF THE FRAME ALSO,BUT THE BIKE WOULD NEED TO BE DISASSEMBLED TO INSPECT ANY FURTHER. *TR
MOTORCYCLE RIGHT SIDE FRAME WELD ABOVE CLUTCH ENGINE COVER WAS FOUND WITH A CRACK. THE CRACK IN THE WELD APPEARS TO RUN ALONG THE OUTSIDE OF THE FRAME AND CONTINUOUSLY UNDER THE FRAME AND BACK UP THE INSIDE OF THE FRAME. THE MOTORCYCLE HAS NEVER BEEN INVOLVED IN A CRASH. THE FRAME WELD HAS JUST FAILED. *TR
A bulletin sent by a manufacturer to its dealers. Not a recall, and repairs are not necessarily free.
EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL
YAMAHA MC: WHEN LOOKING FOR TECHNICAL INFORMATION, A COMPREHENSIVE INDEX IS PROVIDED REGARDING TECHNICAL SOLUTIONS FOR VARIOUS PROBLEMS. *PE
Manufacturers file copies of the bulletins they send to dealers with NHTSA. These often describe diagnostic or repair procedures for a known condition. They are not recalls: repairs described in a bulletin are usually only free if the vehicle is still under warranty or the manufacturer has extended coverage.
Complaint and recall counts across every year of this model
| Year | Complaints | Recalls | Investigations | Issue Index |
|---|---|---|---|---|
| 2007 | 9 | 0 | 0 | — |
| 2006Viewing | 9 | 0 | 0 | — |
Higher-selling and older vehicles accumulate more reports. Counts are not failure rates and are not directly comparable between vehicles that sold in very different numbers. Older model years have had longer for reports to accumulate.