2014 Acura MDX

Recall/Campaign Reference: Rear subframe/rear suspension safety recall, ~880,000+ Acura MDX vehicles (MY 2014–2020), due to risk of rear suspension component failure causing loss of vehicle control. Complaint Narrative: I own a 2014 Acura MDX (VIN [XXX]) subject to Honda's rear subframe safety recall for suspension components Honda has identified as posing a risk of failure, potentially causing loss of vehicle control and increasing crash/injury risk. I brought my vehicle to Acura of Arrowhead, AZ (authorized dealer) for the recall repair. The dealer had recall subframe parts in stock, but upon inspection found the bolt securing the Left Rear Lower Arm A rusted and seized, causing the bushing to separate. The dealer advised the bolt must be cut and the Left Rear Lower Arm A (Part No. 52370TZ5A90) replaced, along with the right-side arm (52375TZ5A9) and Upper/Lower Bolts (90118TZ5A10, 90981TZ5A01). I was informed Part No. 52370TZ5A90 is unavailable anywhere in the U.S. — no dealer, no aftermarket, no third-party source — for an indefinite period with no ETA. As a result, the recall repair cannot be completed, despite an actively corroded, failing component already identified on my vehicle. I must continue operating this vehicle with a known, documented safety defect because Honda cannot supply the needed part, with no resolution timeline. This complaint documents: Recall remedy cannot be completed due to nationwide parts unavailability. Vehicle has an active rusted/seized failure in the exact recalled component. No interim safety guidance or parts timeline provided. I request NHTSA investigate Honda's parts supply chain adequacy for this recall, given the scale (880,000+ vehicles) and inability to supply a critical safety part. Requested Action: Investigate parts availability/remedy completion rate for this campaign; require American Honda Motor Co., Inc. to provide owners a documented parts timeline and/or interim safety guidance. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5

NHTSA ID

11753247

Incident

Jul 18, 2026

I discovered my back taillight is foggy and the lights are not seen. Capital City Honda provided an estimate: driver side taillight assembly replacement. Foggy taillight assembly affecting brightness and visibility. Cost $639.99 I then discovered there is a recall for moisture getting into the taillight causing this problem. Honda said my VIN is not included, but suggested I take it back to Capital City Honda to write a diagnosis, which I did and which is attached. Honda advised me today that since my VIN is not included, there is nothing they will do. I just spent about $3,000 for a tune up and new brakes so another $639 is just too much, especially since this is an issue caused by the manufacturer. I am trying to understand why my car isn't covered, when it has this issue. I've attached my email to Honda, the diagnosis and the recall.

NHTSA ID

11746038

Incident

Mar 1, 2026

OnXXX I was sold an “As is” vehicle under a Christmas special that was deemed unsafe to drive by a licensed mechanic a week later because of the rear subframe is bent from premature corrosion the dealer denied knowing anything about it but i submitted a case with FLHSMV because under the Florida Deceptive and Unfair Trade Practices Act (FDUTPA): For consumer sales, even in "as-is" transactions, sellers must disclose known material defects that substantially impact the vehicle’s value or safety but the claim was denied and ruled non-jurisdictional so im in the process of going civil. The total price the licensed mechanic gave me was 3,246 so ive been trying to mitigate this for months but i recently just seen a Major recall was just issued which is the NHTSA campaign #26V367000 which is the same exact problem my vehicle that was sold to me was & is currently experiencing but my state which is [XXX] was excluded from the Recall list because it isn’t classified as a Salt bath state but since im experiencing the same issue and i don’t live in one of those states im just making this formal complaint to see if i can get some help to mitigate this situation to get the recall extended to more states since its not just affecting the north united states its down south as well so if someone could please help me or get back to me to point me in the right direction to get this situation mitigated it’ll be greatly appreciated thank you and have a great day. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

NHTSA ID

11743848

Incident

Dec 25, 2025

A connecting rod bearing is failing in my 2014 Acura MDX which could have led to complete engine failure while driving my family. Absolute Auto Center of Berlin, CT confirmed the issue and noted that Acura has recalled 2016-2020 MDX models due to connecting rod bearing defects but have not expanded the recall to include earlier model years that are also impacted. There were no warning lamps or messages prior to or during the issue, it was identified due to a loud knocking with the engine around 3-4,000 RPMs.

NHTSA ID

11736130

Incident

May 6, 2026

Car jerked badly on highway when trying to accelerate. It puckered to a stop after a few hours. But started in a few mins and we got home. Mechanic suggested that fuel pressure is low. No repair done. But problem did not surface again for a little bit. Now emissions problem light has come on. This is the third time in 4 months. Once again mechanic suggested low fuel pressure and also pointed to the recall. Writing to request being included

NHTSA ID

11733928

Incident

Apr 25, 2026

This car is consistently garaged. It was pulled out one morning and a large sheet of paint peeled off roof while it was sitting in the driveway. This is a major concern as I don't feel comfortable driving the car for fear more will come off, affecting another driver on the highway. I've had to borrow a car until it can be fixed. Spoke to ACURA and this is a KNOWN issue for this color paint but they will not stand by their product. We have received no information from ACURA regarding this issue as they claim.

NHTSA ID

11714839

Incident

Jan 21, 2026

my daughter drove the vehicle for an appointment. Parked it went in and upon return, started it but could not turn the steering wheel. It was nearly impossible to turn the wheel. When turned with force, it would vibrate. Message popped up stating "Power Steering System (EPS) Problem". I had it towed to my mechanic who identified the problem but wasn't able to obtain the parts due to non-availability. I had the vehicle towed to the dealership (McGrath Acura of Libertyville) where it still remains. It has been there for about two weeks as of Dec. 17, 2025 and still not updates on when the issue would be fixed. I made a phone call complaint to Honda of America three days ago. They left a message today asking me to call back stating a recall (I don't find any EPS recalls while I've found others who have had the same issue. The dealer did quote me a cost of $1247.25 to fix the problem the day after I dropped it with them. Since then absolutely no response. I called Honda of America to follow up on their call but was not able to talk to the person as it went to their voicemail. I left a message and will follow up again tomorrow. I am the original owner of the vehicle and the vehicle has always been serviced on time based on the manufacturer's recommendations with the dealer and an independent mechanic. Thank you.

NHTSA ID

11705732

Incident

Nov 25, 2025

Upon startup the following warning lights come on and remain active: Brake System Problem, Power Steering Problem, Hill Start Assist Problem, Vehicle Stability Assist (VSA) Problem, Anti-Lock Break System Problem. Additionally, intermittingly a loud grinding noise can be heard from the button of the vehicle.

NHTSA ID

11701519

Incident

Dec 7, 2024

Service Bulletin - An uneven sealing surface allows moisture to enter the inner taillight(s), causing one or both of the inner taillights not to work.

Service Bulletin - An uneven sealing surface allows moisture to enter the inner taillight(s), causing one or both of the inner taillights not to work.

Service Bulletin - An uneven sealing surface allows moisture to enter the inner taillight(s), causing one or both of the inner taillights not to work.

Owner Notification Letter - An uneven sealing surface allows moisture to enter the inner taillight(s), causing one or both of the inner taillights not to work.

Owner Notification Letter - An uneven sealing surface allows moisture to enter the inner taillight(s), causing one or both of the inner taillights not to work.

Owner Notification Letter - An uneven sealing surface allows moisture to enter the inner taillight(s), causing one or both of the inner taillights not to work.